气相色谱法测定工业废水中联苯与菲

文章研究了一种新的测定废水中联苯及菲含量的方法,该方法采用气相色谱薄涂柱,对联苯与菲进行了有效的分离与测定。该方法具有固定液用量少,柱温低,分离效果好,分析速度快等特点,利用该对废水样进行了测定,取得了满意的结果。     

Surface reaction of Bacillus cereus biomass and its biosorption for lead and copper ions

In this study, the surface chemical functional groups of Bacillus cereus biomass were identified by Fourier transform infrared （FTIR） analytical technique. It had been shown that the B. cereus cells mainly contained carboxyl, hydroxyl, phosphate, amino and amide functional groups. The potentiometric titration was conducted to explain the surface acid-base properties of aqueous B. cereus biomass. The computer program FITEQL 4.0 was used to perform the model calculations. The optimization results indicated that three sitesthree pKas model, which assumed the cell surface to have three distinct types of surface organic functional groups based on the IR analysis results, simulated the experimental results very well. Moreover, batch adsorption experiments were performed to investigate biosorption behavior of Cu（Ⅱ） and Pb（Ⅱ） ions onto the biomass. Obviously, the adsorption equilibrium data for the two ions were reasonably described by typical Langmuir isotherm.     

Direct simulation of heterogeneous diffusion and inversion procedure applied to an out-diffusion experiment. Test case of Palmottu granite

An out-diffusion laboratory experiment using a non-reactive tracer was fitted using the Time Domain Diffusion (TDD) method. This rapid particle tracking method allows simulation of the heterogeneous diffusion based on pore-scale images and local values of diffusivities. The superimposed porosity and mineral 2D maps act as computation grids to condition diffusion pathways. We focused on a Palmottu granite sample, in which the connected pore space has a composite microstructure with cracks linking microporous minerals and is above the percolation threshold. Three main results were achieved: (i) When compared to the fitting obtained with one coefficient (best mean square residual R = 1.6 x 10(-2)), diffusion is shown to be suitably characterised with two coefficients related to cracks and microporous minerals (best R = 6.5 x 10(-4)), (ii) rather than imposing a local apparent diffusion coefficient D(a) independent of the local porosity Phi, a best fit is obtained by applying Archie's relationship D(a) = D(0) x G with G = Phi(m) to each pixel of the calculation grids (G is the geometry factor, D(0) is the diffusion coefficient in free fluid, and m is Archie's exponent), and (iii) the order of magnitude of the fitted diffusion coefficient or Archie's exponents (m=0 for microcracks and m=1.82 for microporous minerals) is physically realistic.     

改性沸石对2,4-二氯苯酚的去除作用

采用溴化十六烷基三甲铵(HDTMAB)制备改性沸石,在与天然沸石对比的基础上,研究了改性沸石在动态条件下去除2,4-DCP的效果。并对影响去除率的主要因素,包括沸石粒径、进水浓度,进水流速,沸石用量,进水pH值等进行研究。结果表明,细粒改性沸石在pH2.5左右时处理低浓度2,4-DCP溶液时,能取得较好的去除效果,流速较低时去除率最高可达80%以上。     

HP6890色谱柱用于环境空气中微量恶臭硫化物的检测

利用HP6890型气相色谱仪进行环境空气中微量恶臭硫化物分析,实验结果表明:分离效果、峰形都很好,实验采用4种柱箱初始温度及升温程序,分别由初始温度70℃升温至90℃、120℃、130℃及由初始温度150℃,最后升温至190℃,相应分析一个样品的时间依次为:130.515min、63.419min、56.359min及11.116min,样品分析时间大大缩短,可提高分析效率。     

苏南地区新近沉积土的动剪切模量比与阻尼比--试验研究

苏南地区的场地土主要为漫滩相、湖沼相或冲湖相新近沉积软弱土，结构松散，沉积零乱，成分复杂，饱水可液化粉细砂层及粉土层较为发育，在地震或动力荷载的作用下有可能发生软土震陷或砂土液化。通过对苏南地区淤泥质粉质粘土、粘土、粉质粘土、粉质粘土与粉细砂互层土、粉土、粉砂、细砂和中粗砂等8类新近沉积土155个原状土样历时4年的试验研究，给出了该地区上述8类新近沉积土的动剪切模量比G／Gmax和阻尼比D随剪应变幅值γ变化的平均拟合曲线及其参数的推荐值。为便于一般工程应用，给出了这8类新近沉积土的G/Gmax-γ，和D—γ关系曲线的推荐值及其标准差。     

石灰石/石灰-石膏湿法脱硫几种反应塔的比较

石灰石／石灰－石膏湿法烟气脱硫是控制二氧化硫排放的最常用方法。通过对该方法几种主要工艺及反应塔的比较,研究了喷淋塔,格栅塔,鼓泡塔和液柱塔在结构与工艺上的差异,以及它们在中国的实际应用,分析了各种脱硫反应塔的优缺点,并由此归纳出脱硫反应塔发展的趋势,研究结果将为脱硫工艺以及脱硫塔的选择提供依据和参考。     

钢管混凝土柱耐火性能和抗火设计的特点

简要论述了按ISO－834和GS9978－88规定的标准升温曲线升温作用下钢管混凝土柱耐火性能的特点,分析了影响钢管混凝土柱耐火极限的因素,说明了由于钢管和混凝土的共同工作且核心混凝土具有较好的吸热性能,从而使钢管混凝土柱具有较好的耐火性能。在进行钢管钢混凝土柱的抗火设计时,柱子外围只需进行适当的防火涂料保护,即可达到《高层用民建筑设计防火规范（GB50045－95）》对柱结构所要求的耐火极限。《高层用民建筑设计防火规范（GB50045－95）》中对钢结构柱防火保护层厚度的确定方法不适合于钢管混凝土。     

磁河有机污染物在饱和土壤中迁移转化试验研究

通过静态吸附、静态降解和动态土柱试验,研究了磁河废水中有机污染物在土壤饱水条件下的迁移转化行为.实验结果经线性拟合和参数估算,得到弥散系数D=0.0036m2/d,分配系数K_d=0.19cm3/g,降解系数K=0.68 d-1.表明磁河有机污染物在土壤中有较强的吸附和降解能力.      

A process-based model designed for filling of large data gaps in tower-based measurements of net ecosystem productivity

In this paper we present a simple hybrid gap-filling model (GFM) designed with a minimum number of parameters necessary to capture the ecological processes important for filling medium-to-large gaps in Flux data. As the model is process-based, the model has potential to be used in filling large gaps exhibiting a broad range of micro-meteorological and site conditions. The GFM performance was evaluated using “Punch hole” and extrapolation experiments based on data collected in west-central New Brunswick. These experiments indicated that the GFM is able to provide acceptable results (r² > 0.80) when >500 data points are used in model parameterization. The GFM was shown to address daytime evolution of NEP reasonably well for a wide range of weather and site conditions. An analysis of residuals indicated that for the most part no obvious trends were evident; although a slight bias was detected in NEP with soil temperature. To explore the portability of the GFM across ecosystem types, a transcontinental validation was conducted using NEP and ancillary data from seven ecosystems along a north-south transect (i.e., temperature–moisture gradient) from northern Europe (Finland) to the Middle East (Israel). The GFM was shown to explain over 75% of the variability in NEP measured at most ecosystems, which strongly suggests that the GFM maybe successfully applied to forest ecosystems outside Canada.