仿酶型磁性Fe~0-Fe_3O_4复合催化剂的制备及其催化性能

采用原位氧化沉淀法制备出仿酶型磁性Fe0-Fe_3O_4复合催化剂,并将其作为非均相类Fenton催化剂用于溶液中对硝基苯酚的降解;采用SEM和XRD等技术对催化剂进行了表征。表征结果显示,Fe_3O_4与Fe0结合牢固,有利于Fe0的分散。实验结果表明:Fe0-Fe_3O_4对对硝基苯酚的降解为拟一级反应;在Fe0与Fe_3O_4的质量比为0.75、Fe0-Fe_3O_4投加量为1.2 g/L、初始H_2O_2浓度为10 mmol/L、初始溶液p H为3、反应温度为30℃的条件下反应90min,反应速率常数为0.067 min-1,COD去除率为77.28%,Fe溶出量为2.12 mg/L;在对硝基苯酚的降解过程中,pH先增大后减小,Fe溶出量先降低后升高;Fe0-Fe_3O_4是一种稳定的催化剂,可再生使用。     

氧化石墨烯负载纳米零价铁的制备及其对亚甲基蓝的吸附

采用液相还原法制备氧化石墨烯负载纳米零价铁吸附剂(Fe0/GO),并用于吸附去除溶液中的亚甲基蓝(MB)。考察了溶液p H、吸附温度、吸附时间、初始MB质量浓度对Fe0/GO吸附MB的影响。SEM等表征结果显示:Fe0以球形或短链形负载在GO上,增加了材料的反应活性位点;Fe0/GO的比表面积为158.32 m2/g,等电点为3。实验结果表明:在溶液p H为6、吸附时间5 h、吸附温度25℃的最佳条件下,加入400 mg/L的Fe0/GO,处理初始MB质量浓度为160 mg/L的MB溶液,MB去除率为89.26%,吸附量为125.5 mg/g;Langmuir等温吸附方程和Frenudlich等温吸附方程均能较好地描述Fe0/GO对MB的吸附过程;Fe0/GO对MB的吸附行为遵循准二级动力学方程;计算得出吸附温度为25℃、初始MB质量浓度为160 mg/L时的饱和吸附量为201.2 mg/g,平衡吸附量为124.3 mg/g。     

黄钠铁矾法氧化去除废锂电池硫酸浸出液中的铁

废锂电池中含有的Co、Ni和Cu等金属具有回收价值,Fe的存在降低了有价金属的回收效率。为去除废锂电池硫酸浸出液中的Fe,采用黄钠铁矾法分别以氯酸钠和过氧化氢作为氧化剂氧化除Fe,并优化了过氧化氢作为氧化剂的除Fe工艺参数。实验结果表明:过氧化氢作为氧化剂的除Fe效果好于氯酸钠;在n(H2O2)∶n(Fe)=0.5、初始溶液pH为1.8、终点pH为2.5、反应时间为2.0 h、搅拌速率为500 r/min的最佳工艺条件下,初始ρ(Fe)为0.212g/L的硫酸浸出液经除Fe处理后ρ(Fe)小于0.004 g/L,Fe去除率达98.0%,Co、Ni和Cu的损失率分别为1.04%、2.17%和1.41%。     

土壤还原过程对氯代有机污染物还原脱氯的影响与机制

自然环境中,大多数氯代有机污染物厌氧还原脱氯反应是与土壤环境中一些生源要素的生物化学还原过程相伴生。有机污染物的种类、生物有效性以及毒性能够显著影响这些生源要素的转化,反过来,土壤中活跃的氧化还原反应也可以显著影响有机污染物的动力学转化过程。本文从氧化还原顺序上综述了反硝化过程、铁还原过程、硫酸盐还原过程和产甲烷过程对氯代有机污染物厌氧还原脱氯过程的影响与作用机制,旨在为氯代有机污染物在厌氧环境中还原脱氯的过程与机理的进一步研究、以及还原脱氯与微生物介导的生源要素氧化还原过程的耦合作用机制的揭示提供参考。     

中国城市包容度与流动人口的社会融合

当前中国流动人口规模、流向、结构、流动模式和群体利益诉求都在发生深刻变化,滋生出一系列经济社会发展的重大问题,其中社会融合问题受到各界最广泛关注。社会融合问题从城市层面看就是"城市包容度"问题,该命题新、难度大、范围广,国内外研究成果较少。本研究以此为核心,创新性构建了以社会保险参加情况、劳动权益保障程度、公共服务享受范围为主要准则的城市包容度综合指标体系,运用主成分分析法合成"城市包容度综合指数",进而通过非线性离散选择模型探讨流动人口长期居住意愿、落户难度、就业稳定度与城市包容度指标之间的相关关系。基于国家卫生计生委流动人口动态监测数据(2013—2014年)开展研究,主要结论为:中国城市包容度水平越高的城市,流动人口长期居住意愿越强、落户越容易、就业越稳定。进而提出政策建议:建立完善的城市流动人口服务和安置政策体系,直接和间接促进流动人口社会融合;形成有效融合机制,实现居民福利最大化及城市协同发展;制定科学的产业政策和户籍制度,引导匹配城市产业结构的人口流入,实现合理布局;结合顶层设计与基层探索,实现城市包容性增长与制度改进。本文归纳总结出"两个新体系":建立了城市包容度综合指数测算体系,及应用城市包容度指数定量研究的范式体系。     

Effects of initial iron corrosion rate on long-term performance of iron permeable reactive barriers: Column experiments and numerical simulation

Column experiments and numerical simulation were conducted to test the hypothesis that iron material having a high corrosion rate is not beneficial for the long-term performance of iron permeable reactive barriers (PRBs) because of faster passivation of iron and greater porosity loss close to the influent face of the PRBs. Four iron materials (Connelly, Gotthart-Maier, Peerless, and ISPAT) were used for the column experiments, and the changes in reactivity toward cis-dichloroethene (cis-DCE) degradation in the presence of dissolved CaCO₃ were evaluated. The experimental results showed that the difference in distribution of the accumulated precipitates, resulting from differences in iron corrosion rate, caused a difference in the migration rate of the cis-DCE profiles and a significant difference in the pattern of passivation, indicating a faster passivation in the region close to the influent end for the material having a higher corrosion rate. For the numerical simulation, the accumulation of secondary minerals and reactivity loss of iron were coupled using an empirically-derived relationship that was incorporated into a multi-component reactive transport model. The simulation results provided a reasonable representation of the evolution of iron reactivity toward cis-DCE treatment and the changes in geochemical conditions for each material, consistent with the observed data. The simulations for long-term performance were also conducted to further test the hypothesis and predict the differences in performance over a period of 40 years under typical groundwater conditions. The predictions showed that the cases of higher iron corrosion rates had earlier cis-DCE breakthrough and more reduction in porosity starting from near the influent face, due to more accumulation of carbonate minerals in that region. Therefore, both the experimental and simulation results appear to support the hypothesis and suggest that reactivity changes of iron materials resulting from evolution of geochemical conditions should be considered in the design of iron PRBs.     

一种新型光催化剂用于降解腈纶废水研究

将1,10菲啰啉和铁Fe2+溶液配成络合物负载到D113树脂上作为可见光催化剂,利用该催化剂对腈纶废水进行了降解研究,考察了该负载型铁氮配合物催化剂处理腈纶废水的影响因素。由实验结果可知,该催化剂处理腈纶废水最佳条件为：过氧化氢浓度为400 mg/L,催化剂用量为5 g/L,最佳pH值范围为4～9,COD降解率可达68.7%,实现了在温和的反应条件下,即常温、常压、宽pH范围进行反应,充分利用了可见光来处理难降解有机物。     

pH对电解处理垃圾渗滤液的影响

在不同的pH值条件下对氯离子和重金属离子含量不同的渗滤液和邻硝基苯酚人工模拟废水进行了电解处理,着重考察了不同pH值条件下氯离子浓度和重金属离子种类对有机物电解去除效果的影响。结果表明,电解处理过程中, pH值对有机物电解去除效果的影响与渗滤液的水质有关,尤其与渗滤液中氯离子和重金属离子浓度以及重金属离子种类有关。在pH＝2的条件下电解处理氯离子和重金属离子含量均很低的渗滤液,有利于有机物的氧化去除;在pH=9的条件下电解处理氯离子和重金属离子浓度均较高的渗滤液,其COD的电解去除效果最好;在pH=2或pH=12的条件下电解处理氯离子浓度高而重金属离子浓度低的渗滤液,能促进有机物的氧化分解。在一定浓度范围内,渗滤液中无机变价离子的组成不同,电解处理垃圾渗滤液的最佳pH值也不同。     

涂铁石英砂吸附水中Cr（Ⅵ）的研究

采用静态吸附和动态过滤的试验方法研究了涂铁石英砂（IOCS）滤料对水中Cr（Ⅵ）的去除,并探讨其吸附机理。研究结果表明,Cr（Ⅵ）在IOCS上的吸附平衡符合Langmuir吸附模型。经氧化铁改性滤料表面电位带正电荷,对水中的Cr（Ⅵ）有良好的去除效果。pH值对Cr（Ⅵ）的去除影响较大,随着溶液的pH值升高,滤料表面电位减小,Cr（Ⅵ）的吸附率也减小。IOCS滤料去除Cr（Ⅵ）机理主要为静电吸附。     

Bioconcentration kinetics of PCBs in various parts of the lifecycle of the tadpoles Xenopus laevis

Polychlorinated biphenyls （PCBs） in Xenopus laevis have been reported only for a few congeners. Additionally, there is very little information on the ability of Xenopus laevis to bioconcentrate PCBs. To address these issues, the tadpole Xenopus laevis was exposed to Aroclor 1254 mixtures in water at room temperature for 110 d followed by an additional 110 d of nonspiked PCBs in the water for the control group. During the whole process, bioconcentration factors （BCFs） of PCBs ranged from 1180 to 15670. For most PCB congeners, the highest and lowest bioconcentrations of the kinetic curves were found to be remarkably simultaneous, respectively. All 141 PCB congeners under the same experimental conditions had no linear correlation on the lgBCF versus lgKow relationship. The relationship between lgBCFs and lgKow followed a parabolic pattern indicative of selective bioconcentration, suggesting that the kinetic curves of the PCB congeners observed in the lifecycle of the tadpoles may be concentrated due to the amphibian special species and internal metabolism. In contrast, lgBCFs for PCBs were inversely related to lgKow, suggesting that a metabolism of the higher Kow PCB congeners occurred. These results support the author＇s conclusion that the tadpole Xenopus laevis plays major roles in the bioconcentration of PCB congeners, and demonstrated that the exposure kinetic curves of PCB congeners are complex. Besides the amphibian metamorphous development, the lifecycle of the tadpole Xenopus laevis also may be of importance in determining the bioconcentration of PCB congeners.