TiO2/beads as a photocatalyst for the degradation of X3B azo dye

The feasibility of photocatalytic degradation of X3B azo dye by TiO2/beads photocatalyst was studied.The effects of parameters such as the amount of TiO2/beads,airflow ,as well as the concentrations of H2O2,Fe^3 ,Mg^2 and Na^ on the photocatalytic degradation of X3B azo dye were also studied.The results showed that 25mg/dm^3 X3B azo dye can be photocatalytically degraded completely by 30 min illumination with a 375W medium pressure mercury lamp.Adding a small amount of H2O2 or Fe^3 ,the efficiencies of photocatalytic degradation of X3B azo dye were increased rapidly.The mechanisms of the reaction and the role of the additives were also investigated.After 120 hours TiO2/beads showed no significant loss of the photocatalytic activity.     

石墨极板电氧化法处理靛蓝染料废水初步研究

采用惰性材料石墨为阳极的电氧化法处理靛蓝染料废水。研究了进水浓度、不同电解质的作用对处理效果的影响，获得了COD去除率大于90％、色度去除率大于95％的处理效果。     

膨润土吸附－絮凝法处理废水中的有机染料

研究了天然膨润土对阳离子、分散、还原、中性、活性和直接等类有机染料的吸附特性，并比较了膨润土吸附－絮凝法与单纯絮凝法处理染料水溶液的脱色效果，前者比后者的脱色率可提高４０％－２００％。使用０．０１％的膨润土加０．００５％的聚合氯化铝，可使以阳离子染料为主的印染废水脱色率达９４％－１００％。     

凹凸棒土复合净水剂处理印染废水

用活化后的凹凸棒粘土配制成复合净水剂处理印染废水，色度去除率达９３％以上，ＣＯＤ去除率达７４％，每立方米废水处理费用约０．１５元，压滤渣可用于制砖。     

Dye removal from wastewater using the adsorbent developed from sewage sludge

Introduction Adsorptionisrelevantinenvironmentalpollutionandprotectionwithreferencetowaterandwastewatertreatment(Bowen,1992).Toxicmaterials,hazardousionsanddyes fromindustrialeffluentsbythewayofadsorptionareofgreatsignificantinconnectionwithenvironmentala…     

Continuous treatment of azo acid dyes by photo-dependent denitrifying sludge

Simultaneous removals of dye and nitrate by photo-dependent denitrifying sludge(PDDS)have been demonstrated in a continuousflow bench-scale reactor.The best C/N for the degradation of azo dyes by PDDS was 1.5.The specific removal rate of azo dye AB92 decreased with a decrease in hydraulic retention time and increased with a decrease in solids retention time.The degradation rate of TOC decreased with a decrease in hydraulic retention time.AB92,which has nitro and hydroxyl substitutions in non-para positions,was uniquely degraded.During continuous flow treatment experiments using PDDS,complete degradation of azo dyes AB92 and AO20 at influent concentrations of 40mg/L and 30mg/L,respectively,was achieved with an HRT of 16.     

真菌对染料废水脱色降解的研究进展

染料属生物难降解有机物 ,染料和印染废水已成为当前最重要的水体污染源之一。本文列举了近年发现和研究的染料脱色真菌 ,并综述了真菌脱色降解染料的机理及其在染料废水处理中的应用前景     

镁盐复合混凝剂应用于活性染料印染废水脱色的实验研究

采用镁盐与亚铁盐混合复配对活性染料印染废水进行脱色处理.考察该复合混凝剂的组分配比、pH值和投加量对脱色率的影响,并与单一组分混凝剂的脱色效果作对比,同时初步分析了复合混凝剂的脱色机理.结果表明:复合混凝剂MgSO4-FeSO4·7H2O的脱色效果明显优于单一组分,表现出显著的协同效应;对于80 mg/L的活性黑KN-B印染废水(色度为1000倍),在复合混凝剂投加量为556 mg/L、pH值在10.9左右时,脱色率可以达到99.07%;主要脱色机理表现为镁盐和亚铁盐在高pH值的环境下共沉淀生成氢氧化物絮状物吸附溶液中的染料分子一起沉降.该吸附主要为电中和吸附.吸附等温线符合Langmuir方程,复合吸附剂的饱和吸附量达1.1614 g/g.     

印染行业清洁生产技术

论述了目前印染行业水污染的现状及原因，指出调整产业结构、应用新工艺、大力提倡节约用水、清沽生产将是印染行业实现可持续发展的必由之路。     

粘土颗粒吸附直接染料的分形特征

粘土颗粒对直接耐晒黑和直接大红染料的吸附均可分为快速的边缘覆盖和慢速的晶层吸附2个过程,整个吸附过程符合准-二级反应动力学方程式,除了伊利土-直接耐晒黑染料的吸附体系之外,其它体系的吸附过程中以晶层吸附为主的阶段均具有类分形特征.体系的非线性吸附等温线符合Langmuir型吸附等温模式,并且除了蒙脱土吸附直接大红染料之外,也可以用分形Langmuir吸附等温模式获得较好的模拟效果.在不同原始浓度下直接大红染料在粘土颗粒表面发生的边缘覆盖和晶层吸附这2个过程的程度是不同的,从而导致了吸附等温线在原始染料为150mg·L-1时出现最大的吸附量,而且颗粒边缘覆盖的直接大红染料的比例较高.染料进入粘土颗粒的晶层后,扩大了晶层间距,改变了其表面微孔几何结构.颗粒表面棱角变得光滑,结构疏松,片层结构逐渐减少,上述效果在蒙脱土颗粒上或直接耐晒黑染料吸附时表现地更为显著.而且吸附染料后蒙脱土颗粒对N2的吸附量比伊利土下降的幅度小,其比表面积、孔体积和平均孔径的下降比例也比伊利土小,其中平均孔径的差异比较明显.吸附染料之后粘土颗粒表面分形维数Ds均升高了,晶层膨胀和开孔作用抵消了"表面粗糙度屏蔽"、"孔阻塞效应"机理降低Ds的影响.增加了表面粗糙度.