Performance of a novel vertical-flow settler: a comparative study

By increasing particle concentration and G value （root-mean-square velocity gradient） to enhance flocculation, a novel vertical-flow settler was designed to increase sedimentation effectiveness, and to simultaneously improve operational stabilization. Due to the gradual decrease in upward flow-rate of raw water, a floes blanket would form and suspend in the middle section of the settler, not at the bottom as in a conventional clarifier. Enough large floes, resulted from flocculation or fltration, would continuously settle out of the floes blanket, and simultaneously, the floes in raw water or those forming above the blanket would ceaselessly enter the floes blanket. As a result, the floes concentration in the blanket could keep a dynamic balance. The hydrodynamic shear in the blanket was improved by flow separation, which was induced by the abrupt change in flow channel. Due to the floes blanket and improved hydrodynamic shear, flocculation would be enhanced, which was helpful for removing fine particles in raw water. A comparative study showed that the novel vertical-flow settler had a much better performance in the removal of the particles in raw water than a conventional one, when they treated kaolin suspensions of different concentrations （500, 100 and 50 mg/L, respectively） coagulated by polyaluminum chloride（PAC1） at the up-flow rates of 1 and 2 mm/s, respectively.     

基于疲劳累积破坏机制的储罐结构动力可靠度分析

针对随机风载荷作用下储罐结构动力可靠性问题,以300 m3的中小型立式低温储罐为研究对象,利用AR模型进行数值模拟得到风载荷的脉动风速时程与脉动功率谱密度函数。采用ANSYS建立储罐三维有限元模型,并对储罐进行动力学分析,计算出储罐结构的随机响应,进而求出随机风载荷作用下储罐结构动力可靠性所需全部数字特征,最后利用疲劳累积损伤机制计算得到储罐的动力可靠度。结果表明:假设结构强度不随时间退化,前5 a动力可靠度基本保持不变,随着使用年限的延长,动力可靠度下降速度明显增大。研究方法可为储罐的动力可靠性及寿命预测提供一定的理论依据。     

Study on the dynamic response of polyurea coated steel tank subjected to blast loadings

Steel tanks are widely used in the storage of various chemical liquids, and the blast resistance of the tanks is very important because of the explosiveness of these liquids. To explore a feasible method to improve the blast resistance of steel tanks, the effect of polyurea coating on the blast resistance of steel storage tank is investigated in this paper. The responses of monolithic steel tanks and polyurea coated tanks under blast loads are studied by field blast experiments using TNT explosive, and the results shows that the polyurea layers are effective in reducing the maximum and residual displacements of the tank. Numerical simulations are performed and validated, and the deformation process and stress and strain distribution of the tanks are analyzed accordingly. The increase on the bending moment of the plastic hinge lines of the tanks and the increase of the area density of the cylindrical shell induced by the polyurea layers are believed to be the two main factors contributing to the displacement reduction effect of polyurea in this paper. The validated numerical model is used to study the influence of polyurea layer's thickness on the deflection of the tank, and a nearly inversely proportional relationship between the thickness and the maximum displacement is found. Three deformation modes of the tanks are identified when subjected to blast load with varying intensity and it is found that the displacement reduction effect of polyurea varies in different deformation modes.     

用次氯酸钠法处理选矿废水

采用次氯酸钠法处理铅锌硫化矿选矿废水,考察了废水初始pH、NaClO加入量及反应时间对选矿废水COD去除率的影响。在废水pH为4、NaClO加入量为100g/L、反应时间为30min的条件下,选矿废水的COD去除率可达到98．3％;当pH为11、反应时间为10min、NaClO加入量为1g/L时,选矿废水的COD去除率为39．4％。     

用环己烷氧化副产物制备浮选剂

在固体酸催化剂作用下,用环己烷氧化制备环己酮的副产物——酸性油和轻质油进行酯化反应,制备了羧酸混合酯,酯化反应的最佳工艺条件：n（C4-C5醇）：n（有机羧酸）=1．2：1,催化剂质量分数为1．5％,反应温度为110-160℃,反应时间为5h。经应用评价结果表明,该羧酸混合酯是一种性能优异的选煤浮选剂。     

生物浮选法处理含油污泥

利用从石油污染物中分离的一组微生物菌株对胜利油田含油污泥进行了生物浮选处理,探讨了处理过程中温度、稀释率、投加菌量及加糖量等因子对油去除率的影响及组合菌株与单一菌株处理效果的差异。通过实验获得生物浮选最佳运行参数为:温度40℃,稀释率98%,加菌量3.75%,加糖量0.25%,在该参数运行条件下,原油去除率可达95%以上。使用混合菌株进行生物浮选有利于回收原油中含油量的提高。     

蜡防印花生产废水处理工程扩改设计

对蜡防印花生产废水处理工程进行扩改设计,实际结果表明:机械洗蜡废水分流后经双级气浮处理,蜡回收率和处理水回用率可达90%以上;皂化脱蜡废水分流后采用酸化-气浮处理,蜡回收率可达95%以上,出水与印花水洗废水经微电解脱色,脱色率可达85%以上;混合废水经混凝气浮-生物接触氧化-沉淀-过滤组合工艺处理,出水达标排放。该处理工艺效率高,效果稳定,经济效益和环境效益高。     

钙法提钒尾渣的浮选脱硫试验

根据钙法提钒尾渣的矿物特性,采用浮选法分离其中的石膏以实现脱硫,分别考察了矿浆pH、矿浆液固比、捕收剂添加量及浮选中水循环次数等因素对浮选指标的影响,并进行了理论分析,确定了钙法提钒尾渣浮选脱硫的优选工艺参数.试验结果表明,在矿浆pH为7、矿浆液固比为5:1、捕收剂添加量为0.6～0.8 kg/t的条件下,可获得w(S...     

合流制排水系统溢流污染就地调蓄处理控制技术研究

在对高效混合絮凝斜板沉淀工艺进行现场中试的基础上,将化学强化处理工艺与调蓄池相结合,针对上海市某合流制排水系统,进行调蓄/沉淀池的概念设计,提出主要设计参数,利用计算流体力学(CFD)模型对调蓄/沉淀池进行优化设计.试验和模拟结果表明,调蓄/沉淀池与单纯的调蓄池相比具有更好的溢流污染控制效果和效益/造价比.     

城市污水处理厂二沉池出水曝气混合絮凝的研究

在污水处理厂实验室,对二沉池出口污水进行了曝气和机械2种方式的混合絮凝对比试验。研究结果表明,对于同一水质,在相同的投药量下,曝气混凝沉淀后的水质明显优于机械混凝沉淀后的水质,各项水质指标的去除率分别提高：BOD₅ 6%～9%,COD 4%～6%,NH₃-N 6%～9%,TP 15%～24%,SS 8%～18%。