AN OVERVIEW OF POROUS PAVEMENT RESEARCH1

ABSTRACT: This paper discusses the economics, advantages, potential applications, and status and future research needs of porous pavements. Porous pavements are an available storm water management technique which can be used on parking lots and low volume roadways in order to reduce both storm water runoff volume and pollution. In addition, ground water recharge is enhanced. Also, cost reductions result due to elimination of curbs, drains, and small sized storm sewers. Porous asphalt pavements consist of a relatively thin course of open graded asphalt mix over a deep base of large size crushed stones. Water can be stored in the crushed stone base until it can percolate into the subbase or drain laterally. Other porous pavement types include concrete lattice blocks and a porous concrete mix.     

AN EVALUATION OF PRECIPITATION GAGE DENSITY IN A MOUNTAINOUS TERRAIN1

ABSTRACT: Inter-station analysis was employed to evaluate the adequacy of the precipitation network in topographically complex West Virginia. A 25-year period was determined as the minimum lingth of record needed for relatively stable and fairly accurate estimates of long-term (50-year) precipitation and in frequency analysis. Data from the 83 National Weather Service stations with 25-year records were adjusted for consistency and evaluated separately by zones east (31 stations) and west (52 stations) of the Appalachian divide. Correlation coefficients (r) and average standard errors of estimate were computed for all station pairs within 50 miles distance and 1000 feet elevation difference of each other. The third polynomial equation of inter-station distance eliminated using elevation and land slope as the criteria in network design in this mountainous terrain. A network with (r) = 0.9 estimates annual precipitation with accuracy as great as 5 percent, but requires about 250 additional gages (i.e., about 200 percent of the present density).     

PREDICTING INSTANTANEOUS PEAK DEMAND IN RURAL DOMESTIC WATER SUPPLY SYSTEMS1

ABSTRACT: Many rural areas of the United States still have no public domestic water systems. Typical land use patterns in these areas may require 1/2 mile or more of pipe per farm connection. Public systems serving these areas are economically feasible only if realistic short-term peak demand standards are available for their design. The lack of reliable data upon which to establish such criteria has resulted in a large variation in criteria among state and federal agencies involved in financing and in approving construction of these systems. During the summer of 1975 three distribution laterals of a rural system in Utah were master metered and instantaneous peak flows were recorded for 4 months. The metered lines served 4, 12, and 22 farm houses each. The frequency distribution of peak flows has been analyzed and compared with that developed during similar research in Mississippi and with the existing design standards of the Farmers Home Administration and the State of Utah.     

RELIABILITY OF THE DESIGN STORM CONCEPT IN EVALUATING RUNOFF PEAK FLOW1

A comparative study was undertaken to evaluate peak runoff flow rates using (1) a continuous series of actual rainfall events and (2) design storms. The ILLUDAS computer model was used to simulate runoff over a catchment within the city of Montreal, Canada. A ten-year period, five-minute increment rainfall data base was used to derive peak flow frequency curves. Two types of design storms were analyzed: one derived from intensity duration frequency curves (Chicago type), the other from averaging actual rainfall patterns (Huff type). Antecedent soil moisture conditions were considered in the analyses. It was found that the probability distribution of runoff peak flow was sensitive to the choice of design storm pattern and to the antecedent soil moisture condition. A symmetrical, Chicago-type design storm with antecedent dry soil moisture produced a flow frequency curve similar to the one obtained from a series of historical rainfall events.     

DESIGN CONSIDERATIONS FOR AMBIENT STREAM QUALITY MONITORING1

ABSTRACT: Existing ambient water quality monitoring programs have resulted in data which are often unsuitable for assessment of water quality trends. A primary concern in designing a stream quality monitoring network is the selection of a temporal sampling strategy. It is extremely important that data for trend assessment be collected uniformly in time. Greatly superior trend detection power results for such a strategy as compared to stratified sampling strategies. In general, it is desirable that sampling frequencies be at least monthly but not greater than biweekly; higher sampling frequencies usually result in little additional information. An upper limit on trend detectability exists such that for both five and ten year base periods it is often impossible to detect trends in time series where the ratio of the trend magnitude to time series standard deviation is less than about 0.5. For the same record lengths trends in records with trend to standard deviation ratios greater than about one can usually be detected with very high power when a uniform sampling strategy is followed.     

INTERACTIVE COMPUTER-AIDED HYDRAULIC DESIGN: CULVERTS1

ABSTRACT: Regular use of interactive computer programs in hydraulic design can materially increase the productivity of designers without sacrificing accuracy. This article considers the hydraulic design of culverts by interactive use of a computer program; this approach most profitably combines the speed and accuracy of the computer with the experience of the designer.     

WATER TREATMENT PLANT STAGING POLICY1

Economics of treatment plant staging or capacity expansions is governed by the initial water demand rate, Q₀; the anticipated demand growth rate, G; the discount rate, D; the cost of operation, maintenance, and repair (OMR); the useful plant life, T, as a function of the quality of design, construction, and OMR; the treatment plant load factor, L_f; the salvage value of the plant at the end of the project period; the efficiency of the plant-staging design, eta; and the length of the project period, T_s. Various staging policies are investigated to find an optimal policy. The desirability of adopting a staging policy is governed by the magnitude of percent savings that can be achieved by adopting this policy instead of a no-staging policy. A detailed analysis of the problem shows that the percent savings because of staging increase with an increase in Q, G, D, T, and eta;. A reduction in the plant load factor increases the total costs. Information about the effect of variation in the parameters should help the planner and designer to work out an economical schedule of treatment plant capacity expansions.     

MIXING INDUCED BY AN INTERNAL HYDRAULIC JUMP1

ABSTRACT The efficiency of an inverted internal hydraulic jump as a mixing and dispersion mechanism in an aquatic environment was examined. The flow considered was a two-dimensional buoyant flow from a shallow channel over a sloping bottom into a deep reservoir. It could be seen that a rapidly varied flow associated with violent turbulent mixing occurred near the point of discharge if specific discharge conditions and downstream controls were met. Downstream from the mixing zone the flow was stably stratified. The main object of the study was to find the conditions under which a turbulent mixing zone occurred and the rate of turbulent entrainment. Energy loss and length of the mixing zone were also investigated. The independent variables were the outlet densimetric Froude number, the density differential between outfall water and receiving water, the relative depths of the upper and lower layers in the stratified flow portion, the total depth, and the slope of the transition. Theoretical calculations had to be confined to a step increase in depth, but experiments in a laboratory flume showed that results obtained with slopes of 23° and 90° were quite similar. Both theory and experiments showed, for example, that dilution (entrainment rates) up to 2:1 (2 parts heated water to one part cold water) can be achieved at very little energy expense and with downstream depths approximately 8 times the outlet depth. Theoretically, any amount of dilution can be obtained, but large depths may be required. Experimental results also indicate that the length of the mixing zone was frequently ten times the value of the outlet densimetric Froude number.     

设计火灾时火灾热释放速率曲线的确定

在运用火灾计算机模型进行建筑物性能化消防设计与评估时,确定合理、切合实际的火灾的热释放速率曲线非常重要。基于当前国内外的研究现状,本文提出了几种符合当前技术水平且实用的确定火灾热释放速率曲线的方法,对于每种分析计算方法及其适用条件进行了详细阐述,并给出了相关的计算实例。     

非公路车辆翻车安全保护技术的研究

在我国农业、矿山、建筑、水利等行业中 ,非公路车辆保有量上千万台 ,使用者上亿人 ,由于车辆技术性能和操作使用水平参差不齐 ,非公路车辆作业工况恶劣 ,特别是车辆在承载时 ,重心上移 ,整车稳定性下降 ,加上车辆在边坡作业时 ,可能出现车辆翻滚现象 ,造成人员伤亡。笔者列举并分析了瑞典、德国、美国和中国等国家的非公路车辆翻车的人员伤亡统计数据 ;指出通过建立相应的保护法规 ,增设车辆翻车安全保护装置 (ROPS) ,一定程度上保护了工作人员安全 ;同时强调我国农业及工程车辆采用翻车保护装置的必要性 ,并给出了ROPS的设计选用原则。