上海石洞口第二电厂拟建粉煤灰分选系统的技术可行性研究

上海石洞口第二电厂拟建设粉煤灰分选系统生产国标等级灰,但其粉煤灰的游离氧化钙偏高.研究表明:游离氧化钙在细灰中没有明显富集的趋势,即源灰游离氧化钙含量指标合格,那么分选所产细灰的也合格;供分选用的源灰细度和粒度分布较利于提高分选效率,生产国标Ⅱ级灰的分选产率可达70%左右;建设分选系统在技术上是可行的,且可获得较大的综合效益.     

瓦斯气体在煤层中的扩散机理及模式

根据气体在多孔介质中的扩散模式 ,结合煤结构的实际特点 ,分析了瓦斯气体在煤孔隙中的扩散机理 ,得出瓦斯在煤体中几种扩散模式 :菲克型扩散、诺森扩散、过渡型扩散、表面扩散和晶体扩散。从微观上看 ,影响瓦斯气体在煤层中扩散的主要因素是瓦斯气体的平均自由程和煤不同尺寸微孔隙的分布情况。根据不同孔隙分布的煤层 ,探讨了各种扩散模式的适用条件     

碳酸钙自发沉淀析出的动力学研究

通过记录析晶过程中溶液各组份随时间的变化关系,研究了不同过饱和度的碳酸钙水溶液的沉淀动力学过程．实验结果显示,异相成核是主导的成核机制．通过实验数据计算出了表面二维晶核的棱自由能为２．５３ × １０－８ｍＪ·ｍ－１．实验数据表明,碳酸钙晶体生长的过程是扩散控制过程．     

软件滤波在土体自振柱试验中的应用

自振柱试验是测量土样动剪切模量和阻尼比的常用方法,但由于噪声等环境因素的影响,土样扭剪自由振动的衰减波曲线有时会因高频干扰出现不平滑现象,难以得到合理的测试结果。软件数字滤波是解决这类问题的有效方法。本文通过多种软件数字滤波方法优缺点的对比,认为平均滤波法和惯性滤波法能有效解决试验数据中的高频干扰问题,并分别选择适当的滤波参数,得到了平滑的自振衰减波曲线;最后,采用平均滤波法处理了两组自振柱试验数据。结果表明,软件滤波法确能有效消除不合理数据,得到符合一般规律的土体动剪切模量和阻尼比试验结果,从而验证了其在土体自振柱试验中的应用价值。     

Surface-enhanced Raman spectroscopic analysis of N6-benzylaminopurine residue quantity in sprouts with gold nanoparticles

ABSTRACT

A rapid and quantitative method for the determination of N⁶-Benzylademine (N⁶-BA) was established through the application of surface-enhanced Raman spectroscopy (SERS). The Raman peak intensities of N⁶-BA at 1002 cm^?1 positively correlated to N⁶-BA concentrations in sprout extracts. The R² reached 0.99, and RSDs calculated below 10% at the concentration range of 0.1 ～5μg mL^?1. The average recoveries were 80.0% ～ 98.2% for blank samples intentionally contaminated at differing levels of 0.04, 0.4, and 1 μg g^?1. The whole procedure, including sample preparation and SERS detection, did not exceed 30 min for a set of 6 samples. This study indicates that SERS is a promising technique for rapid tracing analysis and on-site testing of N⁶-BA.     

Rain‐washing of mimic®, RH‐5992, from balsam fir foliage following application of two formulations

Abstract

Two formulation concentrates of the insecticide, RH‐5992 [N'‐t‐butyl‐N'‐(3,5‐dimethylbenzoyl)‐N‐(4‐ethylbenzoyI) hydrazine], an aqueous flowable (2F) and an emulsion‐suspension (ES), were diluted with water to provide spray mixes containing dosage rates ranging from 35 to 150 g of the active ingredient (AI)/ha. The mixes were sprayed in a laboratory chamber, onto balsam fir branch tips collected from field trees and greenhouse‐grown seedlings. Droplet spectra and spray mass recovery were determined on artificial samplers. Simulated rainfall of two different intensities was applied at different rain‐free periods, and rain droplet sizes were determined. Foliar washoff of RH‐5992 was assessed after application of different amounts of rain, and the increase in soil residues was evaluated.

A direct relationship was indicated between the amount of rainfall and RH‐5992 washoff. The larger the rain droplet size, the greater the amount washed off. Longer rain‐free periods made the deposits more resistant to rain. Regardless of the amount of rainfall, rain droplet size and rain‐free period, foliar deposits of the 2F formulation were washed off to a greater extent than the ES formulation. The increase in soil residues due to foliar washoff was greater for the 2F than for the ES formulation. The deposits of the emulsion‐suspension were consistently more resistant to rain‐washing than those of the aqueous flowable formulation.     

硝化颗粒污泥的快速培养及其硝化特性分析

以好氧颗粒污泥接种小试柱形SBR,采用自配无机氨氮废水为进水,在中温（28～30℃）条件下通过逐步提升进水NH4^＋-N浓度（100～650mg／L）和缩短水力停留时间（8～4h）快速培养硝化颗粒污泥。实验结果证实,以好氧颗粒污泥接种可以促使硝化颗粒污泥快速形成,36d时粒径〉0．21mm的颗粒污泥占总数的93％,颗粒污泥NH4-N比去除速率为50．53mgNH4^＋-N／（gSS·h）。硝化颗粒污泥具有良好的短程硝化性能,亚硝酸盐产生速率和累积率分别保持在3．3kgNO2-N／（m^3·d）和85％以上。反应初期高FA和反应末期高FNA的共同抑制是该研究中实现和维持稳定短程硝化的关键因素。     

氨基咪唑类甲醛捕获剂去除人造板中游离甲醛

采用1-(3-氨基丙基)咪唑作为甲醛捕获剂,研究去除人造板中游离甲醛的方法。在单因素实验基础上,根据中心组合设计原理,采用4因素3水平的响应面分析法,依据回归分析确定最佳甲醛捕获工艺条件。结果表明,当1-(3-氨基丙基)咪唑用量为0.6 g,温度17℃,反应时间48 min,反应体系的pH值为9.0时,捕获率为85.21%。所以,1-(3-氨基丙基)咪唑化合物对人造板中的游离甲醛有较好的捕获能力。     

新疆油田气井压井液研究与回收利用

针对新疆克拉美丽气田火山岩气藏固相堵塞、滤液侵入等潜在伤害因素,研制了GCP无固相气井压井液体系。该体系具有无毒、无刺激性、可生物降解、能有效抑制粘土膨胀、低滤失、不与储层中钙、镁等二价离子反应形成无机沉淀以及低腐蚀等特点,可有效保护储层和油、套管。通过循环替液将气井钻井、完井作业使用的泥浆中固相成分和岩屑带出井筒,用过的压井液经过固相清除处理可实现回收再利用,在减少对储层环境污染的同时,降低了压井液使用成本,为在新疆油田公司大规模应用奠定了良好的基础。     

Experimental investigation on the phase change material-based modular heat exchanger for thermal management of a building

A phase change material (PCM)-based flat plate modular heat exchanger for free cooling application, suitable for the diurnal temperature variation that prevails during the summer months of Bangalore city, India is designed and experimentally investigated. The flow and other parameters selected in the present study are meant to suit the accelerated charging of the PCM in the modular heat exchanger during the early morning hours, and to provide cool energy to the room during the daytime, by circulating the ambient air through the heat exchanger at a lower velocity. It is observed from the charging experiments that the decrease in the inlet air temperature has more influence in reducing the solidification time than the increase in the inlet air velocity. The heat exchanger designed in the present investigation is capable of maintaining the room temperature around 30°C for a longer duration of 8 hr when the heat load is 0.5 kW. It is suggested to design the modular heat exchanger with a surface area proportionate to the present heat exchanger size when the room heat load increases beyond 0.5 kW, in order to maintain a minimum comfortable temperature of 30°C in the room.