利用餐厨垃圾湿热处理脱出液制备液态菌肥研究

以餐厨垃圾湿热处理脱出液为发酵培养基,选用圆褐固氮菌(Azotobacter chroococcum)作为实验菌种制作固氮液态菌肥。测定了圆褐固氮菌的主要生理特性,将其接种于餐厨湿热处理脱出液中进行培养,确定最佳发酵时间,并分别测定发酵的最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例。结果表明:圆褐固氮菌在餐厨湿热处理脱出液中最佳发酵时间为36 h,发酵最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例依次为7.5、1%、30℃、150 r/min、50 m L(250 m L锥形瓶)、1∶1。圆褐固氮菌在餐厨垃圾湿热处理脱出液中进行培养后,可达到液态菌肥的活菌数标准。     

Tissue distribution of perfluoroalkyl acids and health status in wild Mozambique tilapia (Oreochromis mossambicus) from Loskop Dam, Mpumalanga, South Africa

This study examined concentrations of 15 perfluoroalkyl acids (PFAAs) in tissues from male Mozambique tilapia (Oreochromis mossambicus) collected at Loskop Dam, Mpumalanga, South Africa in 2014 and 2016. Nine of the 15 PFAAs were detected frequently and were included in statistical analysis and included two of the most commonly known PFAAs, perfluorooctanesulfonic acid (PFOS) (median, 41.6 ng/g) and perfluorooctanoic acid (PFOA) (median, 0.0825 ng/g). Of the tissues measured, plasma (2016 and 2014 median, 22.2 ng/g) contained the highest PFAA burden followed by (in descending order): liver (median, 11.6 ng/g), kidney (median, 9.04 ng/g), spleen (median, 5.92 ng/g), adipose (median, 2.54 ng/g), and muscle (median, 1.11 ng/g). Loskop Dam tilapia have been affected by an inflammatory disease of the adipose tissue known as pansteatitis, so this study also aimed to investigate relationships between PFAA tissue concentrations and incidence of pansteatitis or fish health status. Results revealed that healthy tilapia exhibited an overall higher (p-value < 0.05) PFAA burden than pansteatitis-affected tilapia across all tissues. Further analysis showed that organs previously noted in the literature to contain the highest PFAA concentrations, such as kidney, liver, and plasma, were the organs driving the difference in PFAA burden between the two tilapia groups. Care must be taken in the interpretations we draw from not only the results of our study, but also other PFAA measurements made on populations (human and wildlife alike) under differing health status.     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。     

基于质谱技术的在线大气颗粒物来源与污染过程解析研究——以江苏省淮安市为例

通过大气细颗粒物实时在线源解析技术(质谱直接测量法)采集录入淮安市市区部分特征污染源排放成分谱,对淮安市大气细颗粒物进行在线源解析,获取高时间分辨的颗粒物源解析结果,分析颗粒物来源、季度变化和重污染天气的污染过程,评估形成重污染过程的污染影响因子和影响程度,为区域大气污染综合整治提供重要目标指向,同时也为淮安环境空气PM2.5重度污染实时预警与监控、大气污染源减排方案评估、污染事件监控等提供有效的在线监测技术平台.     

聚合氯化铁-聚(环氧氯丙烷-二甲胺)复合絮凝剂在模拟水处理中的混凝特性研究

制备出一系列具有不同聚合氯化铁(PFC)的碱化度(B)、不同聚(环氧氯丙烷-二甲胺)[P(EPI-DMA)]质量分数[ω(E)]和黏度(η)的PFC-P(EPI-DMA)复合混凝剂,并将其用于模拟染料废水和模拟天然地表水的絮凝脱色处理,对比探讨了ω(E)、η和B对PFC-P(EPI-DMA)中铁的形态分布及其混凝效果的影响,以及混凝作用机制.结果表明,复合絮凝剂中铁的有效形态含量随ω(E)的增大而不断降低;η=850 mPa.s时,复合混凝剂中铁的有效形态含量最高;随B值的增大,Feb含量先增大后减少,而Fec含量逐渐增大.一定程度上使用预水解程度较低、有机成分黏度较大的PFC-P(EPI-DMA)有利于混凝效果的提高,复合混凝剂中有机成分质量分数对混凝效果的影响则与处理对象有关.在模拟水处理中,复合混凝剂依靠电性中和及架桥吸附能力发挥混凝特性.     

氟虫双酰胺在水稻和稻田中的残留动态研究

采用超高效液相色谱法(UPLC)测定了氟虫双酰胺19.8%悬浮剂(SC)在水稻及稻田环境中的残留动态.结果表明,当氟虫双酰胺及其代谢产物NNI-des-iodo的添加量为0.05～1.0 mg·kg-1时,其在水稻田土壤、田水、稻秆、稻米和稻壳中的平均回收率为78.2%～104.8%,变异系数为1.1%～4.4%.氟虫双酰胺在2011年三地(福建福州、天津、江苏南京)的稻田水中的降解半衰期为9.8～17.3 d,土壤中10.8～22.4 d,植株中7.6～17.3 d,其在稻田水样品中检出了代谢产物NNI-des-iodo,而在土壤和植株样品中未检出.在推荐使用剂量下,于末次施药10 d后,氟虫双酰胺在水稻稻米中的残留量均低于美国规定的在稻谷上的最大残留允许量(0.5 mg·kg-1).     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

Simultaneous preconcentration of cadmium and lead in water samples with silica gel and determination by flame atomic absorption spectrometry

A new method that utilizes pretreated silica gel as an adsorbent has been developed for simultaneous preconcentration of trace Cd(II) and Pb(II) prior to the measurement by flame atomic absorption spectrometry. The effects of pH, the shaking time, the elution condition and the coexisting ions on the separation/preconcentration conditions of analytes were investigated. Under optimized conditions, the static adsorption capacity of Cd(II) and Pb(II) were 45.5 and 27.1mg/g, the relative standard deviations were 3.2% and 1.7% (for n = 11), and the limits of detection obtained were 4.25 and 0.60 ng/mL, respectively. The method was validated by analyzing the certified reference materials GBW 07304a (stream sediment) and successfully applied to the analysis of various treated wastewater samples with satisfactory results.     

Homogeneous and heterogeneous reactions of anthracene with selected atmospheric oxidants

The reactions of gas-phase anthracene and suspended anthracene particles with O3 and O3-NO were conducted in a 200-L reaction chamber, respectively. The secondary organic aerosol (SOA) formations from gas-phase reactions of anthracene with O3 and O3-NO were observed. Meanwhile, the size distributions and mass concentrations of SOA were monitored with a scanning mobility particle sizer (SMPS) during the formation processes. The rapid exponential growths of SOA reveal that the atmospheric lifetimes of gas-phase anthracene towards O3 and O3-NO are less than 20.5 and 4.34 hr, respectively. The particulate oxidation products from homogeneous and heterogeneous reactions were analyzed with a vacuum ultraviolet photoionization aerosol time-of-flight mass spectrometer (VUV-ATOFMS). Gas chromatograph/mass spectrometer (GC/MS) analyses of oxidation products of anthracene were carried out for assigning the time-of-flight (TOF) mass spectra of products from homogeneous and heterogeneous reactions. Anthrone, anthraquinone, 9,10- dihydroxyanthracene, and 1,9,10-trihydroxyanthracene were the ozonation products of anthracene, while anthrone, anthraquinone, 9-nitroanthracene, and 1,8-dihydroxyanthraquinone were the main products of anthracene with O3-NO.     

LNAPLs污染物在层状非均质多孔介质中的运移试验研究

文章通过室内试验研究层状非均质多孔介质中轻非水相液体(Light Non-Aqueous Phase Liquid,LNAPL)的运移机制与分布特性。首先,在二维砂槽上进行LNAPL的入渗试验,试验过程中用数码相机进行拍照,把LANPL的扩散过程以图像的形式记录下来;然后,用AutoCAD对图片进行分析处理,得出不同时刻LNAPL的入渗锋面变化图。结果发现,介质结构突变面改变了LNAPL的迁移模式。在LNAPL由中砂进入细砂层后,由于受到毛细作用的增强,其运移速度加快;而由中砂进入粗砂,受粗砂介质阻滞作用增强的影响,LNAPL运移速度变小。当LNAPL由干砂进入湿润砂体时,由于孔隙水浮托力增大,LNAPL先产生纵向运移,随后以横向迁移的形式在地下水位上部聚积。当达到一定厚度后,LNAPL的压头足以克服浮托力,驱替孔隙水进入砂土孔隙。另外,LNAPL的厚度足够大时,方可克服饱水层受到的浮托力,在地下水位上形成LNAPL池,并因孔隙水向周围砂体排泄,LNAPL池周围的水位上升。