蜡防印花生产废水处理工程扩改设计

对蜡防印花生产废水处理工程进行扩改设计,实际结果表明:机械洗蜡废水分流后经双级气浮处理,蜡回收率和处理水回用率可达90%以上;皂化脱蜡废水分流后采用酸化-气浮处理,蜡回收率可达95%以上,出水与印花水洗废水经微电解脱色,脱色率可达85%以上;混合废水经混凝气浮-生物接触氧化-沉淀-过滤组合工艺处理,出水达标排放。该处理工艺效率高,效果稳定,经济效益和环境效益高。     

Performance of a novel vertical-flow settler: a comparative study

By increasing particle concentration and G value （root-mean-square velocity gradient） to enhance flocculation, a novel vertical-flow settler was designed to increase sedimentation effectiveness, and to simultaneously improve operational stabilization. Due to the gradual decrease in upward flow-rate of raw water, a floes blanket would form and suspend in the middle section of the settler, not at the bottom as in a conventional clarifier. Enough large floes, resulted from flocculation or fltration, would continuously settle out of the floes blanket, and simultaneously, the floes in raw water or those forming above the blanket would ceaselessly enter the floes blanket. As a result, the floes concentration in the blanket could keep a dynamic balance. The hydrodynamic shear in the blanket was improved by flow separation, which was induced by the abrupt change in flow channel. Due to the floes blanket and improved hydrodynamic shear, flocculation would be enhanced, which was helpful for removing fine particles in raw water. A comparative study showed that the novel vertical-flow settler had a much better performance in the removal of the particles in raw water than a conventional one, when they treated kaolin suspensions of different concentrations （500, 100 and 50 mg/L, respectively） coagulated by polyaluminum chloride（PAC1） at the up-flow rates of 1 and 2 mm/s, respectively.     

基于疲劳累积破坏机制的储罐结构动力可靠度分析

针对随机风载荷作用下储罐结构动力可靠性问题,以300 m3的中小型立式低温储罐为研究对象,利用AR模型进行数值模拟得到风载荷的脉动风速时程与脉动功率谱密度函数。采用ANSYS建立储罐三维有限元模型,并对储罐进行动力学分析,计算出储罐结构的随机响应,进而求出随机风载荷作用下储罐结构动力可靠性所需全部数字特征,最后利用疲劳累积损伤机制计算得到储罐的动力可靠度。结果表明:假设结构强度不随时间退化,前5 a动力可靠度基本保持不变,随着使用年限的延长,动力可靠度下降速度明显增大。研究方法可为储罐的动力可靠性及寿命预测提供一定的理论依据。     

Study on the dynamic response of polyurea coated steel tank subjected to blast loadings

Steel tanks are widely used in the storage of various chemical liquids, and the blast resistance of the tanks is very important because of the explosiveness of these liquids. To explore a feasible method to improve the blast resistance of steel tanks, the effect of polyurea coating on the blast resistance of steel storage tank is investigated in this paper. The responses of monolithic steel tanks and polyurea coated tanks under blast loads are studied by field blast experiments using TNT explosive, and the results shows that the polyurea layers are effective in reducing the maximum and residual displacements of the tank. Numerical simulations are performed and validated, and the deformation process and stress and strain distribution of the tanks are analyzed accordingly. The increase on the bending moment of the plastic hinge lines of the tanks and the increase of the area density of the cylindrical shell induced by the polyurea layers are believed to be the two main factors contributing to the displacement reduction effect of polyurea in this paper. The validated numerical model is used to study the influence of polyurea layer's thickness on the deflection of the tank, and a nearly inversely proportional relationship between the thickness and the maximum displacement is found. Three deformation modes of the tanks are identified when subjected to blast load with varying intensity and it is found that the displacement reduction effect of polyurea varies in different deformation modes.     

连续流反应器中培养好氧颗粒污泥的运行效能研究

在连续流完全混合反应器(CSTR)中,采用不同进水方式,以乙酸钠作为碳源配制的人工配水作为原水,对好氧颗粒污泥的运行效能进行了试验研究。研究表明,采用不同进水方式运行的2个反应器在颗粒污泥出现后,运行效能差别不大;好氧颗粒污泥反应器运行高效稳定,在水力停留时间为1.5h、COD容积负荷为1.0kg/(m3·d)的条件下,对COD、TP、NH4+-N和TN的去除率分别为90%、85%、95%和60%,并具有明显的脱氮除磷效果;反应器中存在同步硝化反硝化现象。     

罐底含油泥热解动力学参数计算方法的优选

在化学反应设计中反应动力学是较重要的因素。为得到更合理的污泥热解动力学参数计算方法,利用热重分析仪,在氮气气氛下对罐底含油污泥的热解特性进行研究。根据热重实验数据,分别采用Coats-Redfern法、Kissinger法、FWO法和Popescu法计算污泥热解动力学参数,并获取罐底泥热解制油的主要阶段(第2阶段)的反应活化能E、频率因子A并分析各种方法反应机理。通过对比不同计算方法得到动力学参数及拟合曲线与实验曲线的相关性,确定了最佳罐底含油污泥热解动力学参数计算方法。研究表明,Popescu法得到罐底泥的热解过程符合Jander方程,活化能E为101.43 kJ/mol,与FWO法得到的91.20 kJ/mol相近,且预测曲线与实验曲线有较好的相关性(0.9816),说明Popescu法计算罐底泥热解动力学参数更合适。     

基于底泥再悬浮试验的太湖水质模拟

为探索浅水湖泊水动力扰动作用对底泥再悬浮影响的规律,在室内矩形水槽内模拟了各种水动力条件下太湖底泥的起动规律,得到了太湖底泥在3种不同起动标准下的起动流速,通过考察上覆水中悬浮物浓度的变化,建立了底泥沉积物再悬浮通量与水体流速的定量化关系。结果表明:太湖底泥在个别动、少量动、普遍动3种标准下的起动流速分别为15、30和40 cm/s,且底泥沉积物再悬浮通量与流速呈现线性正相关关系,再悬浮通量随流速增大而增大,且相关性较好。将该试验结果应用于太湖的水量水质数学模型中,并和太湖实测资料进行了对比,取得了比较满意的效果。该模拟装置能够在室内可控条件下较好地反映太湖沉积物再悬浮特征,对太湖的富营养化治理具有重要意义。     

混凝一气浮控制三卤甲烷生成势的研究

研究了混凝一气浮工艺对不同分子量区间三卤甲烷生成势（trihalomethanes formation potential,THMFP）的去除效果及絮体形态对THMFP去除效果的影响。结果表明,混凝一气浮工艺以去除大分子量区间THMFP为主,对小分子量区间THMFP的去除效果较差。UV254值与THMFP值的线性相关系数为0．9449,UV254值可以较好地反映THMFP的含量。絮体的分形维数为1．17～1．2时,孔隙率较大,可增加絮体对THMFP的活性吸附空间,且絮体相对密度较小,可增强同向絮凝作用,增加絮体和THMFP的接触概率,有利于气浮对THMFP的去除。     

含泥钾矿浮选分离技术研究

从钾矿性质和浮选技术2个方面对盐湖含泥钾矿进行资源化利用研究,首先运用X射线荧光光谱、X射线衍射和扫描电镜对含泥钾矿的矿泥化学组成及其结构特征进行了分析,其次选用盐酸十八胺和煤油为浮选药剂,对浮选法脱除钾矿中泥进行了研究.结果表明,盐湖矿泥中70%以上为以长石、粘土和粉砂等为主的硅铝酸盐;矿泥多充填包裹于盐类矿物粒晶间...     

颗粒化序列间歇式活性污泥反应器工艺处理化粪池污水

在序列间歇式活性污泥反应器(SBR)中成功培养出适应化粪池污水水质的好氧颗粒污泥.并将其应用于化粪池污水的处理.在好氧颗粒污泥培养的第15天左右,SBR中开始出现细小的颗粒,然后微生物在其上繁殖生长使颗粒逐渐增大而成熟;在第24天时,SBR中絮状活性污泥已基本实现了颗粒化.培养出的好氧颗粒污泥对化粪池污水有稳定的处理效果,在进水完全为化粪池污水时,COD、NH_4~+-N、TN的平均去除率分别为77%、61%、47%.但是,由于化粪池污水COD较低,因此无法维持较高的生物量,在后期的稳定运行过程中MLSS始终维持在2 500 mg/L左右.好氧颗粒污泥的同步硝化反硝化作用是其稳定脱氮的保证.