Hydrothermal liquefaction phase behavior of microalgae & model compounds in fused silica capillary reactor

A fused silica capillary reactor combined with a heating/cooling stage, a microscope and a digital camera were used to investigate phase behavior during the hydrothermal liquefaction of microalgae (Dunaliella tertiolecta) and model compounds, including soya protein and glycine, starch, glucose and xylose, stearic acid and palmitic acid. Bubbles were generated at 246°C and disappeared at 360°C upon heating when Dunaliella tertiolecta used as feedstocks. Moreover, liquid products were generated at 300°C upon heating and oily liquid products began to separate out at 250°C upon cooling. The phase behavior of soya protein was similar to that of the Dunaliella tertiolecta. Meanwhile, there only observed the bubbles generation during hydrothermal liquefaction of glycine. Heating the starch, glucose and xylose above 350°C generated black solids from carbonization. Stearic acid and palmitic acid only had the process of melting, dissolution, dispersion and precipitation.     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水,考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时,COD去除率约为87%,出水COD在2500mg/L以下,出水挥发性脂肪酸（VFA）浓度为4~6mmol/L,最佳容积负荷为15.0kg/（m3·d）;采用SBR处理UASB出水,当容积负荷为1.5kg/（m3·d）时,出水COD在200mg/L以下,COD去除率在83%以上,ρ（NH₃-N）在5mg/L以下,TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷,加入量为5mL/L,处理后废水TP为4~6mg/L。处理后废水的COD,ρ（NH₃-N）,TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

一种包埋微生物复合填料的制备及性能评价

采用包埋法制备出一种复合生物填料,测其各项理化性质,并以NO。模拟废气验证其脱硝性能。填料主要由碳酸钙、牛粪堆肥腐殖质、菌剂载体、水泥、轻质珍珠岩、立体网状纤维及脱硝功能微生物等复合而成,粒径书12mm×20mm,自然堆积密度（471±0．8）kg／m2,持水量（49±1．3）％,比表面积3．91m2／g,平均机械强度（427．3±0．2）N,pH为10．5-0．2。填料能长期在潮湿环境中保持良好的粘结强度,并具有营养缓释及pH缓冲能力。包埋脱硝功能微生物复合填料中初期微生物数量5．3×10^5 CFU／g,运行60d后微生物数量达到8．6×10 8 CFU／g,闲置停运30d微生物有所减少,但重启后净化效率基本不变。当进气负荷低于I878mg／（13m3·h）,气体停留时间为14．47s时,BF,的去除率高达93．15％。     

微生物絮凝剂M-C11处理高岭土悬浊液的响应曲面优化

采用响应曲面法对微生物絮凝剂M-C11处理高岭土悬浊液的过程参数进行优化,选取中心复合实验设计(CCD),以p H、M-C11投加量和Ca Cl2投加量等因素为自变量,以处理后的高岭土悬浊液絮凝率(Fr)为响应值,并借助扫描电镜对絮凝剂的作用机理进行初步探讨。结果表明,微生物絮凝剂M-C11可显著改善高岭土悬浊液的絮凝性能,且选取的3种单因素水平均可影响絮凝剂活性。经多元回归拟合分析,在M-C11投加量为2.56 m L,Ca Cl2投加量为0.37 g/L的最优条件下,微生物絮凝活性实验值可达92.37%,接近模型预测值(92.30%)。Ca Cl2投加量对絮凝效果的影响高于M-C11投加量(PCa Cl2相似文献   

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

TiO2-Cu2O/蒙脱土复合光催化剂的制备与性能

以钠基蒙脱土（MMT）为载体,先采用溶胶-凝胶法将纳米TiO₂引入到MMT层间,再采用化学沉积法将纳米Cu₂O负载在TiO₂/MMT上,制备出TiO₂-Cu₂O/MMT纳米复合光催化剂。采用XRD、SEM、紫外-可见漫反射技术对催化剂进行了表征。以甲基橙为目标污染物,考察了催化剂的光催化性能。表征结果显示：TiO₂与Cu₂O均匀分布在MMT的表面与片层孔隙中;TiO₂-Cu₂O/MMT结合了TiO₂和Cu₂O的特性,拓宽了催化剂的光吸收范围。实验结果表明,在光源为可见光、初始甲基橙质量浓度为20 mg/L、光催化剂加入量为2 g/L的条件下,TiO₂-Cu₂O/MMT纳米复合光催化剂对甲基橙的光催化降解效果明显优于单一负载的Cu₂O/MMT和TiO₂/MMT,大幅提高了催化剂的光催化效率,反应300 min时TiO₂-Cu₂O/MMT对甲基橙溶液的脱色率达到93%。     

纳米二氧化钛复合石墨烯催化剂的制备及处理染料废水

以硫酸钛为原料,采用共沉淀法,制备了一系列纳米二氧化钛复合石墨烯催化剂,采用XRD和FTIR对样品进行表征。通过紫外光照射亚甲基蓝溶液光催化降解实验,研究石墨烯的加入量对TiO2光催化性能的影响,结果表明,TiO2-GO-5具有最佳的光催化性能。在pH=6.00、TiO2-GO-5的投加量为0.070 g/50 mL、光照3 h条件下,100 mg/L亚甲基蓝溶液的脱色率达到最大值为90.52%。     

两级EGSB反应器处理焦化废水的实验研究

采用两级膨胀颗粒污泥床(EGSB)反应器在微氧条件下处理焦化废水,分别考察了一级和二级EGSB反应器(EGSBⅠ和EGSBⅡ)对污染物的去除效果。结果表明,系统能够高效去除COD和NH3-N,EGSBⅠ主要用于去除COD,EGSBⅡ主要用于去除NH3-N。总水力停留时间(HRT)为24 h(EGSBⅠ12 h+EGSBⅡ12 h),系统对952 mg/L的COD、41.3 mg/L的NH3-N、34.55 mg/L的挥发酚、295.8 mg/L的硫氰化物和0.89 mg/L的氰化物的平均去除率分别为78.1%、81.3%、100%、98.1%和89.9%。出水COD、NH3-N、挥发酚、硫氰化物和氰化物的平均浓度分别为208、7.7、0、5.7和0.09 mg/L。出水NH3-N、挥发酚和氰化物浓度均低于《炼焦化学工业污染物排放标准》(GB 16171-2012)的直接排放限值。     

A full-scale sequencing batch reactor system for swine wastewater treatment

A full-scale sequencing batch reactor (SBR) system was evaluated for its ability to remove carbon and nitrogen from swine wastewater. The SBR was operated on four, six-hour cycles each day, with each cycle consisting of 4.5 hours of “React,” 0.75 hours of “Settling”, 0.75 hours for “Draw” and “Fill.” Within each cycle, an amount of wastewater equivalent to about 5% of the reactor volume (5,500 litres) was removed and added. The SBR system was able to remove 82% of biochemical oxygen demand (BOD) and more than 75% of nitrogen. Even though the SBR effluent, with an average effluent BOD₅ of about 588 mg L^{? 1}, did not meet the discharge criteria, it enabled a reduction of the land base required for land application of swine wastewater by about 75%. Results indicated that the SBR system was a viable method for the treatment of swine wastewater.     

Treatment of wastewater from red and tropical fruit wine production by zeolite anaerobic fluidized bed reactor

A study of the anaerobic treatment of wastewaters derived from red (RWWW) and tropical fruit wine (TFWWW) production was carried out in four laboratory-scale fluidized bed reactors with natural zeolite as bacterial support. These reactors operated at mesophilic temperature (35°C). Reactors R1 and R2 contained Chilean natural zeolite, while reactors R3 and R4 used Cuban natural zeolite as microorganism support. In addition, reactors R1 and R3 processed RWWW, while reactors R2 and R4 used TFWWW as substrate. The biomass concentration attached to zeolites in the four reactors studied was found to be in the range of 44–46 g volatile solids (VS)/L after 90 days of operation time. Both types of zeolites can be used indistinctly in the fluidized bed reactors achieving more than 80%–86% chemical oxygen demand (COD) removals for organic loading rates (OLR) of up to at least 20 g COD/L d. pH values remained within the optimal range for anaerobic microorganisms for OLR values of up to 20 and 22 g COD/L d for RWWW and TFWWW, respectively. Toxicity and inhibition levels were observed at an OLR of 20 g COD/L d in reactors R1 and R3 while processing RWWW, whereas the aforementioned inhibitory phenomena were not observed at an OLR of 24 g COD/L d in R2 and R4, treating TFWWW as a consequence of the lower phenolic compound content present in this substrate. The volatile fatty acid (VFA) levels were always lower in reactors processing TFWWW (R2 and R4) and these values (< 400 mg/L, as acetic acid) were lower than the suggested limits for digester failure. The specific methanogenic activity (SMA) was twice as high in reactors R2 and R4 than in R1 and R3 after 120 days of operation when all reactors operated at an OLR of 20 g COD/L d.