水中LAS的光催化氧化处理研究

本文研究了三聚磷酸钠（STPP）浓度变化和温度变化条件下,对水中直链十二烷基苯磺酸钠（LAS）光催化氧化降解的影响,并根据动力学研究的结果,充分说明了造成上述影响的原因。     

沉淀--吸附处理双氯灭痛高浓度有机废水的工艺研究

介绍了用沉淀－吸附法处理双氯灭痛高浓度有机废水的工艺。先用废盐酸将废水的ｐＨ调节到４,沉淀、过滤,然后将滤液依次经过炉渣、生炭串级吸附,处理后的废水ＣＯＤＣｒ、ｐＨ、ＳＳ均达到ＧＢ８９７８－８８污水综合排放制药行业二级标准。     

用离子交换法从β盐母液中分离1-萘磺酸钠的研究

比较了Ｄ２９０、Ｄ２９６、Ｄ３０１、Ｄ３７０、Ｄ３７２、Ｄ３８０ ６种树脂对β盐母液中１－萘磺酸的静态交换性能,筛选出Ｄ２９６用以回收β盐母液中的１－萘磺酸钠,进行了ＰＨ、接触时间、交换温度等影响因素的条件试验及树脂再生试验,得到１－萘磺酸钠收率８０％以上。     

采用温度梯度凝胶电泳(TGGE)分析消毒剂对池塘型微宇宙细菌群落结构的影响

构建6个池塘型微宇宙模拟水生态系统,1个设为对照组,试验组连续投加次氯酸钠13 d,投加剂量分别为1.0、2.5、5.0、10.0、20.0 mg/L,停止投加后再观察10 d.试验期间对各微宇宙分别进行8次采样,经37 ℃培养后提取细菌总DNA,进行16S rDNA V3区扩增后,对扩增产物进行TGGE分析.对TGGE图谱中的主要条带进行回收、重新扩增、克隆、建库、测序以及序列分析.结果显示,消毒剂进入环境后会对细菌群落结构产生影响,但不同剂量消毒剂产生的影响有显著差异,存在明显的剂量-效应关系:低剂量消毒剂对细菌群落结构的影响比较小,而且是可逆的,微宇宙系统对消毒剂逐渐适应后其群落结构即可恢复;而高剂最消毒剂对细菌群落结构的破坏比较大,且不可逆转,即使消毒剂停止投加后也不能恢复.说明盲目的过量投加消毒剂会对水体微生态环境造成严重破坏.图4表1参10     

可见光/H2 O2/海藻酸铁非均相催化降解吖啶橙的研究

由海藻酸钠和氯化铁反应制备了海藻酸铁凝胶小球催化剂,考察了该催化剂的吸附和可见光下催化降解吖啶橙的性能.结果表明催化剂的吸附能力随pH升高而提高,且催化剂用量为40个凝胶小球时,可见光下吖啶橙能够在较宽pH值范围内脱色,脱色速率随H2O2的用量增加而增加,该反应符合Arrhenius规律,其表观活化能为49.6 kJ/mol.自由基清除剂的加入不会降低脱色速率,表明催化反应不是羟基自由基的机理,而与高活性的类{ Fe(Ⅳ)=O}高价铁中间产物有关.     

聚环氧琥珀酸钠阻碳酸钙垢性能研究

研究了聚环氧琥珀酸钠在不同因素下的阻碳酸钙性能。实验结果表明 ,聚环氧琥珀酸钠具有较高的阻垢性能和较好的热稳定性 ,在高钙离子浓度、高温水系统中长时间停留对碳酸钙仍有较强的抑制作用。     

Development of inherent safety and health index for formulated product design

The numerous formulated products which are introduced to the market consist of chemical ingredients that may cause various safety and health hazards to the consumers. Therefore, it is extremely important to practice a systematic methodology to formulate products with acceptable safety and health performances. This work presents an index-based methodology to assess the safety and health hazards of the ingredients during the early formulation stage of product design. Hence, new inherent safety and health sub-indexes are introduced to improve the current safety and health hazards that are needed in formulated product design. The inherent safety and health sub-indexes are assigned with scores based on the degree of potential hazards. A higher score indicates a higher safety risk or severe health effect, and vice versa. The proposed methodology will greatly assist the users to identify the adverse safety and health effects caused by the ingredients. Hence, it is pivotal to eliminate or reduce the safety and health impacts from product usage. A case study on common ingredients used in the formulation of paint is presented on this study to describe the proposed method.     

Studies on catalytic reduction of nitrate in groundwater

Catalytic reduction of nitrate in groundwater by sodium formate over the catalyst was investigated. Pd-Cu/γ-Al₂O₃ catalyst was prepared by impregnation and characterized by brunauer-emmett-teller (BET), inductive coupled plasma (ICP), X-ray diffraction (XRD), transmission electron microscopy (TEM) and energy dispersive X-ray (EDX). It was found that total nitrogen was effectively removed from the nitrate solution (100 mg/L) and the removal efficiency was 87%. The catalytic activity was affected by pH, catalyst amount used, concentration of sodium formate, and initial concentration of nitrate. As sodium formate was used as reductant, precise control in the initial pH was needed. Excessively high or low initial pH (7.0 or 3.0) reduced catalytic activity. At initial pH of 4.5, catalytic activity was enhanced by reducing the amount of catalyst, while concentrations of sodium formate increased with a considerable decrease in N₂ selectivity. In which case, catalytic reduction followed the first order kinetics. Translated from Acta Scientiae Circumstantiae, 2006, 26(4): 567–571 [译自: 环境科学学报]     

Optimization, equilibrium, adsorption behavior and role of surface functional groups on graphene oxide-based nanocomposite towards diclofenac drug

Aquatic contamination of diclofenac (DCF), an emergent non-steroidal anti-inflammatory drug (NSAIDs), can result in adverse effects to many ecosystems through biomagnification. Hence, introducing effective remediation techniques to sequester the pharmaceutical wastes is highly fundamental to prevent their accumulation in the environment. Generally, adsorption has been presented as a green and efficient approach. Herein, we report the characterization and application of the novel magnetic nanocomposite ([email protected]₂O₄) derived from cobalt-based ferrite (CoFe₂O₄) and graphene oxide (GO) for DCF adsorption. For the optimization procedure, the response surface methodology (RSM) was adopted to investigate the impacts of DCF concentration (1.6–18.4 mg/L), DCF dosage (0.08–0.92 g/L), and solution pH (2.6–9.4) to find the optimum conditions for DCF removal, at 10.5 mg/L, 0.74 g/L, and pH 4, respectively. For the adsorption experiments, the kinetic, isotherm, thermodynamic, and intraparticle diffusion models were systematically studied. Moreover, we have elucidated the role of functional groups on the surface of [email protected]₂O₄ in enhancing the adsorption of DCF drug. With good removal efficiency (up to 86.1%), high maximum adsorption capacity (32.4 mg/g), [email protected]₂O₄ can be a potential candidate to eliminate DCF drug from water.     

毛细管气相色谱法衍生化的最优催化剂

衍生化处理对于气相色谱检验环境中微量有机物有着重要的作用,酯化反应作为最常用的方法,正越来越广泛的运用在多种酸性物质的衍生化处理中。根据酯化反应催化原理,在实验中发现反应的最佳条件为:温度为80℃,选用硫酸氢钠或三氯化铁催化剂,催化剂用量为2g。