Immobilization of Pb(II), Cd(II) and Ni(II) ions on kaolinite and montmorillonite surfaces from aqueous medium

The present study investigates the immobilization of Pb(II), Cd(II) and Ni(II) on clays (kaolinite and montmorillonite) in aqueous medium through the process of adsorption under a set of variables (concentration of metal ion, amount of clay, pH, time and temperature of interaction). Increasing pH favours the removal of metal ions till they are precipitated as the insoluble hydroxides. The uptake is rapid with maximum adsorption being observed within 180 min for Pb(II) and Ni(II) and 240 min for Cd(II). A number of available models like the Lagergren pseudo first-order kinetics, second-order kinetics, Elovich equation, liquid film diffusion and intra-particle diffusion are utilized to evaluate the kinetics and the mechanism of the immobilization interactions. Two isotherm equations due to Langmuir and Freundlich showed good fits with the experimental data. Kaolinite and montmorillonite have considerable Langmuir monolayer capacity with respect to Pb(II), Cd(II) and Ni(II), the values being in the range of 6.8-11.5mg/g (kaolinite) and 21.1-31.1mg/g (montmorillonite). The Freundlich adsorption capacity follows a similar order. The thermodynamics of the immobilization process indicates the same to be exothermic with Pb(II) and Ni(II), but endothermic with Cd(II). The interactions with Pb(II) and Ni(II) are accompanied by decrease in entropy and Gibbs energy while the endothermic immobilization of Cd(II) is supported by an increase in entropy and an appreciable decrease in Gibbs energy. The results have established good potentiality for kaolinite and montmorillonite to remove heavy metals like Pb(II), Cd(II) and Ni(II) from aqueous medium through adsorption-mediated immobilization.     

HAN阻隔防爆模型研究

通过合理简化,利用多方气体状态方程,分别建立油品储运容器内可燃混合气体定容爆炸模型和装设阻隔防爆材料的油品储运容器内可燃混合气体爆炸模型,获得了阻隔防爆性能测试装置的燃爆容器抗爆设计限值,以及其在HAN阻隔防爆测试中燃爆容器试爆压力量级的控制下限值,同时,还给出HAN工程应用中容器留空率的计算方法,具有实际指导意义。     

Toluene removal biofilter modeling: Optimization and case study

Based on the model proposed by De Visscher and Van Cleemput for methane oxidation in landfill cover soils, a simulation model for biofiltration of toluene-contaminated air has been developed for biofilters with substrate inhibition. A convenient way to optimize biofilter performance was developed assuming Haldane kinetics. It was calculated that for a typical oilsands operation emitting 200 ton of toluene annually, 90% of the toluene can be removed by a 740 m³ biofilter, if the waste gas sent to the biofilter has a toluene concentration of 2.25 g m⁻³. The optimal initial concentration increases with increasing target efficiency.     

苯蒸气在有机膨润土上的吸附动力学

本文研究了苯蒸气在溴化十六烷基三甲基胺（CTMAB）系列单阳离子有机膨润土上的吸附动力学过程。结果表明,苯蒸气在有机膨润土上的吸附符合一级动力学方程,即：r＝KvCo;在12h内,吸附反应均可达到平衡,吸附速率常数（Kv）与温度（T）成正相关,吸附反应的活化能在9．50－17．92kJ.mol^-1之间。     

海洋巨藻(Durvilaea potatorum)生物吸附剂对Hg~(2 )的吸附动力学研究

对经特殊的稳定化预处理所得的海洋巨藻 (Durvillaeapotatorum)生物吸附剂对Hg2 的吸附动力学进行了研究 ,报导了不同Hg2 初始浓度、温度以及生物吸附剂平均粒径下动态吸附量与时间的关系 .结果显示 ,各吸附动力学曲线呈优惠型 ;当生物吸附剂平均粒径为 0 .45mm时 ,Hg2 的半饱和时间tS均不超过 6 0min ;Hg2 初始浓度和生物吸附剂粒径越小 ,吸附温度越大 ,达到吸附平衡所需的时间越短 .在测试范围内 ,生物吸附剂的平衡吸附容量与粒径和温度无关 .同时考察了吸附过程中的传质效应并对液膜传质系数kL进行了关联 ,结果表明 :当吸附时间t≤tS时 ,Hg2 的吸附速率为液膜传质控制 ;在测试范围内 ,kL为 0 .0 40 7～ 0 .112cm/s.本研究结果为利用海洋巨藻 (Durvillaeapotatorum)生物吸附剂处理含汞废水的规模化应用提供了一定的依据 .图 5表 2参 11     

羊角月芽藻摄取磷形态的动力学研究

将湖水中的磷分成总溶解磷,溶解反应磷,总反应磷、溶解的水解性磷,溶解的光解性磷。研究其在羊角月芽过程中的变化。     

Vertical migration of radionuclides in undisturbed grassland soils

Literature data on numerical values obtained for the parameters of the two most popular models for simulating the migration of radionuclides in undisturbed soils have been compiled and evaluated statistically. Due to restrictions on the applicability of compartmental models, the convection–dispersion equation and its parameter values should be preferred. For radiocaesium, recommended values are derived for its effective convection velocity and dispersion coefficient. Data deficiencies still exist for radionuclides other than caesium and for soils of non-temperate environments.     

Diffusion mechanism of lindane into wood charcoal

Abstract

The wood charcoal treated by 1N HNO₃ (WCT) was used to remove toxic chlorinated pesticide lindane (y‐HCH) residue from water by the sorption process. Using a simple first order reversible kinetics constants and half time equations, the film and pore diffusion coefficients were determined. Film diffusion was found to be rate limiting step in sorbing lindane by WCT. This was further authenticated by kinetics studies at different initial sorbate concentrations, different sorbent sizes, and different agitation speeds besides interruption test. A pore diffusion model was used to fit the data of kinetics in continuously mixed batch reactors (CMBR), and the tortuosity, external resistance, and surface diffusion effects on lindane sorption by WCT were noticed. The tortuosity values of 15 to 28 were obtained for WCT‐lindane system.     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.     

Sorption and desorption kinetics of diuron,fluometuron, prometryn and pyrithiobac sodium in soils

Abstract

The sorption and desorption characteristics of four herbicides (diuron, fluometuron, prometryn and pyrithiobac‐sodium) in three different cotton growing soils of Australia was investigated. Kinetics and equilibrium sorption and desorption isotherms were determined using the batch equilibrium technique. Sorption was rapid (> 80% in 2 h) and sorption equilibrium was achieved within a short period of time (ca 4 h) for all herbicides. Sorption isotherms of the four herbicides were described by Freundlich equation with an r² value > 0.98. The herbicide sorption as measured by the distribution coefficient (K_d) values ranged from 3.24 to 5.71 L/kg for diuron, 0.44 to 1.13 L/kg for fluometuron, 1.78 to 6.04 L/kg for prometryn and 0.22 to 0.59 L/kg for pyrithiobac‐sodium. Sorption of herbicides was higher in the Moree soil than in Narrabri and Wee Waa soils. When the K_d values were normalised to organic carbon content of the soils (K_oC), it suggested that the affinity of the herbicides to the organic carbon increased in the order: pyrithiobac‐sodium < fluometuron < prometryn < diuron. The desorption isotherms were also adequately described by the Freundlich equation. For desorption, all herbicides exhibited hysteresis and the hysteresis was stronger for highly sorbed herbicides (diuron and prometryn) than the weakly sorbed herbicides (fluometuron and pyrithiobac‐sodium). Hysteresis was also quantified as the percentage of sorbed herbicides which is not released during the desorption step ω = [n_ad / n_de ‐1] x 100). Soil type and initial concentration had significant effect on ω. The effect of sorption and desorption properties of these four herbicides on the off‐site transport to contaminate surface and groundwater are also discussed in this paper.