碱处理对玉米秸秆纤维素结构的影响

介绍了在高固含率条件下氢氧化钠(NaOH)和氢氧化钙(Ca(OH))2堆沤处理对玉米秸纤维素结构的影响。分别用2.5%、5%和7.5%(ρ)的NaOH和Ca(OH)2将玉米秸在常温下堆沤处理3 d后,提取其纤维素,采用傅立叶变换红外光谱(FTIR)和X射线衍射光谱(XRD)对比研究了处理前后纤维素的结构和结晶度的变化。结果表明碱堆沤处理使玉米秸秆中纤维素的形态结构发生了变化,部分分子间氢键断裂,部分酯键消失,随着碱用量的增加,纤维素结构被破坏的程度越大;纤维素的晶体类型与002面微晶位置虽然没有改变,但是纤维素的结晶度与002面微晶尺寸增大。这些变化表明碱处理能提高玉米秸秆纤维素的可及度和反应性,从而改善厌氧消化性能。其中NaOH较Ca(OH)2表现出更好的纤维素润胀能力和反应性,在处理秸秆提高其厌氧消化产甲烷性能上具有更大的潜力。     

Adsorption of phosphate ions from water using a novel cellulose-based adsorbent

A novel cellulose-based adsorbent, iron(III)-coordinated amino-functionalised poly(glycidylmethacrylate)-grafted cellulose [Fe(III)–AM-PGMACell] was developed for the removal of phosphate from water and wastewater. The scanning electron micrograph showed that AM-PGMACell has a rougher surface than cellulose and the adsorption of Fe(III) on AM-PGMACell made the surface even rougher. Infrared spectroscopy revealed that amino groups on the surface of AM-PGMACell complexed with Fe(III) played an important role in the removal of phosphate from solutions. X-Ray diffraction patterns showed a decrease in crystallinity after graft copolymerisation onto cellulose. The effects of contact time, initial sorbate concentration, pH, agitation speed, dose of adsorbent and temperature on the removal process were investigated. Maximum removal of 99.1% was observed for an initial concentration of 25 mg·L ^?1 at pH 6.0 and an adsorbent dose of 2.0 g·L ^?1. A two-step pseudo-first-order kinetic model and Sips isotherm model represented the measured data very well. Complete removal of 11.6 mg·L ^?1 phosphate from fertiliser industry wastewater was achieved by 1.6 g·L ^?1 Fe(III)–AM-PGMACell. The adsorbent exhibited very high reusability for several cycles. Overall, the study demonstrated that Fe(III)–AM-PGMACell can be used as an efficient adsorbent for the removal and recovery of phosphate from water and wastewater.     

Photochemical reactions of musk ketone

The photolysis of musk ketone in cyclohexane and methanol afforded several cyclization products while the product spectrum in cyclohexene and squalene was characterized by an amino derivative and a ring expansion product, respectively. On cellulose stearate layers the photochemical reactions of musk ketone proceeded readily both under sun simulator and in natural sunlight and several photoproducts identified in solvent experiments were detected. Photoproducts were isolated by preparative HPLC and TLC and analyzed by means of HPLC, GC/MS, MS, LC/MS, ¹H‐ and ¹³C‐NMR.     

PBS共聚物对蚯蚓的蛋白质含量和纤维素酶活性的影响

以赤子爱胜蚓Eisennia foetida为研究对象,在滤纸接触法的基础上,采用自然土壤法进行急性毒性试验,研究了不同相对分子质量的PBS-co-PCL共聚物对蚯蚓蛋白质含量和纤维素酶活性的毒性效应。研究结果表明：随着暴露时间的增长,蚯蚓蛋白质含量呈现先增加后减小的趋势;第7天时,数均相对分子质量（Mn）为8.0×103的聚合物对蛋白质的影响较明显;第14天时,相对分子质量（Mn）为1.6×104和2.8×104的聚合物对蛋白质的影响较明显。聚合物相对分子质量（Mn）为8.0×103处理组中,纤维素酶活性受到的抑制作用较明显,聚合物含量为2.5%时,抑制作用达到最大。但是随着暴露时间的增长,这种抑制作用逐渐减小,即影响是暂时性的,纤维素酶活性变化比蛋白质含量变化更敏感。以上结果表明蚯蚓在实验过程中没有出现致病或致死现象,即聚合物对蚯蚓的影响较小。     

Functional Properties of Extruded Acetylated Starch-Cellulose Foams

Acetylated starches, with degrees of substitution (DS) of 2, 2.5 and 3, were blended with 3%, 7.5% and 12% -cellulose and 14%, 17% or 20% (d.b.) ethanol and twin-screw extruded at 165°C barrel temperature and 225 rpm screw speed. A response surface methodology experimental design was applied to the sub-plot and a completely randomized design to the whole plot design to test the differences among the acetylated starches and the effects of cellulose and ethanol. DS, cellulose and ethanol contents significantly affected the functional properties and specific mechanical energy requirement. DS had positive effects on radial expansion ratio (RER), compressibility and specific mechanical energy requirement and a negative effect on bulk density. Highest (RER) was obtained from 20% ethanol content. Extrudates containing 12% cellulose had the highest bulk density and the highest compressibility. Higher cellulose contents required more specific mechanical energy.     

纤维素热裂解的二次反应研究

在热重红外联用分析仪上开展了纤维素的热裂解失重研究,通过对纤维素热裂解的TG和DTG曲线以及热解产物的红外析出图谱的分析研究,探讨了纤维素热裂解的二次反应过程及机理,并在经典Broido—Shafizdeh模型的基础上．提出了改进的纤维素热裂解模型。     

稻草经超声波辅助预处理后酶解过程的动力学研究

在功率为120 W、处理时间为30 min的条件下,分别对稻草进行超声波辅助酸碱预处理,与传统化学预处理(碱-预处理、酸-预处理)后稻草的主要化学组成相比较,结果表明超声波技术辅助酸碱预处理可以更为有效地去除半纤维素和木质素,从而提高了稻草基质中纤维素的相对含量,有利于缩短稻草水解时间。在一系列实验研究的基础上,建立了稻草酶水解动力学模型。结果表明,分别经碱、超声波-碱、酸、超声波-酸预处理的稻草在糖化过程中的模型参数(米氏常数KM,速率常数k和抑制常数KI)均不相同,KM分别为17.55、14.14、15.29和15.08 g/L;k分别为15.30、21.32、13.40和15.42 h-1;抑制常数KI变化不明显分别为2.31、2.08、1.81和1.85 g/L。模型及实验方法简便可靠,有较好的拟合性,对稻草酶水解过程工程放大及过程控制都具有一定的参考价值。     

用于地表水反硝化的纤维素碳源选择研究

为了选取合适的天然有机物作为反硝化细菌碳源用于解决地表水中NO3--N污染问题,以江南大学校内湖水为接种物,选取8种天然纤维素碳源在缺氧状态不同的处理方式下对60 mg/L NO3--N的降解特性进行研究。结果表明,以碱处理作为预处理可明显提高反硝化速率,碳源脱氮率均在96%以上（树皮除外）。2种处理方式中均有NO2--N累积,部分碳源释放NH4＋-N并发生DNRA反应,树叶在2种处理中脱氮效果均较好。结合各碳源脱氮率、耗碳源量以及处理成本,选取基本处理的香樟叶作为最佳纤维素碳源。     

包覆型纳米零价铁的制备及其去除水中的活性艳蓝

采用流变相法,以FeSO4.7H2O∶KBH4=1∶2(摩尔比)为固相介质,0.06 g/mL CMC(羧甲基纤维素)水溶液为液相介质,固液比1∶2,反应2 h制备出包覆型纳米零价铁;采用XRD、TEM等手段对合成的纳米零价铁进行表征。探讨不同反应条件对包覆型纳米铁去除活性艳蓝的影响。实验结果表明,初始活性艳蓝(浓度100 mg/L)pH为5,包覆型纳米铁的投加量为6 g/L,反应时间为30 min时,活性艳蓝的去除率可达96%。通过研究机理,其吸附过程符合二级吸附动力学,降解过程符合一级反应动力学。     

改性纤维素吸附剂的合成及其对铜离子的吸附

建立了一种简单方便的纤维素改性的固相合成方法。采用普遍廉价的滤纸作为原料,用固相合成法将预处理后的滤纸纤维经琥珀酸酐进行酯化改性,制备成新型的纤维素吸附剂,通过质量增比、扫描电镜、傅里叶红外光谱仪和X射线衍射仪对制备的吸附剂进行了分析表征,并且探究了离子初始浓度、溶液p H和吸附时间对改性纤维素吸附铜离子的影响。结果表明,在室温下初始离子浓度为1 000 mg/L,离子溶液体积为50 m L,加入0.1 g纤维改性剂,p H为4.0~5.0,吸附平衡时间为50 min时,滤纸纤维改性后最大吸附铜离子质量可达470 mg/g,铜离子去除率达到94%。