超滤处理含聚污水过程中通量衰减机理的研究

研究了超滤处理含聚合物污水过程中操作压力、膜面流速、聚合物浓度、料液流变性、阻力等影响因素对膜通量的影响,并进行理论分析,揭示了通量衰减机理.研究结果表明,通量衰减的机理是聚合物的浓差极化和凝胶层的形成,其次是原油和无机物对膜孔的堵塞.     

膜分离-光催化组合工艺中膜污染的控制

文章主要研究膜分离-光催化组合工艺中膜污染的控制措施。研究表明,该体系中,膜可逆阻力是造成膜污染的主要因素。通过减小抽吸压力,提高曝气强度,间歇抽吸等措施可以有效地减小膜可逆污染。实验表明:最佳抽吸压力为0.02MPa,经济曝气量为0.4 m3/h,采取抽吸13min、停抽2min的运行模式。膜不可逆污染可通过化学清洗加以去除。     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

挥发性有机废气治理技术进展

主要介绍了目前国内外有机废气（VOCs）治理的常用方法以及这些方法的原理和工艺流程,并对它们的特点进行了简单介绍。     

炼化企业闭路循环水系统缓蚀技术的研究与应用

分析了炼化企业闭路循环水系统腐蚀的原因,并以大庆石化公司所属化工一厂为试点,筛选了合适的缓蚀药剂,并经现场应用,达到了实用、经济、环保的目的。     

城市污水处理厂化学除磷工艺精确控制技术研究进展

现今自动控制系统已经广泛应用于城市污水处理厂。总结归纳了污水处理厂的化学除磷工艺,重点对加药过程控制的类型,包括手动控制系统、自动控制系统、智能控制系统进行较为详细的论述。最后针对传统污水处理厂存在的问题和不足,提出研究污水处理厂化学除磷工艺精确控制系统技术的必要性。     

含丙烯腈废水处理技术发展现状与试验研究

含丙烯腈废水危害大、难降解,而用生化法对该类废水进行预处理的难点在于工艺的选择。文章较系统地概述了含丙烯腈废水处理技术的发展现状,并重点研究了“水解酸化＋SBR工艺＋生物滤池技术”处理工艺的反应器启动阶段。研究结果表明：1．水解酸化工艺可用于含丙烯腈废水的处理;2．SBR反应器处理效果良好,COD的平均去除率在70％以上,而且对进水水质的变化适应性较强;3．生物滤池技术应用于废水处理可显著提高COD的去除率。上述研究成果为下一步进行水解酸化＋生物滤池技术＋SBR处理工艺的效果试验奠定了基础。     

生态修复技术在保护水库水源地中的应用

为改善和保证库区水体水质 ,有必要对生态系统受到破坏的水库水源地进行生态修复。结合水库水源地的自然、社会特点 ,提出对保护区内涧河、入库口门、库区等处及水土保持生态修复的设想 ,使水体水质得到净化 ,进而保证水库供水的可持续发展。     

UASCB-SMBR处理垃圾渗滤液的试验研究

研究了厌氧污泥复合床 (UASCB) 序批式膜生物反应器 (SMBR)串联工艺 ,处理垃圾渗滤液的工艺性能及影响因素 ,并与单纯的SMBR工艺进行了对比。试验结果表明 ,在进液COD浓度平均为 2 50 0mg/L ,NH+ 4-N平均浓度为 360mg/L ,厌氧反应器COD的负荷为 7～2 0kgCOD/m3·d ,SMBR负荷为 1～ 5kgCOD/m3·d,系统总水力停留时间为 1 4～ 2 8h时 ,该串联工艺COD去除率达到 92 %以上 ,NH+ 4-N的去除率在 80 %以上