海水异养硝化-好氧反硝化芽孢杆菌SLWX2的筛选及脱氮特性

从分离自刺参养殖环境的7株候选菌株中筛选出1株具有较强异养硝化和好氧反硝化能力的菌株SLWX_2,通过形态学特征、生理生化特性和16S rRNA基因测序分析鉴定其为花津滩芽孢杆菌(Bacillus hwajinpoensis).该菌株脱氮特性研究结果表明,SLWX_224 h对氨氮、亚硝酸氮和硝酸氮的去除率分别达到100%、99.5%和85.6%;当3种无机氮源同时存在时,菌株优先利用氨氮,再利用NO_2~--N和NO_3~--N,72 h 3种无机氮的质量浓度均降至0.013 mg·L~(-1)以下,表明该菌株能同时进行异养硝化和好氧反硝化完成脱氮;在氨氮负荷500 mg·L~(-1)、亚硝酸氮负荷100 mg·L·~(-1)和硝酸氮负荷200 mg·L~(-1)范围内,该菌的脱氮能力不受明显抑制,对3种形态的氮均有良好去除效果,96 h最多可去除180 mg NH_4~+-N、30 mg NO_2~--N和120 mg NO_3~--N,并且在硝化过程中没有亚硝酸氮积累.该菌株在海水养殖和高盐高氮工业废水的脱氮处理方面具有更大潜力.     

耦合厌氧氨氧化反应的高氮负荷型双室MFC性能研究

实验针对厌氧氨氧化反应在双室型MFC阳极和阴极2种形式的耦合,将厌氧氨氧化菌分别接种于a、b-双室型MFC的阳、阴极,并探究其产电、脱氮性能及脱氮机理.结果表明,2种类型的MFC均可在NH+4-N、NO-2-N浓度分别为400 mg·L-1和528 mg·L-1的高氮浓度模拟配水条件下稳定启动.与开路状态下的线性关系曲线不同,2类MFC在闭路状态下氨氮、亚硝态氮浓度均呈单指数关系衰减曲线,脱氮效率显著提高,周期内氨氮、亚硝态氮去除率均分别达到99%和85%以上.另外a、b-MFC平均容积氮去除负荷分别为0.417 kg·m-3·d-1和0.516 kg·m-3·d-1.在外阻1500Ω条件下,a-MFC最高输出电压48.0 m V,b-MFC最高输出电压可达到502.2 m V,b-MFC稳定输电周期约2170 min.     

黄土高原磷湿沉降特征及其对坝系流域磷输出影响-以羊圈沟为例

对黄土高原坝系流域磷(P)的湿沉降过程进行动态监测,分析了降雨-径流过程中各形态磷的输出变化,探讨了黄土高原坝系流域磷湿输出分异特征及其对水体的影响.结果表明:2015年湿季(7、8月)共11场降雨,产生的磷湿沉降负荷为30.8 kg,磷湿沉降通量为0.16kg·hm~(-2),干季(9月)共3场降雨,产生的磷湿沉降负荷为20.51 kg,磷湿沉降通量为0.11 kg·hm~(-2),干湿季磷湿沉降负荷呈现出明显差异性;选取3场降雨过程(降雨量从小到大)进行动态分析发现,流域磷湿沉降负荷分别为3.33、7.51和6.35 kg,相应的本地区磷湿沉降通量依次为0.02、0.04、0.03 kg·hm~(-2),3场降雨总磷(TP)的输出负荷为1.5×10-3kg,溶解性总磷(DTP)的输出负荷为1.24×10~(-3)kg,PO_4~(3-)-P的输出负荷为7×10-4kg,表明该地区磷湿沉降以可溶性磷为主.根据单因子评价方法中的标准指数法,发现流域水质不能满足Ⅴ类水质标准,应对流域水体加强管理.     

纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

POLLUTANT LOADS IN URBAN STORMWATER: REVIEW OF METHODS FOR PLANNING-LEVEL ESTIMATES1

ABSTRACT: A review of methods for planning-level estimates of pollutant loads in urban stormwater focuses on transfer of charac. teristic runoff quality data to unmonitored sites, runoff monitoring, and simulation models. Load estimation by transfer of runoff quality data is the least expensive, but the accuracy of estimates is unknown. Runoff monitoring methods provide best estimates of existing loads, but cannot be used to predict load changes resulting from runoff controls, or other changes of the urban system. Simulation models require extensive calibration for reliable application. Models with optional formulations of pollutant build up, washoff, and transport can be better calibrated and the selection of options should be based on a statistical analysis of calibration data. Calibrated simulation models can be used for evaluation of control alternatives.     

VELOCITY EQUATION FOR WATER QUALITY MODELING IN GEORGIA1

ABSTRACT: Tabletop water quality modeling still plays an important role in the water pollution control activities of the Georgia Environmental Protection Division. Tabletop models are those developed with out the aid of extensive field data. One important component of GEORGIA DOSAG, our basic water quality model, is the equation used to predict flow through velocity. However, Georgia is characterized by wide physiographic diversity which reduces the effectiveness of uncalibrated velocity equations. Using 15 years of accumulated time-of-travel studies, a series of empirical velocity equations were developed and calibrated to various physiographic conditions in Georgia. Equations are available for each major soil province and for three stream flow ranges within each province - Q<100 cfs, 100<Q<1000 cfs, and Q>1000 cfs. Now, in the absence of extensive field data, we have data based velocity equations which can be tailored to each site under study.     

MODELING FECAL COLIFORM CONTAMINATION IN THE RIO GRANDE1

This study examines sources of fecal coliform in Segment 2302 of the Rio Grande, located south of the International Falcon Reservoir in southern Texas. The watershed is unique because the contributing drainage areas lie in Texas and Mexico. Additionally, the watershed is mostly rural, with populated communities known as “colonias.” The colonias lack sewered systems and discharge sanitary water directly to the ground surface, thus posing an increased health hazard from coliform bacteria. Monitoring data confirm that Segment 2302 is not safe for contact recreation due to elevated fecal coliform levels. The goal of the study was to simulate the observed exceedences in Segment 2302 and evaluate potential strategies for their elimination. Fecal coliform contributions from ranching and colonia discharges were modeled using the Hydrologic Simulation Program‐Fortran (HSPF). Model results indicated that the regulatory 30‐day geometric mean fecal coliform concentration of 200 colony forming units (cfu) per 100 milliliters is exceeded approximately three times per year for a total of 30 days. Ongoing initiatives to improve wastewater facilities will reduce this to approximately once per year for 14 days. Best management practices will be necessary to reduce cattle access to streams and eliminate all exceedences. The developed model was limited by the relatively sparse flow and fecal coliform data.     

河冰对桥墩作用的冰荷载计算方法(Ⅰ)——河冰的力学性能试验

通过对松花江河冰的物理力学性能试验和松花江公路大桥桥墩的流冰动压力测量、桥面的脉动测量 ,依据国内外对冰 -结构相互作用的分析 ,提出了适合我国黑龙江冰情特点的春季流冰冰荷载的计算方法。     

A LARGE ELECTRONIC WEIGHING LYSIMETER SYSTEM: DESIGN AND INSTALLATION1

ABSTRACT: To measure crop evapotranspiration, a large double tank, electronic weighting lysimeter system was designed and installed at the Shahid Bahonar University farm, Kerman, Iran. The system was installed in a 50 m² underground building. It includes two tanks of 3.00 m in diameter and 1.75 m deep. The weighing mechanism for each tank is a set of three compression strain gage load cells, which are fixed on 1.20 m height column above the floor. According to the specification of the load cells, the maximum possible weighing error may be about 0.01 percent of total mass, which is equivalent to 0.28 mm of water, but the measured error was equal to 1 kg mass, which is equivalent to 0.14 mm of water. The load cell data from each tank and the on‐site environmental data (temperature, humidity, and wind velocity and direction) are automatically recorded and saved in a personal computer hard disk for further use and analysis.     

A GAME-THEORETIC APPROACH TO ACID RAIN ABATEMENT: CONFLICT ANALYSIS OF ENVIRONMENTAL LOAD ALLOCATION1

ABSTRACT: The detrimental impacts of acid rain have become widely publicized, but effective and equitable methods to mitigate the acid rain problem remain to be found. This paper focuses on conflicts involved in allocation of the total emission loads to be reduced to respective pollution sources of acid rain, and proposes a game-theory approach to the resolution of the conflict. With an example abstracted from a hypothetical case study in the United States of America and Canada, a systematic analysis is performed and policy implications of the results examined to assess the applicability of the proposed model.