铁黄生产中废水处理与废渣的回收利用

介绍了氧化铁黄生产中的废水治理情况，同时其产生的废渣可回收利用。经过治理产生的环境、经济和社会效益显著。     

复合沸石动态膜系统的脱氨效能及其对沸石的同步回收

为同步实现吸附脱氨和微尺寸沸石回收,将沸石与动态膜技术耦合联用,构建了一种复合沸石-动态膜系统,并考察其脱氨和沸石回收效果。在初始氨氮质量浓度为10 mg·L⁻¹条件下,投加10 g·L⁻¹沸石可有效实现氨氮的去除,去除率为67%。吸附动力学和等温模型分析结果表明,该过程符合准二级动力学模型,Langmuir吸附等温模型拟合得到的最大氨氮吸附量为4.12 mg·g ⁻¹。按照1:1的质量比投加沸石与硅藻土,在投加量均为1 g·L⁻¹,流量为40 mL·min⁻¹,支撑膜孔径38 μm下可快速形成动态膜,出水浊度稳定在1 NTU以下,氨氮去除率可达到56%,在脱氨的同时能够实现沸石的有效回收。该研究结果可为复合沸石动态膜系统同步吸附脱氨和吸附材料回收提供参考。     

结晶沉淀-树脂吸附组合工艺回收黄连素废水中铜试验研究

通过多批次的小试试验考察了结晶沉淀-树脂吸附组合工艺对黄连素含铜废水的处理效果,并对产生的碱式氯化铜(TBCC)结晶沉淀进行X射线衍射(XRD)成分分析。结果表明:反应pH为7.0~9.0时,废水中超过99.9%的Cu ²⁺以碱式氯化铜结晶沉淀的形式得以回收,反应生成的碱式氯化铜沉淀通过水洗后,其成分符合GB/T 21696—2008《饲料添加剂 碱式氯化铜》质量标准。剩余的废水再经过树脂吸附工艺处理后,出水Cu ²⁺浓度小于1.0 mg/L。在小试试验的基础上,开展了中试试验研究,其结果进一步验证了小试试验的运行效果及该工艺的可行性。通过该处理工艺既可综合利用废水中的铜资源,又可将废水的pH由小于1调至大于7,有利于实现制药废水综合处理和达标排放。     

反应条件对等离子体脱除吸附于Cu-Ce/AC表面NOx的影响

以放电等离子体协同催化法对吸附在Cu-Ce/AC上的NOx进行脱除,研究了不同的放电条件和添加水蒸气对脱除NOx的影响。结果表明,对于同轴圆筒形反应器,催化剂量一定时,放电长度增加,吸附态NOx去除率先升高后下降;放电电压增大,吸附态NOx去除率升高,原因在于放电反应区内能量密度和活性粒子分布状态改变。根据NOx程序升温脱附（TPD）,TPD低温位（x更容易被放电等离子体脱除,放电长度和放电电压能够影响不同吸附位上NOx的去除效率。适宜条件下,吸附态NOx去除率最高达到93.3%。循环吸附-等离子体脱除NOx进行10次后,NOx脱除率在92%以上。在混合气中添加5%水蒸气提高了等离子体对吸附态NOx的去除率,但导致循环吸附-等离子体脱除NOx效率下降。原因是H2O与NOx竞争吸附带来的负面效应大于等离子体中H2O提供自由基与吸附态NOx反应所带来的正面效应。     

生产废水回用对常规净水工艺去除有机农药的影响

通过小试实验,研究了生产废水直接回用对常规净水工艺各处理单元去除有机农药的影响。结果表明,尽管生产废水直接回用能够显著提高浊度和UV254的去除率,但对有机农药去除的影响差异较大。对于具有较大正辛醇/水分配系数(lgKow)的农药,生产废水回用能够提高其去除效果,而对于lgKow较小的有机农药,生产废水直接回用对其去除效果没有显著影响;另外,由于生产废水本身含有一定浓度的该类农药,长期回用可能会引起出水中该类物质的富集现象。     

乙醇汽油对减少机动车污染排放的机理研究与分析

以93#国Ⅲ乙醇汽油(E10)、93#国Ⅲ普通汽油和93#国Ⅳ普通汽油为实验对象,对GB18352.3-2005中要求限定的CO、HC和NOx,以及颗粒物(PM)和CO2等主要污染物的排放进行了测量和对比研究,并对CO、HC、PM、NOx、CO2和苯系物等污染物的形成原因和减排机理进行了分析。和93#国Ⅲ普通汽油相比,93#国Ⅲ乙醇汽油(E10)排放的尾气中:CO降低了19.7%,HC降低了16.4%;和93#国Ⅳ普通汽油相比,93#国Ⅲ乙醇汽油(E10)排放的尾气中:CO降低了1.8%,HC降低了12.9%, CO2降低了2.4%。研究表明,乙醇汽油在减少CO、HC、NOx、颗粒物和苯系物等有毒物质排放方面具有显著功效,使用乙醇汽油可以减少环境污染物的排放,显著改善空气质量。     

Comprehensive Environmental Investigation at Former Industrial/Petroleum Underground Storage Tank Sites in Long Beach,CA: A Forensic Perspective

Two industrial sites were investigated based on years of available hydrogeologic information and monitoring data for soil and groundwater. Collected data were forensically evaluated using age-dating and fingerprinting methods. The previous business uses of the project sites were as a gas station, laundry/dry-cleaning service, and car wash with petroleum underground storage tanks (USTs). As a result, these sites were exposed to a number of toxic contaminants at relatively high concentrations. Source control was necessary for successful remediation and the ultimate removal of the remaining compounds from these industrial sites. Although contaminated soil around the source was excavated during the remedial action and the high concentrations of contaminants were reduced, typical groundwater contaminants such as petroleum hydrocarbons as gasoline (TPH-G), benzene, toluene, ethylbenzene, xylenes (BTEX), and oxygenates including methyl tert-butyl ether (MTBE), diisopropyl ether (DIPE), ethyl tert-butyl ether (ETBE), tert-amyl methyl ether (TAME), and tert-butyl alcohol (TBA) were persistently found at the studied sites around the source points. The plume and concentration of contaminants had changed their shapes and strength for all monitoring periods. Thus, additional source control seems to be a requirement for the complete removal of source contamination, which must be ascertained with groundwater and soil monitoring on a regular time base. For the study sites, monitored natural attenuation was relatively feasible for the long-term plan; however, it did not offer a perfect remediation solution for an ultimate goal because of residual toxic compounds that might have affected the surrounding residential areas at higher concentrations than their health limits. Therefore, as a remediation strategy, the combination of clean-up technology and natural attenuation with monitoring activities are more highly recommended than either clean-up or natural attenuation used separately.     

催化燃烧处理有机废气及催化剂中毒的防止

研究了在Ｐｔ、Ｐｄ、Ｃｅ多组分蜂窝状催化剂上乙醇、环己烷和苯的氧化性能及水蒸气对催化剂活性的影响,探讨了如何防止硫化氢和甲硫醇引起的催化剂中毒。     

提高油田伴生气回收率的研究与应用

文章阐述了陆梁油田在开发过程中采用油气混输技术、天然气发电机橇技术、锅炉烧湿气等技术,将伴生气回收率提高至92.10%;油气混输技术能够实现边缘区块油气全密闭输送;集中处理站锅炉燃烧湿气技术可增加处理站天然气外输气量,降低运行成本;小型活动天然气发电机橇的应用,可以充分利用富裕天然气降低生产成本,同时减少富裕天然气火炬放空燃烧量,收到了良好的经济效益和环境效益。     

废镍镉电池处置和金属回收关键技术研究进展

系统地介绍了处置废镍镉电池所涉及预处理、蒸馏、浸出、湿法分离和三废处理的关键技术,尤其是真空冶金、生物冶金、乳状液膜分离的研究成果,并对比了不同工艺对环境的影响。