铝型材废水治理工程的设计与运行

针对铝型材废水中含有大量铝、锌、镍、铜等金属离子和pH值呈酸性的特性,以昆明某铝型材厂生产废水治理工程为例,介绍该工程以中和调节+混凝沉淀+过滤的治理工艺的设计及其运行效果.     

铁氧体法处理电解锌厂生产废水

在对广西某电解锌厂的金属废水分析的基础上 ,采用铁氧体法对其产生的含铜、锌废水进行工程实际处理 ,运行结果表明 ,处理效果十分稳定。进水Cu2 +、Zn2 +浓度为 2 5mg/L ,1 2 0 0mg/L左右 ,pH为 2 .0 ,出水pH为 8.0左右 ,Cu2 +,Zn2 +浓度为 0 .1mg/L ,1 .0mg/L ,并对运行中的一些问题进行了讨论。     

Microbial Fe(III) Reduction in Acidic Mining Lake Sediments after Addition of an Organic Substrate and Lime

To elucidate the role of Fe(III) reduction in mining lake sediments amended with organic substrates, we performed a large (10 m diameter) enclosure experiment in which sediments were amended with Carbokalk, a waste product from sugar industry containing organic carbon and lime. Fe(III) reduction rates were determined monthly by measuring the accumulation of Fe(II) in the sediments in the field. Fe(III) reduction rates were also determined by incubating sediment samples with synthetic Fe(III) oxyhydroxide under in situ temperature in the laboratory. Sulfate reduction was selectively inhibited in the Fe(III) reduction experiments by addition of sodium molybdate. Sulfate reduction was measured by accumulation of reduced inorganic sulfides in the field and by ³⁵S radiotracer using a core injection technique. Sediment incubation and determination of sulfate reduction rates with radiotracer showed that sulfate reduction and direct microbial Fe(III) reduction occured simultaneously in the upper centimeters of the sediments and that both processes contributed to alkalinity generation. However, Fe(III) reduction was the initial process and rates were at least 3.5 fold higher than sulfate reduction rates. The results indicate that the presence of suitable anions for Fe(II) precipitation as carbonate or sulfide is needed in order to prevent loss of potential alkalinity by Fe(II) diffusion and reoxidation in the water column.     

Phosphorus release from phosphate rock and iron phosphate by low-molecular-weight organic acids

Low-molecular-weight(LMW) organic acids widely exist in soils, particularly in the rhizosphere. A series of batch experiments were carded out to investigate the phosphorus release from rock phosphate and iron phosphate by low-molecular-weight organic acids.Results showed that citdc acid had the highest capacity to solubilize P from both rock and iron phosphate. P solubUization from rock phosphate and iron phosphate resulted in net proton consumption. P release from rock phosphate was positively correlated with the pκa values. P release from iron phosphate was positively correlated with Fe-organic acid stability constants except for aromatic acids, but was not correlated with pκa. Increase in the concentrations of organic acids enhanced P solubilization from both rock and iron phosphate almost linearly. Addition of phenolic compounds further increased the P release from iron phosphate. Initial solution pH had much more substantial effect on P release from rock phosphate than from iron phosphate.     

Catalytic degradation of methylene blue by Fenton like system: model to the environmental reaction

To develop more efficient chemical methods for the demineralization of organic pollutants from water bodies, which one was also mimic to the nature, a degradation of methylene blue by Fe( Ⅲ ) and H2O2 in the absence of light instead of Fe( Ⅱ ) and H2O2 was studied. Results showed that use of Fe ( Ⅲ ) is more promising than Fe( Ⅱ ). The present study reflects that Fenton reaction is more efficient, in the presence of a small amount of salicylic acid is added which is a one of the priority pollutant.     

液相络合-铁粉还原-酸吸收回收法脱除烟气中NO

提出了Fe2+螯合剂络合-铁粉还原-酸吸收回收法脱除烟气中NO的新工艺,重点研究了模拟烟气中O₂含量对NO络合量的影响,以及铁粉用量、铁粉粒径和搅拌速度对脱氮效率的影响,确定了最佳的铁粉脱氮工艺条件,并对铁粉和铁屑的脱氮效果进行了比较.结果表明:烟气中φ(O₂)从0增加到4.2%,NO络合量下降90.2%;脱氮效率随铁粉用量和反应器搅拌速度的增加而增加,随铁粉粒径的增加而降低;最佳工艺参数为,铁粉用量0.8 g,铁粉粒径≥200目(≤0.077 mm),搅拌速度900 r/min,在该条件下,对φ(O₂)为5%的模拟烟气在搅拌反应器中可取得90%以上的脱氮效率;用铁粉在1台搅拌反应器中取得的脱氮效率和用铁屑在2个鼓泡反应器串联时所取得的效率相当.      

程序升温条件下铁及其氧化物在CO存在时对N2O的还原机理

应用热综合分析仪（TG－FTIR）研究了在还原性气氛下Fe及其氧化物对N2O的催化还原 作用。研究发现铁氧化物对氮氧化物的催化还原能力相当弱，而Fe可以高效地降低N2O分解的初始温度和提高N2O向N2的转化率。在Fe和CO的作用下，N2O的初始分解温度为920K和1000K。在1123K时，N2O的转化率达到95％和805。TG／DSC曲线表明了在Fe与N2O反应过程中CO的作用表现为通过与N2O在反应表面的竞争吸附使铁氧化物还原为金属铁，X射线衍射证明Fe与N2O反应后的氧化物为Fe2O3；扫描电镜对反应后Fe表面物理形态的研究发展，在CO作用下，Fe的表面呈松散结构，可以保证Fe对氮氧化物反应的连续进行。     

航天继电器用AgCuONiO电接触材料的电寿命服役性能研究

目的 探究一种可替代AgCdO的高性能且环境友好的新型电接触材料,以提升航天继电器的可靠性。方法 在一定条件下以合金内氧化法制备AgCuONiO电接触材料,并与商用AgCdO电接触材料进行对比,利用电寿命模拟试验分析2款材料的电寿命循环服役性能,分析其失效机理。结果 AgCuONiO材料的总质量损失为0.000 88 g,平均燃弧时间、燃弧能量、熔焊力、回跳次数、回跳时间、回跳能量分别为4 222μs、694 mJ、0.049 N、1.799次、592.999μs、63.892 mJ,均大于商用AgCdO电接触材料,但其接触电阻低,且稳定,失效模式为无法分断电弧,而商用AgCdO电接触材料为粘连失效。AgCuONiO电接触材料的电寿命服役周期为44073次,是AgCdO电接触材料的3倍左右,因此可以显著提高航天继电器的可靠性。结论AgCuONiO电接触材料的一些电寿命服役性能虽然不如商用AgCdO电接触材料,但其电寿命服役周期明显强于商用Ag Cd O电接触材料,可作为替代AgCdO的较佳候选材料之一,应用于服役寿命要求更长的航天继电器。     

纳米零价铁改性膜强化厌氧生物处理氯酚废水

针对厌氧生物技术处理氯酚废水驯化周期长和纳米零价铁易团聚的问题,采用压滤法制备纳米零价铁改性聚偏氟乙烯膜（nZVI@PVDF）,并将其与厌氧生物体系耦合处理氯酚废水,通过序批实验探究nZVI@PVDF对耦合体系脱氯、水解酸化、产甲烷阶段的影响.结果表明,48h内,包含3种不同nZVI负载量（0.075,0.15,0.3g）的nZVI@PVDF膜耦合体系的2-氯酚（2-CP）去除率分别为99%、97.6%和91.8%,而未添加nZVI@PVDF的对照组仅为62.7%;72h内耦合体系的COD去除率分别为88.2%、89.1%、89.4%,而对照组COD去除率为63.6%;耦合体系的顶空甲烷占比分别为25.16%、25.98%、26.80%,而对照组仅为16.82%.投加产甲烷抑制剂的条件下,nZVI@PVDF刺激了脂肪酸的生成.nZVI@PVDF促进了氯酚的脱氯、脂肪酸和甲烷的生成.     

超声波强化内电解对对-硝基苯酚的处理

讨论了超声波与内电解处理的可行性。优化超声波、内电解和两者联用的条件,利用常用流程处理10mg/L模拟废水对-硝基苯酚的降解率超过96%,达到国家排放标准和相关行业标准。分析了超声波对内电解强化作用的动力学过程和机理,提出存在的问题和进一步研究的方向。