全文获取类型
收费全文 | 382篇 |
免费 | 38篇 |
国内免费 | 223篇 |
专业分类
安全科学 | 23篇 |
废物处理 | 66篇 |
环保管理 | 32篇 |
综合类 | 305篇 |
基础理论 | 97篇 |
污染及防治 | 113篇 |
评价与监测 | 6篇 |
社会与环境 | 1篇 |
出版年
2023年 | 4篇 |
2022年 | 3篇 |
2021年 | 7篇 |
2020年 | 4篇 |
2019年 | 5篇 |
2018年 | 9篇 |
2017年 | 17篇 |
2016年 | 19篇 |
2015年 | 18篇 |
2014年 | 25篇 |
2013年 | 43篇 |
2012年 | 33篇 |
2011年 | 34篇 |
2010年 | 33篇 |
2009年 | 41篇 |
2008年 | 32篇 |
2007年 | 48篇 |
2006年 | 51篇 |
2005年 | 31篇 |
2004年 | 25篇 |
2003年 | 23篇 |
2002年 | 31篇 |
2001年 | 21篇 |
2000年 | 16篇 |
1999年 | 19篇 |
1998年 | 10篇 |
1997年 | 13篇 |
1996年 | 8篇 |
1995年 | 6篇 |
1994年 | 6篇 |
1993年 | 2篇 |
1991年 | 1篇 |
1990年 | 1篇 |
1988年 | 1篇 |
1987年 | 1篇 |
1983年 | 1篇 |
1981年 | 1篇 |
排序方式: 共有643条查询结果,搜索用时 99 毫秒
451.
452.
453.
内电解法处理偶氮染料废水 总被引:2,自引:0,他引:2
采用内电解法处理偶氮染料废水。正交实验结果表明,铸铁铁屑加入量对废水脱色率的影响最大,其次是酸性反应pH,再次是碱性反应pH,最后是碱性反应时间。最佳处理工艺条件为:铸铁铁屑加入量10g,酸性反应pH2.0,碱性反应pH7.0,碱性反应时间10min。此条件下脱色率达98.89%。铸铁铁屑使用6次后对废水的脱色率明显下降,将使用6次后的铸铁铁屑活化,活化后废水脱色率由86.80%提高至93.83%。 相似文献
454.
Andrade LS Ruotolo LA Rocha-Filho RC Bocchi N Biaggio SR Iniesta J García-Garcia V Montiel V 《Chemosphere》2007,66(11):2035-2043
The electrochemical performance of pure Ti–Pt/β-PbO2 electrodes, or doped with Fe and F (together or separately), in the oxidation of simulated wastewaters containing the Blue Reactive 19 dye (BR-19), using a filter-press reactor, was investigated and then compared with that of a boron-doped diamond electrode supported on a niobium substrate (Nb/BDD). The electrooxidation of the dye simulated wastewater (volume of 0.1 l, with a BR-19 initial concentration of 25 mg l−1) was carried out under the following conditions: current density of 50 mA cm−2, volume flow rate of 2.4 l h−1, temperature of 25 °C and electrode area of 5 cm2. The performances of the electrodes in the dye decolorization were quite similar, achieving 100% decolorization, and in some cases 90% decolorization was achieved by applying only ca. 0.3 A h l−1 (8 min of electrolysis). The reduction of the simulated wastewater organic load, monitored by its total organic carbon content (TOC), was greater for the Ti–Pt/β-PbO2–Fe,F electrode obtained from an electrodeposition bath containing 1 mM Fe3+ and 30 mM F−. In this case, after 2 h of electrolysis the obtained TOC reduction was 95%, while for the pure β-PbO2 and the Nb/BDD electrodes the reductions were 84% and 82%, respectively. 相似文献
455.
456.
457.
固定化工程菌对偶氮染料脱色及强化作用 总被引:1,自引:0,他引:1
利用聚亚胺酯大孔泡沫吸附固定基因工程菌Escherichia coli JM109 (pGEX-AZR),研究其对偶氮染料的脱色动力学及生物强化作用.实验表明,固定的E.coli JM109(pGEX-AZR) 对酸性大红GR的脱色动力学符合Andrews方程,动力学常数为μmax,c、Kc、Kic分别为49 .2 mg·(g·h)-1、710 .43 mg·L-1和681 .62 mg·L-1,R2为0 .995.将固定的E.coli JM109(pGEX-AZR)按10%的比例投加到厌氧序批式活性污泥反应器中连续运行32 d,含有固定化工程菌的强化体系耐浓度冲击的能力和脱色率均高于对照体系,脱色率可以稳定在90%以上.利用RISA对其微生物群落结构进行分析,E.coli JM109(pGEX-AZR)及降解酸性大红GR的优势菌群可以在污泥体系中稳定存在. 相似文献
458.
活性染料K-2BP在环境水体中的光解效应 总被引:8,自引:0,他引:8
研究了活性染料K-2BP在TiO2存在下的光催化氧化分解。结果表明,影响光解过程的主要因素是染料浓度、催化剂TiO2的用量和pH。实验条件下,染料样液脱色率可达90%以上,将该法用于实际印染废水的处理,光照6h,脱色率可达70%以上。 相似文献
459.
采用絮凝-光催化氧化工艺成功地处理了实际染料废水;研究了COD光催化降解动力学。COD和BOD5浓度分别为2169mg/L、295mg/L的染料废水,经絮凝-光催化处理后,出水COD和BOD5分别为214mg/L、18.5mg/L,去除率分别为90.1%、93.7%。向光催化体系中加入H2O2,可促进COD与BOD5的去除。该工艺可处理高浓度染料废水。 相似文献
460.