紫外光芬顿-膜分离耦合体系降解金霉素

以金霉素为降解对象，采用沉淀法制备α-FeOOH光催化剂，进一步将其用共价结合法负载在陶瓷膜上，用SEM、XRD、EDS、UV-Vis和FTIR对α-FeOOH和光催化陶瓷膜进行表征.结果表明催化剂α-FeOOH呈针状或纺锤长片状，长宽分别为500~550nm、25~50nm，经α-FeOOH改性的陶瓷膜孔隙率由14.83%变为8.11%.研究光芬顿陶瓷膜耦合体系对金霉素的降解效率和动力学行为，确定了光芬顿陶瓷膜耦合体系的最优降解条件为金霉素初始浓度50mg/L，H₂O₂投加浓度10mmol/L，UV强度为3796.6μW/cm².进一步利用UV-Vis光谱分析了两种体系对金霉素的降解机理，光催化剂体系下，H₂O₂的浓度基本保持不变，而光芬顿陶瓷膜耦合体系下H₂O₂的浓度先升后降，同时后者在同一时间点对TOC和NH₄⁺-N去除率更高，表明光芬顿陶瓷膜耦合体系氧化能力更强，对金霉素的降解更为彻底.     

无机陶瓷纳滤膜分离高钠盐废水中的锶

本实验研究表明,仅用截留分子量为1000的无机陶瓷纳滤膜分离高钠盐模拟溶液中的锶,分离效果并不理想.为提高陶瓷纳滤膜对锶的选择分离效果,选择了分子量为3000的聚丙烯酸作为陶瓷纳滤膜分离的强化剂,重点探讨了溶液pH值、聚丙烯酸浓度、温度及离子强度对模拟溶液盐分离效果和膜通量的影响,并得到了适宜的锶钠分离条件.实验结果表明,在适宜条件下,通过聚丙烯酸强化和两级分离,陶瓷纳滤膜可大大提高模拟溶液中锶离子的选择分离效果,锶/钠的分离因子高达205.     

疾病预防控制中心废水处理技术工程实例

疾病预防控制机构废水具有重金属种类繁多、含病原体数量大、间断性排放等特点,通过运用混凝沉淀＋曝气生物滤池（BIOFOR）＋ClO2消毒工艺对其废水进行处理,处理后废水达到《医疗机构水污染物排放标准（》GB18466-2005）排放标准。     

Particle properties in granular activated carbon filter during drinking water treatment

The elemental composition and bacteria attached in particles were investigated during granular activated carbon (GAC) filtration.The experimental results showed that trapped influent particles could form new,larger particles on GAC surface.The sloughing of individuals off GAC surface caused an increase in effluent particles in the size range from 5 to 25 μm.The selectivity for element removal in GAC filters caused an increasing proportion of metallic elements in the effluent particles.The distribution of molar ratio indicated a complicated composition for large particles,involving organic and inorganic substances.The organic proportion accounted for 40% of total carbon attached to the particles.Compared with dissolved carbon,there was potential for the formation of trihalomethanes by organic carbon attached to particles,especially for those with size larger than 10 μm.The pure carbon energy spectrum was found only in the GAC effluent and the size distribution of carbon fines was mainly above 10 μm.The larger carbon fines provided more space for bacterial colonization and stronger protection for attached bacteria against disinfection.The residual attached bacteria after chorine disinfection was increased to 10 2-10 3 CFU/mL within 24 hours at 25°C.     

陶瓷材料放射性衰变时间及最佳平衡周期研究

简述了有关放射性样品衰变平衡及平衡时间的基本理论,运用碘化钠γ谱仪对衰变时间介于0～27 d区间内的三组陶瓷样品进行放射性比活度测定,采取t检验法分析了同一样品在0d～7d、7d～12d、15 d、21 d等不同衰变时间条件下,放射性核素226Ra、232Th、40K比活度测试结果之间的差异程度,通过实验验证陶瓷样品衰变时间对其放射性测定结果准确性的影响.研究表明,当每组检测结果数据的显著性差异水平为5％,若兼顾科学性和经济性,则陶瓷样品的最佳放射性衰变时间应为至少21 d.     

自来水厂除锰滤池的成熟与微生物群落的研究

为探讨自来水厂除锰滤澉成熟的生物机理,从生产滤池和实验滤柱成熟过程的不同阶段取１０００多个水质和细菌样品进行了分析测试。实验结果表明：滤池的成熟过程是不同细菌有规律的增殖并固定在滤料和包埋于铁泥的过程;当每ｇ滤砂的细菌个数超过１０＾４时,滤滤池才能成熟和高速除锰,随反冲洗强度及提高水质量。     

无机超滤技术和生化处理技术在宝钢冷轧含油废水处理中的应用

冷轧废水处理是轧钢工艺中的难点之一。宝钢 2 0 30冷轧废水处理改造工程 ,首次将生化处理技术引入到冷轧含油废水处理工艺 ,并在工程中采用了无机陶瓷超滤技术 ,从而实现了冷轧废水处理的国产化及国内技术总成     

Measurements of selected PCBs in open urban ambient air of Madrid (Spain)

The focus of this study was to characterize the concentration levels of selected PCBs and compare them to compiled data in order to contribute to the international database. The sampling site is located in the outskirts of Madrid and can be considered an open urban area. 32 samples of air were taken from February 1998 to June 1998 by using a high volume air sampler. Glass fiber filters and polyurethane foam (PUF) were used to collect the paniculate and gas phase material, respectively. PUF plugs were Soxhlet extracted and filters were ultrasonically extracted by using pesticide-grade hexane and dichloromethane, respectively. The cleanup procedure was carried out on a florisil column with hexane and hexane/dichloromethane as elution solvents. GC/MS in a selected ion monitoring mode was used for quantification and 29 selected PCBs congeners were analyzed.     

燃煤陶瓷隧道窑的烟气净化技术

主要论述了某陶瓷厂新建成的燃煤隧道窑的除尘脱硫设施。采用湿式除尘脱硫与陶瓷微孔过滤除尘技术相结合 ,同时通过在循环水中加生石灰的方法进行脱硫 ,净化后的烟气通过 35米烟囱排放。经当地环保部门监测 ,净化后的烟气完全达标排放。该套设备除尘效率不低于 94.94% ,平均达到 95 .87% ;脱硫效率不低于 56 .2 5% ,平均达到 63 .69%     

Neutron activation analysis of ceramic tiles and its component and radon exhalation rate

IntroductionCeramic,consistofearthymaterialslikeclaykaolin ,limestoneandsandglass .Ceramicmaterialsarenonmetalic ,inorganiccompoundsprimaryoxides ,alsocarbides ,nitridesandsilicides .Twotypesofbondingmechanismsoccurinceramicmaterial ,ionicandcovalent.Theo…