Preparation of high concentration polyaluminum chloride with high content of Alb or Alc

A novel membrane distillation concentration method was used to prepare high concentration polyaluminum chloride (PACl) with high content of Al_b or Al_c. 2.52 mol/L PACl₁ with 88% Al_b and 2.38 mol/L PACl₂ with 61% Al_c were successfully prepared. Three coagulants, AlCl₃, PACl₁ and PACl₂ were investigated on their hydrolysis behavior and speciation under different conditions. The effects of pH and dilution ratio on Al species distribution were investigated by ferron assay. Experimental result showed that pH had a significant effect on Al species distribution for the three coagulants. Dilution ratio had little effects on Al_b and Al_c distribution in whole dilution process except the beginning for PACl₁ and PACl₂. The results indicated that transformation of Al depends largely on their original composition. AlCl₃ was the most unstable coagulant among these three coagulants during hydrolysis process. PACl₁ and PACl₂ with significant amounts of highly charged and stable polynuclear aluminum hydrolysis products were less affected by the hydrolysis conditions and could maintain high speciation stability under various conditions.     

淹没式生物膜-稳定塘组合技术处理农村生活污水研究

以淹没式生物膜-稳定塘组合技术处理农村生活污水,系统取消了二沉池、污泥回流。运行结果表明:系统对COD、NH3-N、TN和TP的平均去除率分别为84.33%、97.02%、80.18%和77.34%,出水平均浓度分别为14.88,1.06,9.92,0.53 mg/L。淹没式生物膜系统出水污泥浓度为零,稳定塘出水水质良好,可满足中水回用。     

贫营养条件下膜生物反应器污泥混合液可滤性分析

采用膜生物反应器(MBR)运行16d,未向反应器内活性污泥投加营养物质,对溶解性微生物代谢产物(SMP)、污泥颗粒粒径分布(PSD)、胞外聚合物(EPS)、SMP相对分子量分布(MWDs)进行了定期监测.修正的污染指数(MFI)用来考察与SMP和EPS相关的污泥混合液可滤性.结果表明,MFI值由1.8′104迅速增加到7.3′104s/L2,说明长时间的内源代谢过程对MBR内污泥混合液可滤性有负面的影响.污泥混合液上清液中SMP相对分子量>10kDa的大分子有机物和污泥絮体中1~10μm细小颗粒的增加,将严重恶化污泥混合液的可滤性.     

投加氢氧化铁对SMBR中活性污泥性能的影响

试验研究了在SMBR中投加不同量氢氧化铁对出水水质以及膜污染的影响。结果表明,生物铁-SMBR中随氢氧化铁投加量的增加,COD出水及去除率略有提高;氢氧化铁投加量为5%时,对活性污泥的活性促进作用最强;活性污泥SVI的降低主要是氢氧化铁絮体本身的化学絮凝作用所致;试验条件下氢氧化铁最佳投加量为混合液污泥浓度的5%时,半透膜压增长最慢,膜污染程度最轻。     

The effect of coupling coagulation and flocculation with membrane filtration in water treatment： A review

Water supply and sanitation demands are foreseen to face enormous challenges over the coming decades to meet the fast growing needs in a global perspective. Significant growth in the industry is predicted and membrane separation technologies have been identified as one of the possible solutions to meet future demands. Application and implementation of membrane technology is expected both in production of potable water as well as in treatment of wastewater. In potable water production membranes are substituting conventional separation technologies due the superior performance, potential for less chemical use and sludge production, as well as the potential to fulfill hygienic barrier requirements. Membrane Bio-Reactor (MBR) technology is probably the membrane process which has had most success and has the best prospects for the future in wastewater treatment. Trends and developments indicate that this technology is becoming accepted and is rapidly becoming the best available technology (BAT) for many wastewater treatment applications. A major drawback of MBR systems is membrane fouling. Studies have shown that fouling mitigation in MBR systems can potentially be done by coupling coagulation and flocculation to the process.     

超滤膜深度处理煤制气废水的化学清洗研究

用实验室自制超滤膜系统深度处理煤制气废水。采用扫描电镜和能谱分析比较了质量为一定浓度均为0．5％的NaC10溶液（有效氯为5％）、NaOH溶液,HCl溶液对污染膜丝内表面滤饼层的静态浸泡效果。为进一步确定不同清洗剂的化学清洗效果,选用质量浓度为0．25％的NaOH溶液和0．25％的NaCl0溶液对污染膜组件进行了手动化学清洗并通过过滤纯水确定清洗效率。结果显示,NaC10溶液和NaOH溶液对滤饼层分别具有溶解和剥离作用,从而对滤饼层起到了去除作用;能谱分析显示采用这两种清洗剂后的膜丝内表面元素组成与原膜较为接近,SEM分析则显示二者在去除滤饼层的同时对膜袁面性状均有一定程度的改变;而经HCl溶液浸泡后的膜丝滤饼层未见去除,能谱分析显示此时膜丝内表面的元素组成与原膜有显著差异。手动化学清洗结果进一步显示,0．25％的NaCl0溶液对膜组件的清洗效率可达到97％。     

纳滤膜技术在地下水除砷应用中的研究进展

砷污染突发事件的频发严重威胁着地下水饮用水水源的水质安全,加之饮用水控制标准的提高,就对饮用水除砷技术提出了更高的要求,而纳滤(NF)膜分离技术为饮用水除砷提供了新的思路。首先概述了地下水中砷的存在形态、化学性质以及我国高砷地下水地区分布,然后分析了NF膜特点、除砷机理与性能,系统地阐述了各种因素包括膜操作因素（操作压力、膜回收率、膜排布方式等）和原水水质因素（pH、水温、共存离子、共存有机物及砷浓度与砷价态等）,对NF膜除砷性能的影响。此外,对NF除砷的关键问题,如原水预处理、膜浓水处理、膜污染及其清洗等,也作了探讨。最后,总结了目前NF除砷应用中所面临的问题,探索性提出了NF膜技术在除砷应用中的研究方向。     

膜生物反应器内流场动力学特性的PIV实验研究

浸没式膜生物反应器系统内膜面附近的气液两相流动力学特性对控制浓差极化和膜污染具有重要影响。应用粒子图像测速(PIV)技术对浸没式膜生物反应器内近膜面的液相流场动力学特性进行了研究。采用相分离技术灰度分辨法将通过PIV技术得到的气液两相流场图像中的液相速度场进行辨别,得到膜面附近的液相流场数据,并应用Tecplot软件计算得出液相流的涡量特性。在3 mm曝气孔径,2.5、3.0、3.5、4.5、5.5和6.5 m3/h 6种曝气强度下分析了膜面附近的液相速度场和涡量场。结果表明,曝气强度对液相流场和涡量场的影响较大,在一定范围内增加曝气强度可以使得液相速度和涡量增加,同时,分析了3 mm孔径下圆帽状气泡的动力学特性。研究结果为膜生物反应器系统的优化设计提供了研究经验和实验数据。     

生物强化对MBR系统生物特性及群落结构的影响

采用高效菌强化膜生物反应器对溴氨酸废水进行处理,考察了生物强化前后系统对溴氨酸的降解能力及其内部微生物生理状态变化.并采用核糖体基因间隔序列分析技术(RISA)解析了高效菌投加前后污泥系统的群落变化.实验表明,投菌后在进水负荷增加的条件下,上清液和膜出水的溴氨酸脱色率分别约为50%和65%,相应的COD去除率分别约为25%和50%,和投菌前基本保持一致;TTC-脱氢酶活性和胞外聚合物(EPS)浓度略有波动,但是运行一段时间后即恢复到投菌前水平.群落分析表明高效菌可以在系统中稳定存在,并且不对原菌群结构造成较大影响.     

光导纤维生物膜碘荧光传感器的研究

把荧光素固定在经处理的生物膜上,研制成光导纤维生物膜碘荧光传感器。Ｉ－的线性响应范围为３×１０－５ｍｏｌ／Ｌ—５×１０－３ｍｏｌ／Ｌ,相对标准偏差为０６５％,响应时间为２５～３５ｍｉｎ。