磷酸铵镁沉淀法预处理垃圾渗滤液

探讨了用磷酸铵镁沉淀法预处理垃圾渗滤液时,沉淀剂种类、pH值、物质摩尔配比和反应时间等因素对氨氮去除效果的影响。得出了处理氨氮浓度为2 677.34 mg/L的垃圾渗滤液时,在兼顾所用镁盐量尽量低和处理出水氨氮或磷酸盐的残留量都比较低的较佳实验条件为:沉淀剂种类为:MgSO4.7H2O和Na2HPO4.12H2O,反应时间为20 min,pH=9.5,n(Mg)∶n(P)∶n(N)=1.3∶1.15∶1.0。在较佳实验条件下,垃圾渗滤液的NH3-N去除率为97.05%,处理出水PO34--P含量为8.35 mg/L,NH3-N含量为75.86 mg/L。对所得沉淀物进行了成分分析和X-衍射光谱、扫描电镜表征,表明大部分沉淀物为磷酸铵镁物质。     

Scale-up modeling of the twin roll casting process for AZ31 magnesium alloy

In the present study, a 2-D finite-element method (FEM) thermal-fluid-stress model has been developed and validated for the twin roll casting (TRC) of AZ31 magnesium alloy. The model was then used to quantify how the thermo-mechanical history experienced by the strip during TRC would change as the equipment was scaled up from a laboratory size (roll diameter = 355 mm) to a pilot scale (roll diameter = 600 mm) and to an industrial scale (roll diameter = 1150 mm) machine. The model predictions showed that the thermal history and solidification cooling rate experienced by the strip are not affected significantly by caster scale-up. However, the mechanical history experienced by the strip did change remarkably depending on the roll diameters. Casting with bigger rolls led to the development of higher stress levels at the strip surface. The roll separating force/mm width of strip was also predicted to increase significantly when the TRC was scaled to larger sizes. Using the model predicted results, the effect of both casting speed and roll diameter was integrated into an empirical equation to predict the exit temperature and the roll separating force for AZ31. Using this approach, a TRC process map was generated for AZ31 which included roll diameter and casting speed.     

用碳化法从制碱废渣一次盐泥中制取轻质氧化镁的研究

本研究是用制碱废渣一次盐泥作原料，采用二氧化碳碳化法制取轻质氧化镁。同时分析了提取轻质氧化镁后的残渣用于制造水泥或其它胶凝材料的原料的可行性。     

镁合金的大气腐蚀研究

综述了各种因素对镁合金大气腐蚀的影响,其中介绍了单一因素NaCl及两种因素协同作用对镁合金大气腐蚀的影响。同时介绍了镁合金大气电偶腐蚀的影响因素与Al含量对镁合金大气腐蚀的影响。简述了研究镁合金大气腐蚀的几种常用表征手段。     

碳酸镁与镉离子的吸附和沉淀作用研究

以碳酸镁为吸附剂,在镉离子初始浓度为0~6 mmol/L,初始pH值为4和7的条件下,研究了碳酸镁与镉离子的吸附与沉淀作用。结果表明,由于碳酸镁的溶解及与体系中氢离子的中和,碳酸镁—镉体系的最终pH值为10.4左右;体系的平衡pH值随着镉离子初始浓度的增加而减小;体系中镉的平衡浓度随着初始镉离子浓度的增加缓慢上升;碳酸镁对镉的吸附等温线为折线型,不符合Freundlich和Langmuir模型,符合伪二阶吸附动力学模型。结合碳酸镁吸附镉前后固相表征的结果,说明碳酸镁与镉离子的作用机制随着镉离子浓度的增加,从离子交换发展为离子交换和表面配位反应并存,最后表现为表面沉淀。     

氧化镁烟气脱硫反应特性研究

利用实验室规模的鼓泡式反应装置,对比了碳酸钙、氧化镁和氧化镁/硫酸镁脱硫剂的反应活性,证实脱硫液中高浓度硫酸镁的存在是保证镁法脱硫效率高于钙法的重要因素,并考察了硫酸镁浓度、脱硫剂(氧化镁)浓度、烟气量、SO2浓度和吸收液温度等因素对脱硫效率的影响。结果表明,脱硫反应可以根据pH分为2个不同阶段;反应过程中脱硫效率随着硫酸镁浓度的增加而显著升高;烟气量增加将会导致脱硫效率有所下降;入口SO2浓度升高,脱硫效率下降;氧化镁浓度、温度对脱硫效率影响不显著。结合实验现象进行推断,氧化镁脱硫的反应过程受SO2在气液两相界面的传质扩散和其水解产物在液相的扩散控制。     

Feasibility of vermicomposting dairy biosolids using a modified system to avoid earthworm mortality

Abstract

A laboratory study was conducted to examine the feasibility of vermicomposting dairy biosolids (dairy sludge), either alone or with either of the bulking agents ‐ cereal straw or wood shavings, using the epigeic earthworm ‐ Eisinea andrei. Earthworms added directly to these three substrates died within 48 hours. A system was developed to overcome the toxic effect of unprocessed dairy biosolids. The substrates were placed over a layer of vermicomposted sheep manure into which the earthworms were inoculated. Within two weeks, all earthworms were within the upper layer of substrate. Compared to sheep manure which is a favourable substrate for vermicomposting, the three substrates containing dairy biosolids were more effective in supporting earthworm growth and reproduction. The final products obtained after 63 days of vermicomposting had 39–53% less organic carbon than the initial substrates. Organic fractionation indicated that vermicomposting increased the stability of the materials to biological decomposition. The vermicomposts obtained from the three substrates with dairy biosolids had low heavy metal contents and electrical conductivities, and did not inhibit plant growth when compared with a commercial vermicompost in a bioassay.     

Phytoavailability and extractability of potassium,magnesium and manganese in calcareous soil amended with olive oil wastewater

Abstract

Land disposal of olive oil wastewater using it as a soil amendment requires a knowledge of the effects that its application may produce on the status of the mineral nutrients in the plant‐soil system. A pot experiment using calcareous soil was performed in a growth chamber to examine the effects of olive oil wastewater on the availability and postharvest soil extractability of K, Mg and Mn. The experiment included 6 treatments: two rates of olive oil wastewater, two mineral fertilizer treatments containing K (which supplied K in amounts equivalent to the K supplied by the olive oil wastewater treatments), a K‐free mineral fertilizer treatment, and a control. The pots were sown with ryegrass as the test plant, harvesting 3 times at intervals of one month. Olive oil wastewater has demonstrated a considerable capacity for supplying K that can be assimilated by the plant, tending in fact to surpass the mineral potassium fertilizer tested. The application of olive oil wastewater tends to reduce the concentration of Mg in the plant, similarly to the effect of adding mineral potassium fertilizer. An enhancement of Mn availability takes place in the soil amended with olive oil wastewater, which on occasion has produced Mn concentrations in plant that could be considered phytotoxic or at least excessive. After harvesting, we observed an increase in the amount of exchangeable K in soil with added industrial wastewater. However, these increases are lower than those in soil treated with mineral potassium fertilizer. The levels of exchangeable, carbonate‐bound, organic‐bound and residual Mg in soil were higher in treatments incorporating olive oil wastewater than in those with added mineral K, with the opposite tendency occurring in the amount of Fe‐Mn oxides‐bound Mg in soil. Treatments based on olive oil wastewater, especially in high doses, increased the amount of exchangeable and carbonate‐bound Mn in soil, in comparison with treatments adding mineral fertilizers with or without K. In contrast, the addition of industrial wastewater caused a drop in the amount of Fe‐Mn oxides‐bound and organic‐bound Mn in soil.     

Removal of famoxadone,fluquinconazole and trifloxystrobin residues in red wines: Effects of clarification and filtration processes

The effects of six clarification agents [egg albumin, blood albumin, bentonite + gelatine, charcoal, polyvinylpolypyrrolidine (PVPP) and silica gel] on the removal of residues of three fungicides (famoxadone, fluquinconazole and trifloxystrobin) applied directly to a racked red wine, elaborated from Monastrell variety grapes from the D.O. Region of Jumilla (Murcia, Spain) were studied. The clarified wines were filtered with 0.45 μ m nylon filters to determine the influence of this winemaking process in the disappearance of fungicide residues. Analytical determination of fluquinconazole and trifloxystrobin was performed by gas chromatography with electron captor detector (ECD), while that of famoxadone using an HPLC equipped with a diode array detector (DAD). Generally, trifloxystrobin is the fungicide that is the lowest persistent one in wines, except in the egg albumin study whereas, the most persistent one is fluquinconazole. The elimination depends on the nature of the active ingredient, though the water stability in the presence of light within it has more influence than the solubility and polarity of the product itself. The most effective clarifying agents were the charcoal and PVPP. The silica gel and bentonite plus gelatine were not enough to reduce considerably the residual contents in the wine clarified with them. In general terms, filtration is not an effective step in the elimination of wine residues. The greatest removal after filtration is obtained in wines clarified with egg albumine and bentonite plus gelatine, and the lowest in those clarified with PVPP.     

Flotability and flotation separation of polymer materials modulated by wetting agents

The surface free energy, surface tension and contact angles were performed to investigate the properties of wetting agents. Adsorption of wetting agents changes wetting behavior of polymer resins. Flotability of polymer materials modulated by wetting agents was studied, and wetting agents change significantly flotability of polymer materials. The flotability decreases with increasing the concentration of wetting agents, and the wetting ability is lignin sulfonate (LS) > tannic acid (TA) > methylcellulose (MC) > triton X-100 (TX-100) (from strong to weak). There is significant difference in the flotability between polymer resins and plastics due to the presence of additives in the plastics. Flotation separation of two-component and multicomponent plastics was conducted based on the flotability modulated by wetting agents. The two-component mixtures can be efficiently separated using proper wetting agent through simple flotation flowsheet. The multicomponent plastic mixtures can be separated efficiently through multi-stage flotation using TA and LS as wetting agents, and the purity of separated component was above 94%, and the recovery was more than 93%.