纳米膜染料行业清洁生产试验研究

纳米膜技术用在染料有化工行业可代替原有的盐析生产工段，减少ＣＯＤ，色度，氯化钠等污染物的排放，提高物料回收率，改善产品质量。     

Some properties of a granular activated carbon-sequencing batch reactor (GAC-SBR) system for treatment of textile wastewater containing direct dyes

Resting (living) bio-sludge from a domestic wastewater treatment plant was used as an adsorbent of both direct dyes and organic matter in a sequencing batch reactor (SBR) system. The dye adsorption capacity of the bio-sludge was not increased by acclimatization with direct dyes. The adsorption of Direct Red 23 and Direct Blue 201 onto the bio-sludge was almost the same. The resting bio-sludge showed higher adsorption capacity than the autoclaved bio-sludge. The resting bio-sludge that was acclimatized with synthetic textile wastewater (STWW) without direct dyes showed the highest Direct Blue 201, COD, and BOD(5) removal capacities of 16.1+/-0.4, 453+/-7, and 293+/-9 mg/g of bio-sludge, respectively. After reuse, the dye adsorption ability of deteriorated bio-sludge was recovered by washing with 0.1% sodium dodecyl sulfate (SDS) solution. The direct dyes in the STWW were also easily removed by a GAC-SBR system. The dye removal efficiencies were higher than 80%, even when the system was operated under a high organic loading of 0.36kgBOD(5)/m(3)-d. The GAC-SBR system, however, showed a low direct dye removal efficiency of only 57+/-2.1% with raw textile wastewater (TWW) even though the system was operated with an organic loading of only 0.083kgBOD(5)/m(3)-d. The dyes, COD, BOD(5), and total kjeldalh nitrogen removal efficiencies increased up to 76.0+/-2.8%, 86.2+/-0.5%, 84.2+/-0.7%, and 68.2+/-2.1%, respectively, when 0.89 g/L glucose (organic loading of 0.17kgBOD(5)/m(3)-d) was supplemented into the TWW.     

分散染料neocron black(NB)的生物降解特性

在好氧、厌氧、好氧/厌氧交替条件下,采用活性污泥系统生物处理分散染料neocron black(NB),研究分散染料NB在需氧或者厌氧状态下的生物降解特性以及外加碳源对其生物降解特性的影响,并全波段扫描和气相色谱-质谱联用(GC-MS),初步探讨该染料的生物降解过程.结果表明,NB染料在好氧条件下降解效率最高,厌氧/好氧交替条件次之,厌氧条件下染料降解效率最低.随着NB染料浓度的增加,由于染料和中间代谢产物的抑制作用,微生物对染料的降解效率逐渐下降.添加易生物降解碳源可以促进NB染料的生物降解过程,并改变生物降解过程的动力学特征.全波段扫描和GC-MS测定结果显示,NB染料经过生物降解作用后,发色基团得到较彻底降解,NB染料生物降解中间产物有2,4-二硝基苯胺、2-氰基-4-硝基苯胺、对硝基苯胺等.     

多孔TiO_2光催化降解罗丹明B水溶液

以SiO2为模板剂,采用溶胶-凝胶-碱洗的方法制备多孔TiO2催化剂。经TEM和BET分析表明,多孔TiO2粒径约为10 nm,且颗粒大小分布均匀,其比表面积较大,约为167.572 m2/g。通过罗丹明B水溶液的光催化降解实验,考察了多孔TiO2的光催化活性。实验结果表明,初始pH=6,初始浓度30 mg/L的罗丹明...     

NAPLs污染物垂向指流迁移分形表征中图像处理的影响研究

染色示踪技术是研究多孔介质中指流形态的主要手段之一,而如何更精确地对所采集的图像数据进行分析,是该研究工作中非常重要的组成部分.分形理论在染色示踪影像的基础上对指流形态进行定量描述,以质量分形维数(D m)表征渗流面积,以界面分形维数(D s)表征渗流驱替边界长度,对于识别和预测指流形态有一定的实际意义.而分形维数的计算基于二值化图像完成,因此明确图像二值化过程对分形维数表征的影响对分形维数的应用有重要意义.本研究以4种非水相流体在二维砂箱中迁移的130幅染色图像为目标影像,详细比较了图像预处理过程中不同饱和度(红色)阈值、不同亮度(灰度)阈值以及图形中"湖"的填充3个因素分别对D m和D s的影响.结果表明,在砂箱实验中,与田间实验相比由于染色污染物与石英砂颜色对比度较大,红色阈值调整对两种分形维数影响相对较小;随着灰度阈值的提高D m平均降低0.02,D s平均增加0.05;图形中"湖"的填充对D m几乎没有影响,而使D s平均降低0.10.研究发现与D s相比,D m在图像处理过程中受各种因素影响较小,建议在进一步研究中以D m为指流形态指示指标以避免图形处理过程中主观因素的影响.     

Continuous live cell imaging of cellulose attachment by microbes under anaerobic and thermophilic conditions using confocal microscopy

Live cell imaging methods provide important insights into the dynamics of cellular processes that cannot be derived easily from population-averaged datasets.In the bioenergy field,much research is focused on fermentation of cellulosic biomass by thermophilic microbes to produce biofuels;however,little effort is dedicated to the development of imaging tools to monitor this dynamic biological process.This is,in part,due to the experimental challenges of imaging cells under both anaerobic and thermophilic conditions.Here an imaging system is described that integrates confocal microscopy,a flow cell device,and a lipophilic dye to visualize cells.Solutions to technical obstacles regarding suitable fluorescent markers,photodamage during imaging,and maintenance of environmental conditions during imaging are presented.This system was utilized to observe cellulose colonization by Clostridium thermocellum under anaerobic conditions at 60℃.This method enables live cell imaging of bacterial growth under anaerobic and thermophilic conditions and should be widely applicable to visualizing different cell types or processes in real time.     

Anthraquinone acted as a catalyst for the removal of triphenylmethane dye containing tertiary amino group: Characteristics and mechanism

Herein, we found that anthraquinone (AQ) acted as a catalyst for the rapid and effective removal of triphenylmethane dye containing tertiary amino group (TDAG). Results showed that AQ had an enhanced catalytic reactivity towards the removal of TDAG compared to hydro-quinone, which was further proved and explained using density functional theory (DFT) calculations. AQs could achieve a TDAG removal efficiency and rate of approximately 100% and 0.3583 min⁻¹, respectively, within 20 min. Quenching experiments and electron paramagnetic resonance (EPR) tests indicated that the superoxide radical (O₂^•−) generated through the catalytic reduction of an oxygen molecule (O₂) by AQ contributed to the effective removal of the TDAG. In addition, it was found that the electrophilic attack of the O₂^•− radical on the TDAG was the driving force for the dye degradation process. Decreasing the pH led to protonation of the substituted group of AG, which resulted in formation of an electron deficient center in the TDAG molecule (TDAG-EDC⁺) through delocalization of the π electron. Therefore, the possibility of the electrophilic attack for the dye by the negative O₂^•- radical was significantly enhanced. This study revealed that the H⁺ and the O₂^•− generated by the catalytic reduction of O₂ have synergistic effects that led to a significant increase in the dye removal rate and efficiency, which were higher than those obtained through persulfate oxidation.     

多针-水电极直流电晕放电染料废水脱色

采用多针-水电极反应器,研究了直流电晕放电对活性艳蓝KN-R染料废水的脱色,考察了放电电压、初始pH值和初始浓度对活性艳蓝脱色的影响,通过对液相活性物质(O3和.OH)浓度的考察探讨了脱色机理.结果表明,多针-水电极直流电晕放电对活性艳蓝脱色效果明显;放电电压、溶液初始pH值对活性艳蓝脱色效果的影响与其对液相O和.OH浓度的影响一致;.OH和O是促使RBB脱色的主要因素.     

Adsorptive features of banana (Musa paradisiaca) stalk-based activated carbon for malachite green dye removal

Chemically prepared activated carbon derived from banana stalk (BSAC) was used as an adsorbent to remove malachite green (MG) dye from aqueous solution. BSAC was characterised using thermogravimetric analyser, Brunauer Emmett Teller, Fourier transform infrared spectrometry, scanning electron microscopy, pH_pzc, elemental analysis and Boehm titration. The effectiveness of BSAC in adsorbing MG dye was studied as a function of pH, contact time, temperature, initial dye concentration and repeated desorption–adsorption processes. pH_pzc of BSAC was 4.5 and maximum dye adsorption occurred at pH 8.0. The rate of dye adsorption by BSAC was very fast initially, attaining equilibrium within 120 min following a pseudo-second-order kinetic model. Experimental data were analysed by Langmuir, Freundlich and Dubinin–Raduschevich isotherms. Equilibrium data fitted best into the Langmuir model, with a maximum adsorption capacity of 141.76 mg·g^?1. Δ G ⁰ values were negative, indicating that the process of MG dye adsorption onto BSAC was spontaneous. The positive values of Δ H ⁰ and Δ S ⁰ suggests that the process of dye adsorption was endothermic. The regeneration efficiency of spent BSAC was studied using 0.5 M HCl, and was found to be in the range of 90.22–95.16% after four cycles. This adsorbent was found to be both effective and viable for the removal of MG dye from aqueous solution.     

Photocatalytic oxidation of the textile dye basic red 18 with irradiated titanium dioxide

One of the major problems of textile wastewater is the presence of dye materials, because colour is visible to the public even if the dye concentration is lower than other pollutants, and needs therefore to be removed from the wastewater before it is discharged. Techniques based on “advanced oxidative processes” such as photocatalysed oxidation seem to be very promising for industrial wastewater treatment, especially for decolourization of textile effluents. In this work, we describe the photocatalytic degradation of the textile dye Basic Red 18 (BR 18) in aqueous solution using two different types of TiO₂ as photocatalyst: Degussa P25 (80% anatase) and Framitalia (100% anatase). Photooxidation of BR 18 was followed by HPLC analysis, and kinetic parameters were evaluated in order to optimise the treatment procedure. The results obtained in this work showed that the colour became virtually zero and the chemical oxygen demand (COD) is strongly reduced at the end of the treatment. The obtained results are compared with the efficiency of decolourization using the H₂O₂/UV System. Finally, marine mussel test was used to evaluate the efficiency of photocatalytic oxidation with TiO₂ in terms of ecotoxicity. A significant reduction of cumulative mortality was observed for the treated effluent.