H酸综合废水治理工艺试验研究及工程应用

针对H酸母液及T酸一次洗水高含盐量有机废水进行系统的实验研究，结果表明：废水经冷却、结晶、过滤后，用铁屑过滤，石灰乳、PAM处理．使废水COD去除率为50％，脱色率为7O％，BOD／CODcr提高到0．2以上，预期COD去除率达60％以上，BOD去除率达85％以上，NH3—N去除率达80％以上．     

轴承生产废水处理工艺的选择与实践

采用絮凝气浮 过滤工艺处理轴承生产废水。工程实践表明,该工艺处理效果稳定、耐冲击负荷、工艺组合合理。预处理后的废水经气浮 过滤工艺处理后,COD、SS、油的去除率分别为80.62%～84.31%、81.00%～84.39%、89.37%～96.45%,出水完全能达到排放标准。     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

微絮凝双层滤料过滤处理含油废水试验研究

针对机电和机械加工行业排水中含油废水的特性 ,提出了微絮凝双层滤料过滤法处理工艺。通过实验 ,肯定了其良好的除油效果 ,并对影响除油率的因素进行了分析讨论 ,确定了处理工艺流程及合理的设计参数     

污水处理厂污泥脱水滤液循环利用的研究

对污水处理厂污泥机械脱水滤液进行了循环利用研究。将滤液与剩余污泥（mlsss≤13000mg／l）按1比4的比例均匀混合。然后加入到沉淀器中进行重力浓缩试验，结果表明：它能够改善污泥的浓缩脱水性能，加快污泥的沉淀速度，增大浓缩污泥的浓度；生产运行数据分析显示：污泥脱水滤液与剩余污泥混合液进入浓缩池后，上清液更加清澈，污泥的固体负荷率显著提高，这既可降低污泥的处理成本，亦可减少污泥处理系统的基建投资，为污泥处理系统的工艺优化开辟了新途径。     

Sex‐specific and dose‐response relationships of urinary cobalt and molybdenum levels with glucose levels and insulin resistance in U.S. adults

Growing studies have linked metal exposure to diabetes risk. However, these studies had inconsistent results. We used a multiple linear regression model to investigate the sex-specific and dose-response associations between urinary metals (cobalt (Co) and molybdenum (Mo)) and diabetes-related indicators (fasting plasma glucose (FPG), hemoglobin A1c (HbA1c), homeostasis model assessment for insulin resistance (HOMA-IR), and insulin) in a cross-sectional study based on the United States National Health and Nutrition Examination Survey. The urinary metal concentrations of 1423 eligible individuals were stratified on the basis of the quartile distribution. Our results showed that the urinary Co level in males at the fourth quartile (Q4) was strongly correlated with increased FPG (β = 0.61, 95% CI: 0.17–1.04), HbA1c (β = 0.31, 95% CI: 0.09–0.54), insulin (β = 8.18, 95% CI: 2.84–13.52), and HOMA–IR (β = 3.42, 95% CI: 1.40–5.44) when compared with first quartile (Q1). High urinary Mo levels (Q4 vs. Q1) were associated with elevated FPG (β = 0.46, 95% CI: 0.17–0.75) and HbA1c (β = 0.27, 95% CI: 0.11–0.42) in the overall population. Positive linear dose-response associations were observed between urinary Co and insulin (P_nonlinear = 0.513) and HOMA–IR (P_nonlinear = 0.736) in males, as well as a positive linear dose-response relationship between urinary Mo and FPG (P_nonlinear = 0.826) and HbA1c (P_nonlinear = 0.376) in the overall population. Significant sex-specific and dose-response relationships were observed between urinary metals (Co and Mo) and diabetes-related indicators, and the potential mechanisms should be further investigated.     

Acid resistance of methanogenic bacteria in a two-stage anaerobic process treating high concentration methanol Wastewater

In this study, the two-stage upflow anaerobic sludge blanket (UASB) system and batch experiments were employed to evaluate the performance of anaerobic digestion for the treatment of high concentration methanol wastewater. The acid resistance of granular sludge and methanogenic bacteria and their metabolizing activity were investigated. The results show that the pH of the first UASB changed from 4.9 to 5.8 and 5.5 to 6.2 for the second reactor. Apparently, these were not the advisable pH levels that common methanogenic bacteria could accept. The methanogenic bacteria of the system, viz. Methanosarcina barkeri, had some acid resistance and could still degrade methanol at pH 5.0. If the methanogenic bacteria were trained further, their acid resistance would be improved somewhat. Granular sludge of the system could protect the methanogenic bacteria within its body against the impact of the acidic environment and make them degrade methanol at pH 4.5. The performance of granular sludge was attributed to its structure, bacteria species, and the distribution of bacterium inside the granule. Translated from Acta Scientiae Circumstantiae, 2004, 24(4): 633–636 [译自: 环境科学学报]     

纺织工业空调废水处理回用的试验研究

纺织工业空调排水占整个纺织生产过程排水量的９０％。通过多种方法试验比较，发现用锅炉炉渣过滤处理，出水水质可达到印染用水水质要求。     

低温高铁锰氨氮地下水两级生物净化快速启动

为了实现东北地区低温（5~6℃）高铁、锰、氨氮（TFe：9~15mg/L，Fe²⁺：6~12mg/L，NH₃-N：1.4~2.0mg/L，Mn²⁺：1.4~2.0mg/L）地下水的净化及解决同层净化中运行稳定性差、出水锰超标的问题，在水厂净化车间开展“两级曝气+两级过滤”工艺启动研究，采用差滤速和同滤速2种启动方式分别启动两级生物净化工艺.结果表明，2种启动方式分别在106，59d启动成功.同滤速启动可以有效的缩短两级生物净化的启动时间，铁、锰、氨氮去除负荷可达110.69，18.80，19.54g/（m²·h），沿程分析发现，铁在一级滤柱的60cm处即被去除至痕量；85.08%的氨氮在一级滤柱中去除，沿程各段去除均匀，14.92%的氨氮在二级滤柱中去除；锰的去除率和氧化活性去除区位受滤速及进水氨氮浓度影响较大，33.72%的锰在一级滤柱中去除，66.28%的锰在二级滤柱中去除，锰的去除仍然是滤池成熟的决定性因素.     

炼油污水回用方案初探

针对污水处理场改造后的水质情况，结合现有闲置设备的状况，提出一套既符合现场实际又有针对性的污水回用处理方案。