硝酸甲胺反应过程的安全性研究

用反应量热仪(RC1e)对硝酸溶液与一甲胺溶液在反应过程中的热安定性进行初步研究,分别测试不同反应温度、加料速度和初始硝酸浓度下反应的放热情况。实验结果表明:该中和过程反应迅速,在室温就能进行;与反应温度、加料速度相比,起始硝酸浓度对反应安全性影响最大,且硝酸浓度越高,反应的速度和反应的完全程度也越高。实验还表明:RC1e是研究反应过程中热安定性情况的有效工具,能通过反应过程的热量变化体现反应速率,所得结果对硝酸甲胺的工业化生产具有重要的参考价值。     

池火灾热辐射的数值研究

通过列举储罐火灾事故,提出对池火灾进行研究的重要性。介绍目前池火灾国内外的研究现状及发展情况,描述池火灾燃烧特征和模型。应用化学流体力学基本定律,建立了描述池火灾过程的基本控制方程组,并根据适当的条件选择辐射模型。建立物理模型,做出合理假设,确定初始和边界条件,对池火灾热辐射过程进行数值模拟,得出火焰周围入射热流密度分布图,计算出相邻两罐之间的最小安全距离,应用于工程实际中,给防火间距的制定提供理论依据,计算结果定性合理。     

水源热泵空调系统的水质处理技术

针对影响水源热泵系统运行效能的地下水水质和回灌过程中井堵塞的问题,提出相应的水质处理方法和水源热泵用地下水水质参考标准.     

Multivariate characterization of elements accumulated in Wolfiporia extensa mushroom from Yunnan province of China

ABSTRACT

Dried sclerotia of Wolfiporia extensa have been used as medicine in Asia from Eastern Han Dynasty, and also used as traditional snack called “fulingjiabing” in Beijing, China. In this paper, 18 macro and trace elements (Ag, As, Ba, Cd, Co, Cr, Cs, Cu, Fe, Li, Mn, Ni, Pb, Rb, Se, Sr, V, and Zn) in both flesh and peel of Wolfiporia extensa from seven sites of Yunnan province in China were determined by inductively coupled plasma mass spectrometer. The average recovery rates of certified reference materials for GBW10015 (spinach leaves) ranged from 90.5 to 113%, for GBW10028 (citrus leaves) from 92.8 to 106%, and for GBW07603 (bush branch and leaves) from 83.3 to 114.6%. Generally speaking, the concentration of all elements determined was at common level. The results of this survey indicate that mineral compositions in peel were higher than in flesh. In peel, the contents of investigated trace metals in mushroom samples were found to be in the range of 1,660–13,400 µg·g^?1 dry matter (dm) for Fe and 29.6–710 µg·g^?1 dm for Mn. The mean contents of Cr, Cu, Rb, V, and Zn in peel were between 10 and 20 µg·g^?1 dm, followed by As, Co, Li, Ni, Pb, Se, and Sr with mean contents between 1 and 10 µg·g^?1 dm, while Ag, Cd, and Cs had mean contents of <1 µg·g^?1 dm. In flesh, the concentration of Fe was in the range of 54–900 µg·g^?1 dm, and it was 1.5–49 µg·g^?1 dm for Mn, followed by Ba, Cu, Rb, and Zn in the range of 1 to 10 µg·g^?1 dm, while for Ag, As, Cd, Co, Cr, Cs, Li, Ni, Pb, Se, Sr, and V it was <1 µg·g^?1 dm. The concentration of toxic elements, such as As, Cd, and Pb, in both flesh and peel was below the permissible limits of World Health Organization. However, As and Pb contents in peel were higher than the limits permitted in the Chinese Pharmacopoeia. The results of principal component analysis showed that the flesh of Wolfiporia extensa from all the seven sites of the Yunnan province tend to cluster together, most probably because the origin of mineral elements in both flesh and peel is wood substrate (old and dead pine trees).     

Inorganic elemental concentrations in birch bolete mushroom (Leccinum scabrum) and top soil: contamination profiles,bioconcentation and annual variations

Abstract

Analysis of inorganic and organic contaminants in foodstuffs aids in understanding the human exposure to these compounds via consumption. In this study, an edible mushroom species (Leccinum scabrum) and top soil samples were analysed for essential and toxic substances including phosphorus and inorganic elements over a period of three fruiting seasons. Analysis of silver (Ag), aluminium (Al), barium (Ba), calcium (Ca), cadmium (Cd), cobalt (Co), copper (Cu), iron (Fe), mercury (Hg), potassium (K), magnesium (Mg), manganese (Mn), sodium (Na), nickel (Ni), phosphorus (P), lead (Pb), rubidium (Rb), strontium (Sr) and zinc (Zn) in mushrooms and topsoil were performed using inductively coupled plasma optical emission spectroscopy (ICP-OES) with ultrasonic cross flow nebulizer. Total mercury was determined by cold-vapour atomic absorption spectroscopy (CV-AAS). The results exhibited wide variation in concentrations of metals between soil and mushroom (cap and stipes) during three fruiting seasons. Positive bioconcentration factors (BFCs) indicate on bioaccumulation of several metals including, Cd, Cu, Hg, K, Mg, Na, P, Rb and Zn in caps and stipes of fruitbodies of this mushroom, while other metals such as Al, Ba, Ca, Co, Fe, Mn, Ni, Pb and Sr were not exhibiting significant positive BFCs. Over a period studied, the caps were characterised by different (p?<?0.05) concentrations of Al, Co, Cu, Hg, Mn, Ni, P, Pb and Sr. Contamination profiles, temporal fluctuations, BCFs should be taken into consideration when assessing the nutritional value of this mushroom.     

电化学氢化物发生法处理含锑废水及对锑的回收

采用电化学氢化物发生法对模拟含锑废水进行处理,锑与水电解产生的氢形成氢化物从溶液中脱除,而后收集并加热分解锑化氢得到金属锑.实验表明,在酸性条件下对Sb(Ⅲ)去除效果较好,p H=4时去除率为76.1%.Sb(Ⅲ)与电解水产生的氢结合形成锑化氢从溶液中逸出是溶液中锑去除的最主要途径(回收率为66.2%),电沉积和吸附也对锑的去除做出少量贡献.Sb(Ⅴ)须预还原为Sb(Ⅲ)再氢化进行去除.试用了铅、石墨、钨这3种电解阴极材料,铅电极处理效果最佳.     

中国城市热岛时空特征及其影响因子的分析

全球气候变暖背景下,城市热岛效应会加重城市地区的热胁迫,对人类健康和生存发展提出严峻挑战.近年来我国雾-霾污染情况严重,但雾-霾对城市热岛影响的认识仍较匮乏.本研究基于MODIS遥感卫星地表温度数据,明确了我国2003~2013年白天、夜间以及四季城市热岛的空间变化,并从生物物理学和生物化学角度定量分析其控制机制.结果表明,影响我国白天城市热岛强度的主要因素为人口、农田灌溉和植被活动.纬度、降水量、反照率以及气溶胶浓度是夜间城市热岛强度的主控因子.从对比城乡粗糙度、反照率等生物物理学属性的角度,揭示了乡村背景环境对城市热岛分析的重要影响.结果表明,雾-霾治理可以缓解我国夜间城市热岛现象和热胁迫,有利于缓解区域甚至全球气候变化.     

锑胁迫下丛枝菌根真菌对玉米生长与锑吸收及抗氧化酶的影响

为了探讨AM(arbuscular mycorrhizal,丛枝菌根)真菌在Sb(锑)胁迫下对农作物生长及吸收Sb的影响,采用盆栽试验研究了在不同Sb添加量[即w(Sb)分别为0、500、1 000 mg/kg]下,接种AM真菌对玉米植株生物量以及N、P和Sb的吸收、膜脂过氧化[MDA(丙二醛)]和抗氧化酶活性的影响.结果表明:随着土壤中Sb添加量的增加,玉米植株的生物量、w(TN)和w(TP)均呈显著下降趋势,植株体内的w(Sb)和Sb积累量、MDA含量、CAT(过氧化氢酶)以及POD(过氧化酶)活性均显著上升.与未接种组相比,接种AM真菌显著促进了玉米植株的生长,提高了玉米植株地上部分的w(TN)和w(TP).在3个Sb添加量处理下,接种显著增加了玉米植株地下部分的w(Sb)、地上和地下部分的Sb积累量以及地上部分的CAT活性,增幅分别为8.90%~23.30%、18.87%~28.37%、27.68%~78.95%及14.92%~88.52%;同时,接种降低了玉米植株中Sb的转运率、玉米植株地上部分的w(Sb)和MDA含量,在1000 mg/kg Sb添加量下差异达显著水平,三者分别降低了36.35%、22.81%和24.29%.研究显示,在Sb污染环境下,接种AM真菌能够减轻玉米植株膜脂过氧化程度,在提高玉米植株地下部分w(Sb)的同时,也会降低Sb向地上部分的转运,减轻Sb对玉米的毒害作用.      

铝合金-丁腈橡胶航空带垫卡箍典型环境损伤研究

目的研究典型环境对丁腈橡胶-铝合金带垫卡箍的损伤效应。方法通过模拟铝合金-丁腈橡胶航空带垫卡箍使用时的装配结构和应力状态,应用GJB 150A—2009中的湿热和太阳辐射两种典型老化环境,采用宏观形貌观察、卡箍保持力测试和橡胶衬垫拉伸性能测试方法,结合扫描电子显微镜和傅里叶红外光谱技术,分析带垫卡箍的性能劣化过程。结果带垫卡箍在湿热和太阳辐射环境中老化50 d后,卡箍橡胶衬垫表面出现大量微孔缺陷,拉伸性能大幅降低,导致卡箍保持力分别下降了35%和51%。结论带垫卡箍在模拟装配状态下进行湿热和太阳辐射环境暴露实验,卡箍橡胶衬垫内部结构由致密逐渐变得疏松,部分碳碳双键发生氧化交联反应,并在一定程度上提高了聚合物的交联密度,材料硬度提高,回弹性能减弱,橡胶衬垫对芯轴的包裹能力降低,导致卡箍保持力性能降低。     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。