基于纳米TiO2添加的新型航空涂料性能研究

目的解决纳米TiO_2在涂料中的团聚问题,同时实现增强涂层防腐蚀、疏水性能和耐紫外老化性能。方法以氯醚树脂为航空涂料的主要成膜物质,以经氟硅烷改性后的金红石型纳米TiO_2颗粒为主要吸光剂和疏水剂,配合其他合适填料和颜料制备一种新型航空涂料,通过拉拔法、硬度测试法、电化学极化曲线法、接触角测试法和人工紫外加速老化等测试手段分别对涂层的力学性能、电化学性能、疏水性能和耐紫外老化性能进行研究。结果改性后的金红石型纳米TiO_2颗粒的分散性及与氯醚树脂的相容性得到改善。当添加量为2%~3%时,涂层腐蚀防护性能、表面疏水性、耐紫外老化性能达到最佳,附着力、硬度等力学性能达到航空涂料的基本使用要求。结论该涂料有效地解决了纳米TiO_2在涂料中的团聚问题,提高了涂层的防腐蚀、疏水性能和耐紫外老化性能。     

环氧树脂降解嗜盐菌的筛选及其处理高盐环氧树脂废水的特性研究

从环氧树脂废水生化处理系统的活性污泥中分离筛选得到2株嗜盐菌,并对其进行分子生物学鉴定,考察了生长和降解特性.结果表明,通过菌株的形态观察及16S rDNA序列比对分析,菌株J1归属于芽孢杆菌属(Bacillus sp.),菌株J2属于枝芽孢杆菌属(Virgibacillus sp.).菌株J1和J2在高盐CM培养基中的适宜生长条件为:温度30℃,pH为7.0,NaCl的浓度范围为5～50 g.L-1.对环氧树脂废水中有机物的最佳降解条件为:温度30℃,pH为7.0,NaCl浓度30 g.L-1.将菌悬液J1和J2按2∶1的体积比例混合后,在复合菌种的接入量为10%时,对环氧树脂废水中COD的去除率最高.     

氯醇化法环氧丙烷生产中的循环经济探索

从传统的氯醇化法环氧丙烷生产工艺和存在的环保问题入手,结合国内外对环氧丙烷循环经济和清洁生产新技术的研究,对循环经济的新技术进行清洁性分析,提出该技术可以从源头削减污染物产量,提高物料的循环利用率、水的综合利用率,符合清洁生产原则。     

Using thermal analysis with kinetic calculation method to assess the thermal stability of azo compound on construction materials

The application of construction polymers in engineering and alternative materials has always occupied a place in the market. In the production process of polymer resins, initiators can be used to lower the polymerization reaction energy threshold, which can improve reaction efficiency and reduce energy loss. However, as a commonly used energetic substance in the polymerization process, azos have caused related process hazards due to their exothermic characteristics. Because of this, it is essential to examine and analyze the thermal hazard characteristics of emerging azo substances, such as 2-cyanopropan-2-imemicarbazide (CABN). Although previous literature performs the calculation on related thermal hazard parameters of CABN, there is still exists a void for discussion in estimating the reaction model to avoid analogous hazards and enhance the existing thermal analysis. Based on the past literature, the reaction model is improved with thermogravimetric analysis as evidence. The revised thermal hazard parameters are calculated as the basis of control and mitigation measures, the kinetic model is used to estimate the modified safety parameters, and in the judgment of the runaway reaction, the critical temperature of the runaway is found by analyzing the influence of slight changes in ambient temperature on the reaction temperature. The results show that the critical temperature that causes CABN to enter the runaway reaction is delayed, and the hazard is lower than in the storage situation. Therefore, the thermal hazard to CABN mainly focuses on the safety environment and measures during storage.     

电增强环氧树脂基聚合物膜萃取水样中的硝基苯

以环氧树脂基聚合物膜为萃取相,在电场作用下富集目标物,与高效液相色谱(HPLC)联用,应用于环境水样中硝基苯污染物的测定.考察了电压大小、萃取时间、洗脱时间、离子强度和溶液pH值对电增强萃取效率的影响.实验结果表明,环氧树脂基聚合物膜的萃取量与膜上所施加的控制电位相关,阴极极化时,膜对硝基苯的萃取量增大;在阳极极化时,膜萃取量减小.在电压为-0.3kV,硝基苯溶液pH=4的条件下,萃取20min,得到该方法的检出限为0.015μg·mL-1,在0.05～3.0μg·mL-1范围内具有良好的线性关系,可决系数为0.9929,变异系数小于5%.用上述方法分析鱼塘水,硝基苯3种不同加标水平的回收率为79.8%～108.2%.结果表明,该方法既可用于环境水样品中的硝基苯去除又可用于检测.     

Selection of magnetic anion exchange resins for the removal of dissolved organic and inorganic matters

Four magnetic anion exchange resins (MAERs) were used as adsorbents to purify drinking water. The effect of water quality (pH, temperature, ionic strength, etc.) on the performance of MAER for the removal of dissolved organic matter (DOM) was also investigated. Among the four studied MAERs, the strong base resin named NDMP-1 with high water content and enhanced exchange capacity exhibited the highest removal rate of dissolved organic carbon (DOC) (48.9% removal rate) and UV-absorbing substances (82.4% removal rate) with a resin dose of 10 mL/L after 30 min of contact time. The MAERs could also effectively remove inorganic matter such as sulfate, nitrate and fluoride. Because of the higher specific UV absorbance (SUVA) value, the DOM in the raw water was found to be removed more effectively than that in the clarified water by NDMP resin. The temperature showed a weak influence on the removal of DOC from 6 to 26℃, while a relatively strong one at 36℃. The removal of DOM by NDMP was also affected to some extent by the pH value. Moreover, increasing the sulfate concentration in the raw water could decrease the removal rates of DOC and UV-absorbing substances.     

Optimization of biodiesel production from waste cooking oil using ion-exchange resins

Waste cooking oil is a potential substitution of refined vegetable oil for the production of biodiesel due to the low cost of raw material and for solving their disposal problem. In this study, optimization of esterification process of free fatty acids in artificially acidified soybean oil with oleic acid has been carried out using methanol as an agent and ion exchange resin as a heterogeneous catalyst. The esterification reaction has been investigated based on the mass balance of the developed model. The model has been validated against experimental data and effects of temperature and catalyst weight have been analyzed. Thereafter, optimization process has been fulfilled for two different objective functions as conversion of acid oil and benefit. Optimization results indicated that the maximum conversion of acid is 95.95%, which is achievable at 4.48-g catalyst loading and reaction temperature of 120°C. Maximum benefit was obtained as US$0.057 per batch of reaction at a catalyst amount of 1 g and temperature of 120°C.     

离子交换树脂对高浓度氨氮废水的吸附研究

采用D707、D708两种不同类型的离子交换树脂对高浓度氨氮废水进行吸附处理研究,分析了不同的吸附条件及等温吸附模型对吸附效果的影响.静态吸附实验表明:NH+4的吸附率随树脂投加量的增大而增加,在非碱性条件下树脂对NH+4的吸附率随p H的升高而增加;恒速振荡时间达到90 min以上时两种树脂可吸附平衡,当p H为7时,D707、D708树脂对NH+4的吸附容量分别达到196.1、217.4 mg·g-1;D707、D708树脂对NH+4的吸附属吸热过程,随温度的升高树脂对NH+4的吸附率逐渐增大,在298 K温度下D707、D708树脂吸附NH+4的表观吸附活化能Ea分别为54.67和34.46 k J·mol-1,吸附过程为液膜扩散主控制;树脂对NH+4吸附符合Langmuir吸附等温式;使用2 mol·L-1H2SO4对树脂进行解吸,脱附率达到98%以上,重复实验3次吸附率基本不变.     

废弃印刷线路板中环氧树脂的资源化技术

印刷线路板是电子工业的基础,伴随着电子废弃物的快速增长,废弃印刷线路板的回收已经成为迫切需要研究的领域。对废弃印刷线路板中环氧树脂常用的资源化方法、物理法、热解法、超临界法及化学溶剂法等进行了介绍,并比较了几种方法的优缺点。     

处理环氧氯丙烷废水工程实践

采用调节-中和-沉淀-稀释的预处理,好氧水解-接触氧化生物法处理环氧氯丙烷高含盐生产废水,实际调试运行情况表明,稀释后控制生化池Cl-浓度4~6g/L,环氧氯丙烷废水处理能够达到出水COD≤300mg/L、PH 6~9、SS≤200mg/L的排放标准。