“二级厌氧-微氧-好氧”组合工艺处理模拟碳纤维生产废水

对模拟碳纤维生产废水进行“厌氧-好氧”静态小试,根据COD的去除效果确定该碳纤维废水的可生化性。采用“二级厌氧-微氧-好氧”组合工艺进行动态中试,考察废水的处理效果及系统的抗冲击性能。试验结果表明：该工艺对碳纤维生产废水的处理效果较好;系统具有厌氧池出水pH增大的特点,且抗冲击能力较强;在厌氧池水温为28~38 ℃、好氧池水温不低于15 ℃、废水流量为100 L/h、进水COD为660 mg/L、进水ρ（氨氮）为4.9 mg/L的条件下,出水COD稳定在50 mg/L以下,ρ（氨氮）稳定在5 mg/L以下,能够满足GB 8978-1996《污水综合排放标准》的要求。     

超滤法处理回用印钞厂擦版液的研究

根据擦版液的特性,选择了适合处理擦版液的单皮层内压式中空纤维超滤膜,对超滤过程中的操作压力、料液温度、料液流速和固含量等工艺参数以及清洗药品和方法进行了研究。结果表明,当进口压力为0.17MPa,膜面流速在2,7m/s左右,循环液温度在40℃左右时,透水速度可达到50—60L(m.h)。操作过程中,只用透过液作简单清洗即可使透水速度得到较好的恢复。只有当透水速度衰减严重时,才在70℃条件下进行化学清洗,而且可以使透水速度得到较为彻底的恢复。化学清洗周期至少在1星期以上。     

载银活性碳纤维对大肠杆菌吸附作用的研究

以大肠杆菌（Ｅｓｃｈｅｒｉｃｈｉａｃｏｌｉ）为对象，通过细菌吸附实验研究了载银活性碳纤维（ＡＣＦ（Ａｇ））对大肠杆菌的吸附特性．借助扫描电子显微镜（ＳＥＭ）进行细菌分布形态的观察和细菌数量的计算．结果表明，大肠杆菌易分布于ＡＣＦ（Ａｇ）表面的沟槽处；ＡＣＦ（Ａｇ）吸附的细菌数量随银含量、比表面积的增加而增大．此外，细菌吸附量还与ＡＣＦ（Ａｇ）表面银颗粒的大小有关．对吸附细菌的动力学亦进行了研究．     

防电磁波辐射的功能性服装

电磁波辐射已成为危害人类健康的第四大污染源，如何进行屏蔽是人们日益关注的问题，本文介绍了防电磁波辐射服装的功能及特点，提出了屏蔽服装今后的发展方向．     

活性炭纤维吸附废水中对硝基苯酚及其脱附研究

采用新型高效吸附剂——活性炭纤维吸附废水中对硝基苯酚，对其吸附和脱附影响因素进行了较详细的研究，确定了最佳工艺参数，并对动态吸附一脱附进行了稳定性实验。在最佳的吸附条件下，装填4g活性炭纤维可处理含对硝基苯酚1000mg/L的废水1400mL，出水对硝基苯酚浓度〈2mg／L，达到国家综合污水一级排放标准，活性炭纤维有效吸附量可达349．87mg／g。在最佳脱附条件下，脱附率〉99％，并可从高浓度脱附液中回收对硝基苯酚。稳定性实验表明，吸附-脱附性能稳定，采用活性炭纤维吸附处理对硝基苯酚废水是一种行之有效的处理方法。     

一种新型国产高效除尘滤筒在船厂分段涂装车间的应用

国产除尘滤材是将聚酯纤维热轧成型 ,再涂敷高分子发泡制成。滤材硬挺、耐压、抗撕裂 ,内部结构稳定 ,粉尘过滤精度高 ,实现表面过滤 ,易清灰再生 ,使用寿命长 ,耐水、酸、碱 ,可广泛用于各工业领域的气体净化和粉尘处理。大连新船重工集团把国产除尘滤材制成的滤筒配置到厂内原有的除尘系统中 ,通过 1年多的使用 ,获得非常满意的除尘效果。从而证明国产滤料性能已达到国际先进水平。     

活性炭纤维的表面结构及其吸附模式

迄今的吸附模式,Henry定律、Langmuir模型、BET模型、D-R方程、D-A方程都分别适用于不同的表面结构,对于活性炭纤维（Activated Corbon Fiber,ACF）这种特殊的炭吸附材料适用于哪种吸附模型,未见有文献专题论述。本论文在对ACF材料进行了大量表面结构研究的基础上,对ACF的表面结构与颗粒活性炭（GranularActivated Carbon,GAC）的表面进行了对比,并尝试性地对适用于ACF的吸附模式进行了计算和比较,得到了一些有价值的结论。     

Functional flax fiber with UV-induced switchable wettability for multipurpose oil-water separation

● A PAA-ZnO-HDTMS flax fiber with UV-induced switchable wettability was developed. ● The property of flax fiber could be switched from hydrophobicity to hydrophilicity. ● The mechanism of the acquired UV-induced switchable wettability was discussed. ● The developed flax fiber was successfully used for multipurpose oil-water separation. The large number of oily wastewater discharges and oil spills are bringing about severe threats to environment and human health. Corresponding to this challenge, a functional PAA-ZnO-HDTMS flax fiber with UV-induced switchable wettability was developed for efficient oil-water separation in this study. The developed flax fiber was obtained through PAA grafted polymerization and then ZnO-HDTMS nanocomposite immobilization. The as-prepared PAA-ZnO-HDTMS flax fiber was hydrophobic initially and could be switched to hydrophilic through UV irradiation. Its hydrophobicity could be easily recovered through being stored in dark environment for several days. To optimize the performance of the PAA-ZnO-HDTMS flax fiber, the effects of ZnO and HDTMS concentrations on its switchable wettability were investigated. The optimized PAA-ZnO-HDTMS flax fiber had a large water contact angle (~130°) in air and an extremely small oil contact angle (~0°) underwater initially. After UV treatment, the water contact angle was decreased to 30°, while the underwater oil contact angle was increased to more than 150°. Based on this UV-induced switchable wettability, the developed PAA-ZnO-HDTMS flax fiber was applied to remove oil from immiscible oil-water mixtures and oil-in-water emulsion with great reusability for multiple cycles. Thus, the developed flax fiber could be further fabricated into oil barrier or oil sorbent for oil-water separation, which could be an environmentally-friendly alternative in oil spill response and oily wastewater treatment.     

Effect of different pearling times on the quality of hull-less barley rice北大核心CSCD

Hull-less barley is a special food crop rich in various nutrients in Qinghai-Tibet Plateau. Six-pearling is often used to produce commercial hull-less barley rice in order to improve its rough taste and inferior cooking quality. This study evaluated the differences in the nutritional, cooking, sensory, and storage qualities of hull-less barley rice with different pearling times to obtain suitable processing conditions for the production of high-quality hull-less barley rice. With increasing pearling time, the contents of vitamin B6, vitamin E, dietary fiber, iron, zinc, phenols, and flavonoids significantly decreased to a large extent, protein and vitamin B3 decreased slightly, the contents of total starch and β-glucan increased significantly, and γ-aminobutyric acid (GABA) initially increased and then decreased. The peak, trough, and final viscosity of whole grain barley were 1 860.50 cP, 914.50 cP, and 2 150.00 cP, respectively, and increased after six-pearling to 4 219.00 cP, 2 628.00 cP, and 5 074.00 cP, respectively. At the same time, the water absorption and volume expansion of the pearled hull-less barley increased significantly. The hardness of pearled hull-less barley reduced from 4 708.50 g to 2 282.00 g, its adhesiveness increased from 0.00 to -7.33, and its taste and sensory quality exhibited better. The activities of α-amylase, polyphenol oxidase, lipase, and catalase in pearled hull-less barley slightly decreased. Hull-less bran flour is rich in a variety of nutritional components and could be a potential resource with great developmental value. In general, hull-less barley rice obtained from three-pearling has high nutritional value, high cooking quality, low enzyme activity, and low energy consumption; therefore, it can be used to produce high-quality barley rice. This study provides important information for high-quality pearled hull-less barley and further utilization of barley bran flour. © 2022 Science Press. All rights reserved.     

尿素基纤维的制备及对水中Cu2+和Cd2+的吸附

以棉纤维为原料,经氯化和取代反应,制得尿素基纤维并用于水中Cu^2＋和Cd^2＋的吸附,考察了各种因素对吸附效果的影响。尿素基纤维对Cu^2＋和Cd^2＋的吸附可用Langmuir等温吸附方程描述,吸附过程可看成单层吸附。较佳吸附条件：重金属离子溶液pH为5,流量为7mL／min。用过的尿素基纤维经2mol／L的盐酸洗脱再生后,对Cu^2＋的吸附、解吸、再吸附的性能良好,可重复使用。