Analysis of organic compounds in coal gasification wastewater

A procedure for analysis of organic pollutants in coal gasification wastewater was developed, including a series extraction steps at different pH, followed by LC separation or resin adsorption, then analyzed by GC or GC/MS. More than 200 organic pollutants in 22 categories were determined. CH2CL2 extraction at NaHCO3 presence was used to separate carboxylic acids with phenolic compounds in aqueous. Derivatization with acetic anhydride was used for analyses of mono-, di-, poly-hydroxyl phenolic compounds. 21 mono-hydroxyl phenols and 13 di-hydroxyl phenols were determined from the coai gasification wastewater samples. Derivatization with BF3-CH3OH was used for analysis of carboxylic acid. 17 mono-carboxyl, 4 di-carboxyl acids and 6 aromatic acids were determined from coal gasification wastewater samples.     

电絮凝技术处理煤气化灰水

采用电絮凝技术处理粉煤加压气化航天炉装置产生的灰水。中试结果显示：灰水经电絮凝一体化装置处理后,出水中总钙和总镁的平均值分别降至180 mg/L和11.1 mg/L,有效抑制了结垢的发生;相对于单一氢氧化钠,碳酸钠和氢氧化钠共同作用的处理效果更好。工业化应用结果表明,电絮凝一体化装置对灰水的总硬度、浊度和悬浮物均有较好的去除效果,其平均去除率分别为32.5%、66.7%和73.0%。采用该技术处理煤气化灰水具有较强的经济性。     

活性焦吸附—曝气生物滤池处理煤气化废水生化出水

采用活性焦吸附—曝气生物滤池（BAF）工艺对煤气化废水生化出水进行深度处理。在活性焦投加量2 g/L、吸附时间2 h、BAF生化停留时间4 h的条件下,总COD去除率为85.4%,最终出水平均COD为45.2 mg/L,满足后续双膜法回用工艺要求（COD≤50 mg/L）。活性焦对致色的大分子有机物具有较好的吸附效果,吸附后废水的色度从300倍降至60倍,同时耗氧速率加快,可生化性提高。活性焦的吸附以物理吸附为主,吸附出水没有急性毒性。三维荧光光谱显示：各单元对于酚类的去除均有贡献,小分子组分中的酚类几乎全被去除。     

生物膜反应器降解生物质气化洗焦废水

陶瓷球作为固定介质 ,接种本实验室保藏的Pseudomonassp1和Pseudomonassp2混合菌种 ,应用生物膜反应器处理生物质气化过程中产生的洗焦废水 ,对反应器运转整个过程的进出水COD浓度、进出水苯、萘、菲、吡啶、喹啉、异喹啉的含量、反应器内和反应器出水含菌量进行测定 ,以了解生物膜反应器处理生物质气化洗焦废水的特性 .结果表明 ,反应器经挂膜、增菌后 ,可达到稳定运转状态 ,有效的控制了反应器内微生物细胞的流失 ,使生物质气化洗焦废水中的有机物得到较好去除 .     

超临界水气化处理对脱水污泥中重金属环境风险的影响

为探究超临界水气化前后脱水污泥中重金属的变化及生态风险,从重金属(Ni、Cu、Zn、Pb、Cr)的含量、化学形态分布及浸出毒性等多方面出发,利用地层累积指数(Igeo)、潜在生态风险指数(RI)和风险评估指数法(RAC)对江苏地区10种不同种脱水污泥超临界水气化前后重金属的环境生态风险进行综合评价.结果表明:不同污水厂脱水污泥经超临界水气化处理后,绝大部分污泥中重金属浸出毒性和生物可利用组分重金属含量明显降低,即处理后重金属的直接环境风险大大降低.不同重金属含量的脱水污泥经超临界水气化处理后,重金属环境污染程度及潜在生态风险程度显著降低,环境风险值被降至相对安全水平,对环境表现出低风险或无风险.p H值在一定程度上影响处理后污泥中重金属的环境风险.超临界处理时,污泥的p H呈现酸性时会引起反应釜腐蚀,从而导致固相残渣中Ni、Cr的生物可利用组分含量增加,当p H呈现碱性时则更利于重金属以稳定形态富集到固相产物中.     

Analysis and assessment of a critical event during an underground coal gasification experiment

The main goal of the study presented in this paper was to analyse the mechanisms affecting an Underground Coal Gasification (UCG) process and to identify possible deviations of the system from normal work to limit, or even avoid, losses. The UCG process is one of the most innovative technologies connected with the exploitation of coal deposits that are currently being tested and developed all around the world. It allows the conversion of a coal seam into gas under in situ conditions of high temperature with the use of gasifying agents such as air, oxygen, steam or with a mixture of them.The paper presents the results of the analysis and assessment of a critical event during the process: a dangerous gas accumulation that occurred during an underground coal gasification experiment in the Experimental Mine “Barbara” of the Central Mining Institute (Poland). The UCG experiment using the shaft method is described, together with its monitoring system and the problems that appeared during the process. The application of the Fault Tree Methodology allowed the establishment of the main factors that may lead to the explosion and to present possible scenarios of its occurrence.Moreover, calculations were carried out to evaluate the risk level of explosion for the gas mixture and the minimum level of oxygen in the mixture that is necessary to initiate an explosion. These calculations were based on a modification of the formula proposed by Le Chatelier. During the course of the underground experiment, original information of the process behaviour has been acquired that can be used in the preparation of other UCG experiments in operational mines to guarantee the safety and the stability of the process.     

Environmental benefits of underground coal gasification

ＩｎｔｒｏｄｕｃｔｉｏｎＣｏａｌｉｓｔｈｅｍａｉｎｅｎｅｒｇｙｒｅｓｏｕｒｃｅｉｎＣｈｉｎａａｎｄｔａｋｅｓｍｏｒｅｔｈａｎ 70 %ｏｆｔｈｅｐｒｉｍａｒｙｅｎｅｒｇｙｒｅｓｏｕｒｃｅｃｏｍｐｏｓｉｔｉｏｎ.Ｂｕｔｔｈｅｅｎｖｉｒｏｎｍｅｎｔａｌｐｏｌｌｕｔｉｏｎａｒｉｓｅｎｆｒｏｍｃｏａｌｍｉｎｉｎｇ ,ｔｒａｎｓｐｏｒｔａｔｉｏｎ ,ａｎｄｂｕｒｎｉｎｇｉｓｂｅｃｏｍｉｎｇｍｏｒｅａｎｄｍｏｒｅｓｅｒｉｏｕｓ .Ｔｈｅｒｅｆｏｒｅ ,ｉｎｏｒｄｅｒｔｏａｃｃｅｌｅｒａｔｅｔｈｅｃｏｏｒｄｉｎａｔｅｄｄｅ…     

生物质催化气化制取富氢燃气的研究

以流化床为反应器 ,探讨了一些主要参数如 :反应器温度 ,水蒸气 ,当量比ER以及催化剂对气体成分、氢产率和潜在氢产率的影响。实验所用催化剂为白云石和镍基催化剂。在实验条件范围内 ,氢产率为 2 2— 83g/kg生物质 (湿基 ) ,潜在氢产率为 115— 2 2 3g/kg生物质 (湿基 )。结果表明 ,较高的反应器温度 ,适当的水蒸气添加量可以有效提高氢的产出 ;白云石和镍基催化剂可使产品气中的氢含量提高 10 %以上。     

废弃印刷线路板熔融盐气化特性:Ⅲ金属分布与回收实验

为实现印刷线路板金属和非金属的分离回收,在熔融盐气化炉中进行废弃印刷线路板气化实验,对气化过程中金属在熔融盐内的滞留和分布情况进行了研究.结果表明,90%以上的Cu、Al、Ca、Cd、Co、Mg、Sb、Sn、Zn等金属滞留在熔融盐内部.滞留的金属大部分分布熔融盐底部,Al、Cu、Co、Sb、Sn在熔融盐纵向底部的3、4层中的质量分数达90%以上;Mg、Pb和Se在底部3、4层的质量分数也在70%以上.利用金属和非金属成分在不同纵向高度上的分布区别,可以回收得到富集度较高的金属富集体.如纵向4层的总金属质量分数达到92.76%,且其中铜的质量分数达到78.06%.Al的质量分数达到9.89%.     

煤加压气化废水混凝-Fenton氧化法预处理与谱图分析

煤加压气化废水中含有多种难降解有机物,其成分因原煤性质和气化工艺的不同而复杂多变,属于难处理工业废水,目前主要的处理方法有臭氧氧化法、活性炭吸附法、Fenton试剂法、超声空化效应等,文章综合比较各种方法的优缺点,针对煤加压气化废水的特点,利用不同类型的无机混凝剂和Fenton试剂对气化废水进行了混凝-Fenton法处理,并确定了最佳处理条件。在最佳条件下,COD、BOD5、氨氮、挥发酚和色度的平均去除率分别达到81.27%、76.87%、72.45%、86.42%和99.9%,BOD5与COD的比值由0.34提高到0.45。在对处理前后的废水的液-质联用谱图分析得知,处理后苯酚的去除率约为97.6%左右。结果表明煤加压气化废水经过混凝-Fenton法联合处理后出水能达到国家标准,并且成本相对较低,具有广阔的实际应用前景。