硫铁填料和微电流强化再生水脱氮除磷的研究

为提高再生水质量,在不同C/N和HRT条件下,对比分析硫铁复合填料和微电流作用强化再生水深度脱氮除磷效果.结果表明,硫铁复合填料和微电流作用均能够强化氮、磷的深度去除效果,且二者结合能够使反硝化系统pH值稳定在7.2~8.5之间.系统中TN主要靠异养反硝化、氢自养反硝化和硫自养反硝化作用去除,94.04%的TP是以生成磷酸铁沉淀的形式去除.分别从填料上取生物膜,进行Miseq高通量测序,构建细菌16S rRNA基因克隆文库.结果发现,在仅有海绵铁作用系统中,同时具有异养反硝化和氢自养反硝化功能的细菌所占比例达到29.47%;硫铁复合填料和硫铁微电流作用系统中,具有硫自养反硝化功能的Thiobacillus(硫杆菌属)所占比例分别达到60.47%和40.62%.因此,硫铁复合填料和微电流作用用于强化再生水深度脱氮除磷具有明显的优势.     

有机大分子对聚酰胺复合纳滤膜偏硅酸钠污染的影响

选用腐殖酸(HA),海藻酸钠(SA),牛血清蛋白(BSA)和偏硅酸钠分别模拟水体中有机大分子和无机污染物对聚酰胺复合纳滤膜进行了膜污染试验.结合原子力显微镜(AFM)及自制的胶体探针定量测定了不同条件下,膜-偏硅酸钠以及偏硅酸钠-偏硅酸钠之间的作用力.分析了污染膜的表面结构特征及其通量恢复率,系统考察了膜表面吸附不同有机大分子后,对随后硅酸盐污染行为的影响.结果表明:膜表面吸附HA和SA后,膜面负电位增加,与偏硅酸钠之间静电斥力变大,导致其结合能力减弱,减缓了结垢污染.然而,吸附BSA后的膜与无有机条件膜相比,负电位基本一致,故对纳滤膜结垢过程几乎无影响.     

腐殖酸与典型碳纳米材料协同光致产生活性氧物种的研究

采用电子自旋共振光谱(EPR)技术,分析腐殖酸在光照下对4种典型碳纳米材料诱导产生单线态氧(~1O_2)和羟基自由基(·OH)的影响。基于密度泛函理论计算4种典型碳纳米材料的前线轨道能,比较了它们分别经能量转移诱导产生~1O_2的能力以及经电子传递诱导产生·OH的能力。结果显示,4种不同形状的碳纳米材料(富勒烯、单壁碳纳米管、多壁碳纳米管以及石墨烯)悬浮液在紫外光照下均无~1O_2和·OH产生。与腐殖酸共同存在下,4种碳纳米材料均显著诱导~1O_2的产生,且富勒烯和石墨烯还能光致生成·OH。协同产生~1_O2的能力大小为:单壁碳纳米管富勒烯多壁碳纳米管石墨烯,协同产生·OH的能力大小为:石墨烯富勒烯。~1O_2的产生能力与碳纳米材料的能隙大小和颗粒聚集程度有关,而诱导产生·OH的能力主要取决于化学硬度。总之,我们的研究表明腐殖酸与碳纳米颗粒可协同产生活性氧物种。     

复合指纹识别泥沙来源:潜在泥沙源地的选择

复合指纹识别技术应用于泥沙源解析的前提是假设研究者能够确定流域内泥沙的潜在来源类型,并且各泥沙源地所占比例之和为1,对潜在源地预判的不确定性将会对结果产生一定的影响。以南京市九乡河上游流域为例,对不同源地各指纹因子做均值显著性检验,检验各个预判源地能否单独作为潜在泥沙源地,同时对比分析不同沙源地对复合指纹因子判断泥沙来源正确率的影响,定量分析沙源地预判过程中的不足,探讨如何减少沙源地选择对泥沙来源识别的影响。通过对比研究发现,预判的4种泥沙源地被重新调整为农田、林地和道路3种类型。调整后各源地指纹因子差异性明显提高,不同泥沙来源的正确判别率最高达到89.2%,泥沙贡献率从高到低依次为农田(39.9%~87.8%)、林地(0.1%~47.7%)和道路用地(0~25.6%)。     

Preliminary study of groundwater denitrification using a composite membrane bioreactor

A composite membrane bioreactor (CMBR) integrating the immobilized cell technique and the membrane separation technology was developed for groundwater denitrification. The CMBR had two well mixed compartments with one filled with the nitrate- containing influent and the other with a dilute ethanol solution; the compartments were separated by the composite membrane consisting of a microporous membrane facing the influent and an immobilized cell membrane facing the ethanol solution. Nitrate and ethanol molecules diffused from the respective compartments into the immobilized cell membrane where nitrate was reduced to gaseous nitrogen by the denitrifying bacteria present there with ethanol as the carbon source. The microporous membrane was attached to one side of the immobilized cell membrane for retention of the disaggregated bacteria. Relative to the single dose of external ethanol, the two-dose supplementation produced better treatment results as evidenced by the lower concentrations of NO3--N and ethanol (as measured by total organic carbon) of the effluent. The batch treatment in CMBR removed most of the nitrate in the influent and attained a stable denitrification rate of 0.1 g·m^-2·h^-1 for most of the 96-h cycles during the 30-cycle study. The effluent was essentially free of ethanol and nitrite nitrogen.     

复合矿物吸附剂处理模拟含油废水性能研究

采用共混合法制备复合矿物吸附剂,通过矿物粉末对模拟含油废水COD的去除效果及复合矿物吸附剂质量散失率确定其组分的最佳配比。考察了吸附时间、振荡速率、废水pH、吸附剂用量等因素对模拟含油废水COD去除效果的影响。结果表明:制备复合矿物吸附剂最佳焙烧温度为600℃,最佳焙烧时间3 h,对模拟含油废水中COD的去除率可达90%以上。     

Removal of Remazol Brilliant Violet-5R dye using periwinkle shells

The purpose of this research is to obtain optimal processing conditions for the adsorption of Remazol Brilliant Violet-5R (RBV-5R) dye onto activated carbon prepared from periwinkle shells (PSAC) by chemical activation with KOH using response surface methodology. Central composite design (CCD) was used to determine the effects of three preparation variables; CO₂ activation temperature, CO₂ activation time and KOH:char impregnation ratio (IR) on two responses; percentage RBV-5R dye removal and PSAC yield. Based on the CCD, two quadratic models were developed for percentage RBV-5R dye removal and PSAC yield, respectively. The most influential factor on each experimental design response was identified from the analysis of variance (ANOVA). The optimum conditions for the adsorption of RBV-5R dye onto PSAC were CO₂ activation temperature of 811 °C, CO₂ activation time of 1.70 h and IR of 3.0, resulting in 81.28% RBV-5R dye removal and 28.18% PSAC yield. PSAC prepared under optimum conditions was mesoporous with a Brunauer–Emmett–Teller surface area of 1894 m²·g^?1, total pore volume of 1.107 cm³·g^?1 and average pore diameter of 2.32 nm. The surface morphology and functional groups of the activated carbon were respectively determined from the scanning electron microscopy and Fourier transform infrared analysis.     

静电纺PA6/PET复合膜的制备及其空气过滤性能

主要研究静电纺纳米/微米纤维复合膜(PA6/PET)的制备及其空气过滤性能,电纺了几种不同密集度的复合膜,研究了其对氯化钠粒子在特定条件下的过滤能力,进行了加载过滤测试,并通过扫描电子显微镜(SEM)对过滤前后纤维膜的表面形态进行观察.结果表明,对于多分散的NaCl粒子来说,过滤材料的过滤效率随着过滤时间的增加而增加.当增大过滤粒子流量时,过滤阻力与流量呈现线性增长关系,但是过滤效率变化不大.本实验中复合膜的最低过滤效率为99.990%.     

Ce3+复合聚合硫酸铁絮凝剂的光谱分析及处理油田废水性能研究

以FeSO.47H2O为原料,NaClO3氧化法制备出聚合硫酸铁,并用Ce3+与其进行复合得到复合絮凝剂.运用紫外光谱及傅里叶红外光谱对絮凝剂样品进行了表征,并通过CODCr去除率和浊度去除率考察了絮凝剂处理油田废水的性能.结果表明,Ce3+与聚合硫酸铁复合以后,Ce3+与聚合硫酸铁中的羟基作用形成了新的化学键Ce—OH—Fe,实现了Ce3+与聚合硫酸铁的成功复合.该复合絮凝剂对油田废水的处理效果均优于聚合硫酸铁,当复合比为1.5%时处理效果最好,CODC r去除率和浊度去除率均接近或高于90%,表现出良好的应用前景.     

太湖湖滨带林草复合带草本植物枯落物量的变化特征

为减少湖滨带林带枯落物的产生,有效降低N、P随降水径流进入湖泊水体的风险,采用人工草坪替代林下杂草的方式,建立林草复合带.以5种草坪草为研究对象,设立3种种植密度,采用定位定期采集的方法,研究草坪建植后草本植物枯落物的变化以及不同种植密度对枯落物量的影响.结果表明:①间距15 cm高密度种植易导致草坪枯落物的产生,以白三叶和红花酢浆草较突出;草坪种植后林下草本植物枯落物量大幅度减少,平均枯落物量减少66%～95%.②草坪枯落物量随生长时间变化无明显规律,7—11月植物生长期间,白三叶草坪10月枯落物量最高;麦冬草坪、红花酢浆草草坪以及与其混种的其他草坪枯落物量最高时期均出现于8月.③白三叶高、低密度种植单种草坪产生的枯落物量大于与红花酢浆草混种草坪,而中密度种植则相反,单种草坪小于混种草坪.