微波消解法快速测定渗滤液化学需氧量

针对国标回流法测定化学需氧量消耗时间长,分析费用高等不足,研究了微波消解法测定垃圾渗滤液的试验方法.通过微波消解功率、消解时间、催化剂用量等试验,确定了微波消解测定渗滤液CODCr的最佳条件.该方法具有省时间、省试剂、准确度高等优点.     

ESTIMATION OF SOIL MOISTURE WITH API ALGORITHMS AND MICROWAVE EMISSION1

Large area soil moisture estimations are required to describe input to cloud prediction models, rainfall distribution models, and global crop yield models. Satellite mounted microwave sensor systems that as yet can only detect moisture at the surface have been suggested as a means of acquiring large area estimates. Relations previously discovered between microwave emission at the 1.55 cm wavelength and surface moisture as represented by an antecedent precipitation index were used to provide a pseudo infiltration estimation. Infiltration estimates based on surface wetness on a daily basis were then used to calculate the soil moisture in the surface 0–23 cm of the soil by use of a modified antecedent precipitation index. Reasonably good results were obtained (R²= 0.7162) when predicted soil moisture for the surface 23 cm was compared to measured moisture. Where the technique was modified to use only an estimate of surface moisture each three days an R² value of 0.7116 resulted for the same data set. Correlations between predicted and actual soil moisture fall off rapidly for repeat observations more than three days apart. The algorithms developed in this study may be used over relatively flat agricultural lands to provide improved estimates of soil moisture to a depth greater than the depth of penetration for the sensor.     

Microwave extraction of incurred salinomycin from chicken tissues

Abstract

A rapid, accurate, environmentally friendly and cost‐effective microwave extraction technique was developed for the extraction of spiked and incurred salmomycin from chicken tissues (kidney, liver, muscle, ovarian yolk and fat). Extraction of salinomycin from various tissues was achieved by irradiating the sample in absolute ethanol and 2‐propanol (15+2) for 9 sec. in a common household microwave oven. The extract was analysed without further cleanup by HPLC on a C₁₈ column (5 μm) and detected at 592 nm via post‐column reaction with 4‐dimethylaminobenzaldehyde (DMABA) in a heated reactor coil at 86° C. Recoveries of salinomycin from spiked tissues at 30 ng/g level ranged between 87 and 100%. The limit of quantitation was found to be 10 ng/g. The developed method was applied for the analysis of incurred tissues and ovarian yolk of laying chickens given sodium salinomycin in feed at different levels for 14 consecutive days followed by withdrawal periods. Residues were detected in all tissues and ovarian yolk at 0 withdrawal time but declined during the withdrawal period. Highest residue were found in fat and ovarian yolk.     

构造煤孔隙结构与瓦斯耦合特性研究

利用压汞法、低温氮吸附法、瓦斯等温吸附和解吸试验对平煤八矿构造煤和共生原生结构煤进行综合分析,探讨了构造煤孔隙结构与瓦斯耦合特性.结果表明,构造煤以微孔为主,中孔和大孔相对发育且含较多细颈瓶孔,孔隙连通性差.与共生原生结构煤相比,构造煤各孔径阶段的孔容和孔比表面积都有所增加.构造煤比表面积的增加具有阶段性,即孔径＜ 1.2 nm时为慢增加阶段,孔径=1.2 ～ 4.9nm时为快增加阶段,孔径＞4.9 nm时为稳定阶段.构造煤极限瓦斯吸附量a的增大与比表面积快增加阶段关系密切,但小于其BET比表面积的增幅.瓦斯解吸初期0～2 min内构造煤瓦斯解吸速度和解吸量明显大于共生原生结构煤,与中孔和大孔的变化一致,2 min以后瓦斯解吸迅速衰减.低煤体强度、高瓦斯含量的构造煤以气-煤共溶体形式储集更多弹性潜能,突然卸压时瓦斯膨胀能迅速释放,煤层中发育的构造煤增加了煤与瓦斯突出的危险性.     

微波诱导热解法制备落叶吸附剂及其工艺优化

采用微波诱导热解法制备低成本落叶吸附剂,以实现落叶的资源化利用.以碘吸附值为响应值,采用响应面分析法研究了微波诱导热解法制备落叶吸附剂的工艺条件.结果表明,热解时间与微波功率之间存在交互作用,当热解功率增加时,可适当缩短热解时间.落叶吸附剂的最佳制备工艺条件为:热解时间4.04 min,微波功率488.72W,氯化锌质量分数27％.落叶吸附剂以微孔吸附为主,BJH孔径分布较窄,孔容最高峰对应的孔径在1.9 nm左右,Langmuir比表面积为769.61 m2/g.     

空气氧化解吸NO络合吸收产物试验研究

Fe(Ⅱ) EDTA易被氧化为对NO无吸收能力的Fe(Ⅲ)EDTA,为实现Fe(Ⅱ)EDTA的循环使用,提出了Fe(Ⅱ)EDTA络合吸收-空气氧化解吸-铁屑还原再生组合脱除NO新工艺.采用空气氧化解吸络合吸收产物Fe(Ⅱ) EDTA (NO)中NO的方法,研究了温度及压力对Fe(Ⅱ)EDTA(NO)空气氧化解吸过程的影响.结果表明,0.4 MPa、333K为较优的解吸条件.该工艺可循环脱除NO,成本低、效率高,能有效回收NO2资源.     

黄壤表面电场作用下Cu~(2+)与Zn~(2+)的吸附/解吸动力学研究

利用静态恒流法研究了黄壤表面电场作用下Cu2+与Zn2+的吸附/解吸动力学.结果发现:考虑黄壤表面电场作用下,Cu2+和Zn2+的吸附实验呈现初期强吸附作用下的零级动力学过程和一定时间之后弱吸附作用下的一级动力学过程,与理论预期一致;在Cu2+和Zn2+的解吸实验中,只有前期出现了弱吸附作用下的一级动力学过程,实验结果与理论预期存在差别,原因在于专性吸附的Cu2+、Zn2+很难被解吸下来;在交换/吸附实验中,Cu2+的吸附速率值和平衡吸附量均大于Zn2+,且Cu2+-K+体系的表面电化学参数φ0、σ0、E0均大于Zn2+-K+体系中的对应值,证明了黄壤颗粒表面对Cu2+的吸附作用强于Zn2+;在交换/解吸实验中,Zn2+的解吸速率值和平衡解吸量均大于Cu2+,Zn2+-K+体系的表面电化学参数φ0、σ0、E0均大于Cu2+-K+体系中的对应值,证明Zn2+-K+体系中Zn2+的解吸作用比Cu2+-K+体系中的Cu2+解吸作用强.     

微波在废树脂中的穿透厚度研究

通过对不同功率微波在不同规格钢桶中对不同含水率的树脂中的穿透厚度的研究可知,微波在树脂中的穿透厚度主要与树脂自身含水率有关,与钢桶的规格尺寸也有一定的关系,而微波功率的影响则可基本忽略不计;对于含水率50％左右的树脂,微波在12L钢桶中的穿透厚度是130 mm;在200L钢桶中的穿透厚度是70mm.该研究成果对微波干燥工艺的具体参数的选取和扩大规模台架装置的设计研究等有重要意义.     

保定市区采暖与非采暖期环境空气污染状况研究

根据保定大气环境监测数据,对采暖与非采暖期的六项大气污染物浓度变化状况进行了分析.研究结果表明:细颗粒物、可吸入颗粒物、二氧化硫、二氧化氮、一氧化碳五项污染物,采暖期污染物浓度均值明显高于非采暖期,原因是市区集中供热率低,分散燃煤锅炉污染治理水平低,污染物排放量大,采暖期逆温日数多,不利于污染物的垂直扩散.臭氧非采暖期较采暖期明显增加,原因为采暖期过后云层变薄,光照加强,臭氧浓度升高.     

微波消解－ICP－MS法测定土壤中稀土元素的研究

建立了电感耦合等离子体质谱（ ICP－MS）测定土壤中稀土元素的分析方法。采用HNO3＋HF酸体系用微波消解对土壤样品进行处理,以混合内标（ In、Bi）校正基体干扰和信号漂移,用ICP－MS对其中的16种稀土元素进行了测定。在优化的实验条件下,16种稀土元素标准曲线的相关系数r＞0．9999,检出限为0.012 ng／ml～0.069 ng／ml,加标回收率为84.0％～110％,相对标准偏差（n＝6）RSD均小于3.5％。该方法可用于四种不同类型土壤中稀土元素含量的测定。