Removal of basic fuchsin dye from aqueous solutions using graphite oxide modified aromatic polyurethane foam material

Graphite oxide modified polyurethane foam (GO/PUF) was used for adsorption of basic fuchsin from aqueous solution and adsorption conditions were optimized to attain an efficiency of 99.5%. The adsorption isotherm was in agreement with the Langmuir model. Kinetic study followed pseudo-second order. Determination of Gibbs free energy and enthalpy change of adsorption indicated spontaneous and endothermic adsorption behavior, suggesting that the adsorbent had a potential for the removal of dyes from industrial wastewater.     

Concentrations of polychlorinated dibenzo‐p‐dioxins and dibenzofurans in outdoor air of North‐Rhine‐Westphalia,Germany

Measurements of polychlorinated dibenzo‐p‐dioxins (PCDD) and dibenzofurans (PCDF) in outdoor air of North‐Rhine‐Westphalia were carried out. Fifty‐six samples were taken at different sites in areas of different land use and emission structures. A special filter system allowed analysis of the gas and particle phases separately. It was found that higher chlorinated PCDD/PCDF (7 or 8 chlorine atoms) are collected on glass fiber filter and lower chlorinated PCDD/PCDF (tetra‐ and penta‐CDD/CDF) are absorbed on polyurethane foam. The following isomers were determined: OCDD, OCDF and 11 isomers with chlorine substitution in 2,3,7,8‐position as well as the sum of TCDD, PeCDD, HxCDD, HpCDD, TCDF, PeCDF, HxCDF, HpCDF and the sum of PCDD (4–8) and PCDF (4–8). No 2,3,7,8‐TCDD could be detected but 2,3,7,8‐TCDF was found at 15 sites. Mean concentration in the Rhine‐Ruhr‐District for the sum of PCDD (4–8) and PCDF (4–8) was 3.2pg/m³ and 5.5pg/m³ respectively. Detection limit for TCDD and PCDD/PCDF (5–8) was 0.1–0.2 pg/m³ and 0.005–0.015 pg/m³ respectively. There is no significant indication that 2,3,7,8‐chlorinated isomers of PCDD/PCDF are predominantly decomposed by photochemical reactions in outdoor air.     

国内外化学镀镍老化液处理方法

简述了化学镀镍的工艺流程,镀液及老化液成分,以及国内外现有的对化学镀镍老化液处理方法,包括化学法、电解法、离子交换法和膜分离技术。     

密度对聚氨酯软泡收缩及燃烧行为的影响

采用锥形量热仪研究不同密度聚氨酯软泡(FPUF)的燃烧行为,并根据摄像、体视显微镜所观察的样品形体及泡孔结构的变化来研究火灾条件下FPUF的收缩特性。研究结果表明,收缩是表层泡孔受热发生热解生成焦油所致的泡孔塌缩现象,焦油层下方泡孔结构基本没有变化;FPUF密度越大着火前的收缩速率越小,同一时刻表层泡孔热解生成的焦油层越薄。FPUF的着火燃烧可分为受热收缩、燃烧收缩和池火燃烧三个阶段。中高密度样品HRR曲线先出现平台后出现峰值,分别对应于燃烧收缩和池火阶段,且密度越大HRR曲线的平台越低、峰值越高,燃烧收缩阶段的FIGRA越小,而池火燃烧阶段的FIGRA越大。着火前的快速收缩导致低密度样品的HRR曲线不出现平台只呈现单峰。     

泡沫灭火剂对车用汽油油盘火的灭火性能研究

汽油易挥发且闪点低,火灾危险性极大,且理化性能与标准燃料存在较大差异,有必要评估当前市售泡沫灭火剂对汽油的灭火性能。通过4.52 m 2油盘火试验,对水成膜泡沫灭火剂、抗溶水成膜泡沫灭火剂、氟蛋白泡沫灭火剂及抗溶氟蛋白泡沫灭火剂的灭火性能进行评估研究,并与标准燃料油盘火进行对比,结果表明抗溶水成膜泡沫灭火剂对车用汽油火的灭火效能最佳,石化企业和消防救援队伍在处置汽油火灾时应优先考虑使用抗溶水成膜泡沫灭火剂。此外,车用汽油比标准燃料的灭火难度更大,石化企业可适当提高固定泡沫灭火系统的设防标准。     

不同气源压缩气体泡沫灭浮顶罐密封圈火灾性能比较

为评估不同气源压缩气体泡沫扑救浮顶罐密封圈火灾的有效性,通过足尺灭火试验,研究不同工况下压缩气体泡沫对浮顶罐密封圈火灾的灭火性能以及气源类型、挡雨板遮挡对灭火的影响。结果表明:在泡沫溶液供给强度为5 L/（min·m2）条件下,压缩氮气泡沫和压缩空气泡沫均可快速有效扑灭典型浮顶罐密封圈火灾,且灭火后不发生复燃;密封圈挡雨板对泡沫施加和灭火均有较大影响,不利于快速灭火;无论是否设置挡雨板,压缩氮气泡沫的灭火性能均比压缩空气泡沫略有提升,实际工程中有氮气源的场所建议直接采用已有供氮设备作为气源。研究结果对压缩气体泡沫系统工程设计以及在大型浮顶罐工程中的应用具有重要意义。     

便携式储油囊中网状聚氨酯泡沫材料阻燃抑爆性机理研究

针对便携式储油囊的储油安全性,提出了在储油囊内填充网状聚氨酯泡沫材料的设想,通过对网状聚氨酯泡沫材料阻燃抑爆性的机理研究,得出网状聚氨酯泡沫材料在储油领域中具有广阔应用前景的结论.     

废旧聚氨酯硬泡热解特性

采用热重分析仪对废旧聚氨酯硬泡在氮气中的热失重行为进行了研究,并对升温速率、热解终温对热解的影响进行了分析. 结果表明:在氮气气氛条件下,废旧聚氨酯硬泡热解主要发生在200～492 ℃;随着升温速率的提高,废旧聚氨酯硬泡热失重时挥发分初析温度向高温方向偏移,失重速率峰值(DTG_max)显著增大.利用热重-红外(TG-FTIR)联用方法对氮气气氛中10 ℃/min升温速率下的样品热解气体产物进行了检测. 结果表明:废旧聚氨酯硬泡热解产物有H₂O,CO₂,CO,CFC-11,以及含氯化合物、烯烃类、烷烃类和带有苯环等官能团的化合物,且主要气体产物有相似的析出规律.      

电催化还原脱毒预处理丙烯酸盐废水

丙烯酸盐生物降解性好,但毒性较高,为解决含丙烯酸盐废水难以进行高负荷厌氧生物处理的问题,采用电催化还原技术预处理高浓度丙烯酸盐废水,考察了初始ρ(丙烯酸盐)、电流、废水pH、温度、ρ(对甲基苯磺酸盐)等对丙烯酸盐转化的影响. 结果表明:初始ρ(丙烯酸盐)、废水pH、电流对丙烯酸盐电催化还原为丙酸盐的过程影响较大,而废水温度和ρ(对甲基苯磺酸盐)的影响较小. 当废水初始ρ(丙烯酸盐)由5.0 g/L升至20.0～60.0 g/L时,丙烯酸盐转化速率由30.1 g/(L·h)升至51.9～54.6 g/(L·h),能耗下降近50%;随着操作电流从0.25 A升至2.00 A,丙烯酸盐转化速率由9.5 g/(L·h)线性增至85.1 g/(L·h),电流效率略有降低,能耗由2.0 W·h/g增至5.2 W·h/g;pH由2升至4时,能耗由6.6 W·h/g降至3.4 W·h/g;废水温度在30~50 ℃范围内、ρ(对甲基苯磺酸盐)在0~8.0 g/L范围内时,对丙烯酸盐的转化影响较小. 研究显示,在优化工艺条件(电流为1.00 A、废水pH为5、温度为30 ℃)下,电催化还原处理实际丙烯酸丁酯废水,电流效率达90%以上.      

泡沫塑料黄原酸酯的制备及其对含铜废水的处理研究

采用聚氨酯泡沫塑料制备得到了黄原酸酯.将其用于含铜废水的处理.实验结果表明泡沫黄原酸酯的用量、处理体系的pH、搅拌时间和沉降时间是影响铜离子去除效果的重要因素.经过聚氨酯泡沫黄原酸酯处理的含铜废水能够达到排放标准的要求.