草浆造纸中段废水的生物处理动力学

利用静态溶解氧消耗速率（OUR）试验模拟草浆造纸中段废水生物处理的生化反应过程,并运用Lawrence-McCarty模式进行了动力学分析。由OUR试验结果和小试研究结果建立的草浆造纸中段废水好氧生物处理的动力学方程为v=0.72S/(60.43 S）。将该动力学方程预测结果和实际工程的运行数据进行了比较,结果表明,动力学方程的比基质降解速率预测值高于实际工程的计算值,分析原因可能在于：实际工程中中段废水中的纤维素类悬溪物在生物处理装置的积累导致了污泥活性的降低。     

造气含氰废水的生物治理

在塔式生物滤池生产性处理规模上考察了造气含氰废水在挂膜前后的处理效果。比较结果表明，未挂过氰化物的平均处理率仅为７９．２９％，挂膜后的处理率平均为９５．２６％，处理后的废水全部回用于生产，减少了氰化物的排放量，防止了造气废水对环境的污染。     

Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

唐钢一炼钢厂VD精炼炉直接冷却水系统设计

介绍了VD精炼炉直接冷却水处理常用的工艺流程及设计中应重点考虑的问题 ,如水处理单元的选择 ,供水泵与提升泵的匹配问题等     

广东罗浮山生物资源和旅游资源永续利用的探讨

罗浮山是广东四大名山之一,是驰名中外风景秀丽的旅游胜地,也是广东省南亚热带常绿阔叶林及珍稀动植物的综合性自然保护区,有维管植物201科676属1168种,分别占广东维管植物的718%、411%、166%。罗浮山生物资源很丰富,有药用植物和油脂植物等,也有不少国家保护植物和保护动物,而且自秦汉以来就是我国著名的风景区。论文对罗浮山生物资源和旅游资源的永续利用提出了5点建议。     

厌氧—好氧—生物炭系统处理印染废水实例

阐述了采用厌氧水解－好氧生物接触－生物炭吸附氧化工艺处理印染废水的工艺流程、原理、工艺参数及特点。该系统对印染废水ＣＯＤｃｒ及色度的处理取得良好效果，且污泥量少，节省了污泥处理费用。     

Petroleum waste biodegradation with porous biomass support system (PBSS) on rotating biological contactor

A laboratory scale study was conducted to assess the feasibility of the new coupling of rotating biological contactor (RBC) plus porous biomass support system (PBSS) using polyurethane foam as porous support media to biodegrade petroleum refinery wastewater. Polyurethane foam was attached on disks of two four-stage laboratory scale cascade connected RBC units.The two RBC units were operated simultaneously at different but constant, flowrates giving hydraulic loading rates of 0.01, 0.02, 0.03, 0.04 m3/m2/d in two runs keeping the same rotational speed 10 r/min throughout. Organic loading was a less controllable factor in this study.For all of the hydraulic loadings, it was found that the removal efficiency of total chemical oxygen demand (TCOD) and oil were above 80 percent. Ammonia nitrogen and phenol removal were above 90 and 80 percent respectively. The maximum biomass concentration within polyurethane foam was about 30 g/m2 in the first stage for 0.03 m3/m2/d hydraulic loading.The results show that t     

皮革和毛皮加工废水处理技术

采用混凝沉淀-酸化水解-悬挂链曝气-生物接触氧化组合工艺处理皮革和毛皮加工生产废水。实验结果表明;进水COD为2400mg/L,处理后出水COD≤100mg/L,去除率≥95.8%。各项水质指标均稳定地达到了GB8978-96污水综合排放一级标准。     

人工神经元网络对水处理系统建模适应性的研究

针对水处理系统的特点和研究中的难点，引入人工神经元网络的理论和思想，提出了水处理系统的神经网络分析方法．通过建立基于ＢＰ人工神经元网络的臭氧生物活性炭系统的模型，具体地考察了人工神经元网络对水处理系统建模的适应性，使水处理系统的研究迈向智能化和控制化．     

基于TMS320F240 DSP的电网谐波抑制全数字化控制的研究

为治理电力系统谐波污染 ,提高电力系统运行的安全稳定性 ,笔者对混合式并联有源电力滤波系统的结构和工作原理进行了分析和研究。该系统由无源滤波器和小容量有源滤波器串联构成 ,与被补偿的谐波负载并联连接。基于TMS32 0F2 4 0DSP开发套件 ,设计数字控制器主程序和中断服务子程序。实验结果表明 ,采用TMS32 0F2 4 0DSP编程方便并直观 ,运算精度高 ,控制器参数调整方便 ,易于实现各种控制策略。研究成果对DSP在有源电力滤波系统中的应用有重要参考价值。