Methodological and Practical Considerations for Developing Multiproject Baselines for Electric Power and Cement Industry Projects in Central America

The Lawrence Berkeley National Laboratory (Berkeley Lab) and the Center for Sustainable Development in the Americas (CSDA) conducted technical studies and organized two training workshops to develop capacity in Central America for the evaluation of climate change projects. This paper describes the results of two baseline case studies conducted for these workshops, one for the power sector and one for the cement industry, that were devised to illustrate certain approaches to baseline setting. Multiproject baseline emission rates (BERs) for the main Guatemalan electricity grid were calculated from 2001 data. In recent years, the Guatemalan power sector has experienced rapid growth; thus, a sufficient number of new plants have been built to estimate viable BERs. We found that BERs for baseload plants offsetting additional baseload capacity ranged from 0.702 kgCO2/kWh (using a weighted average stringency) to 0.507 kgCO2/kWh (using a 10th percentile stringency), while the baseline for plants offsetting load-following capacity is lower at 0.567 kgCO2/kWh. For power displaced from existing load-following plants, the rate is higher, 0.735 kgCO2/kWh, as a result of the age of some plants used for meeting peak loads and the infrequency of their use. The approved consolidated methodology for the Clean Development Mechanism yields a single rate of 0.753 kgCO2/kWh. Due to the relatively small number of cement plants in the region and the regional nature of the cement market, all of Central America was chosen as the geographic boundary for setting cement industry BERs. Unfortunately, actual operations and output data were unobtainable for most of the plants in the region, and many data were estimated. Cement industry BERs ranged from 205 kgCO2 to 225 kgCO2 per metric ton of cement.     

流化床电偶反应器

探讨了流化床电偶反应器的工作原理 ,阐述了流化床电偶反应器的结构特点及工艺性能 ,重点介绍了该反应器对多种有机废水和重金属离子废水净化的作用。     

白腐菌氧化—混凝工艺处理纸浆漂白废水试验研究

报告用白腐真菌氧化—混凝工艺处理纸浆厂四段漂白混合废水的试验情况 ,在最佳工艺条件下 ,混凝处理出水CODCr、OD4 6 5分别为 1 85 .1mg/L、0 .0 0 4 2 ,去除率分别为 86 .5 %、99.4% ,实验结果表明 :白腐真菌氧化—混凝工艺对于纸浆漂白废水是一种有实用价值的处理工艺。     

用电絮凝法处理乳品污水的实验研究

利用电凝聚法处理乳品污水 ,通过中试设备进行条件实验得出最佳的实验条件为 :电压 :1 5 .2 V;电流 :1 1 .2 A;p H值 :7.0 ;流量 :1 0 0 /L·h- 1 ;PAM:5 ppm。CODCr去除率可达 92 %     

化学法处理含酚废水的组合工艺系统和条件研究

采用化学法组合的三种工艺系统,对含酚废水进行了工艺条件的研究。结果表明,对于浓度<30mg/l含酚废水,采用氧化凝聚处理是有效的;而对于30～80mg/l含酚废水,选用氧化凝聚和吸附组合的工艺系统处理,能使排放水中酚和COD达标。     

废旧家电产品回收性能评价指标体系的建立

针对家电产品回收工艺流程决策评价的多阶段、多目标的特点,以及不同类型家电产品和不同回收工艺过程的动态特性,采用层次分类方法建立了以经济指标和环境指标为主要内容的回收工艺流程评价指标体系,对指标体系的组成进行了较为详细的分析,讨论了应该考虑的因素及有关计算方法。以电冰箱为例,用改进的模糊层次分析法与遗传算法相结合,介绍了回收工艺流程的优化决策方法。建立的指标体系不仅可以根据评价对象进行动态修改,而且具有较强的可操作性。     

粉煤灰、硫铁矿渣制备聚铁铝硅混凝剂及应用研究

采用粉煤灰、硫铁矿渣为原料 ,设计出一条新的工艺流程制备新型无机高分子絮凝剂聚铁铝硅盐 (PAFCSi)。通过其形态分布的研究和对模拟水样的处理得到了产品的最优性能指标。对两种废水的处理结果表明产品的混凝效果明显优于市售混凝剂聚铝 (PAC)和聚铁 (PFC)。     

印刷线路板厂含铜污泥固化处理工艺研究

研究采用水泥作固化基材固化处理某印刷线路板厂酸性废水用石灰混凝所产生的含铜、锡、金的污泥 ,对固化块在不同 pH的水中重金属Cu2 +的浸出实验结果表明 :水泥固化处理该混凝污泥效果良好 ,控制合适的条件 ,可得到混合性能好、初凝时间适当、抗压强度较好的固化块。Cu2 +的浸出率低于允许浸出浓度。混凝过程中加入硫脲硅酸钠等助剂 ,可提高固化效果。研究还对几种不同配比的固化块抗压强度进行了探讨。     

染料废水处理的工艺实验研究

采用中和 -电解 -臭氧氧化工艺首先对高浓度染料生产工艺废水进行预处理 ,再与低浓度废水混合混凝、吸附处理。经电解正交实验设计及工艺实验确定本研究工艺实验为 :废水pH中性、电解条件为电解时间 2h ,电解电压10V ,电流密度 0 0 18A cm2 、O3氧化时间 2h、混凝剂 1#、3#浓度均为 2 5 0mg L、炉渣吸附时间 30min。总脱色率与CODCr总去除率均达 99% ,可以达标排放     

对硝基氯苯废气治理研究

冷却凝固法处理含对硝基氯苯废气 ,用水作冷却剂直接冷却、冷凝、凝固、凝华废气中对硝基氯苯蒸气 ,废气中的升华物、粉尘和水蒸汽同时被分离 ,处理后的废气达到很高的净化程度。在此根据实验结果 ,得到在水蒸汽存在时对硝基氯苯蒸气分压和温度之间的关系