电晕放电等离子体烟气脱硫工业化试验

在四川绵阳5000-20000 m3／h装置上进行了电晕放电等离子体烟气脱硫试验。试验结果表明,水蒸气／氨放电活化均能够提高烟气脱硫效率。在水蒸气／氨活化及脉冲电晕联合作用下,烟气温度60-70℃,烟气含湿总量约10％,SO2初始体积分数1500×10-6,氨硫摩尔比2:1,系统耗能率约为4 W·h／m3时,脱硫效率达到93％,形成的副产物中(NH4)2SO4与(NH4)2SO3的质量比大于95:5。     

脉冲电湿式脱硫除尘技术及其在精锌冶炼炉的应用

介绍脉冲电湿式脱硫除尘技术及其在精锌冶炼炉上的应用。     

低温等离子体技术及其在柴油机排气处理中的应用

概述了等离子体特点及分类 ,介绍了低温等离子体的产生及其净化柴油机排气的应用进展 ,分析了低温等离子体技术有效处理柴油机排气的机理 ,阐述了未来低温等离子体处理柴油机排气的主要方向与应用前景。     

等离子体催化脱氮的实验研究

研究了等离子体和催化剂共同作用下氮氧化物的脱除情况 ,催化剂采用分子筛Cu ZSM 5。实验证明 ,在有催化剂存在的条件下 ,等离子体反应器的脱氮效率有了很大的提高 ,同时电源功率、烟气成分、温度、添加剂也都是影响实验结果的重要因素。     

等离子体技术在环境污染治理中的应用研究

阐述了等离子体的产生机理、方法、分类及特点,从大气污染、水污染和固体废物三方面论述了等离子体技术在环境污染治理中的应用进展,展现了等离子体技术在废物处理中的应用前景。     

脉冲放电等离子体治理甲苯废气放大试验研究

应用脉冲放电等离子体技术,在线板式反应器内对低浓度甲苯废气的治理进行放大试验.采用闸流管开关脉冲电源,其最大输出功率1kW,最大脉冲电压峰值100kV. 试验规模4～16m³·h^-1. 试验考察了峰值电压、重复频率、进口浓度和处理气量对甲苯去除率的影响.结果表明:峰值电场强度在9～12kV·cm^-1范围内增加,甲苯去除率相应明显提高;当处理气量为4 m³·h^-1、脉冲电压峰值69kV、进口浓度1 180mg·m^-3、重复频率300pps时, 甲苯的去除率可达88%;反应器的能量利用率在16g·(kW·h)^-1左右;甲苯的降解产物主要是CO₂和H₂O,还有少量CO. 结合甲苯去除率与能量密度、甲苯进口浓度的关系,建立反应器动力学模型,获得甲苯的反应速率常数为0.00356 L·J^-1. 为进一步优化放大反应器设计及与电源匹配提供了基础数据.     

The effect of plasma components on hemoglobin release test in red blood cells (RBC)

Electrophoresis release test (ERT) was established by our lab to observe the re-released hemoglobin (Hb) from red blood cells (RBCs) and whole blood. In this study, ERT was performed to study the effects of different plasma components including plasma, serum, albumin, globulin, fibrinogen, glucose, amino acid, vitamin, insulin, hormone, and inorganic ions on re-released Hb from RBC and whole blood samples during ERT. The results showed that plasma, serum, albumin, globulin, compound amino acid, essential amino acid, vitamin C, insulin, hormone, NaCl, KCl, CaCl₂, and NaHCO₃^? decreased re-released RBC Hb; while glucose, vitamin B1, vitamin B2, and vitamin B12 elevated re-released RBC Hb. The differing effects of various plasma components on re-released Hb of RBC may play a significant role in blood conservation.     

Single- and dual-porosity modelling of flow in reclaimed mine soil cores with embedded lignitic fragments

Lignitic mine soils represent a typical two-scale dual-porosity medium consisting of a technogenic mixture of overburden sediments that include lignitic components as dust and as porous fragments embedded within a mostly coarse-textured matrix. Flow and transport processes in such soils are not sufficiently understood to predict the course of soil reclamation or of mine drainage. The objective of this contribution is to identify the most appropriate conceptual model for describing small-scale heterogeneity effects on flow on the basis of the physical structure of the system. Multistep flow experiments on soil cores are analyzed using either mobile–immobile or mobile–mobile type 1D dual-porosity models, and a 3D numerical model that considers a local-scale distribution of fragments. Simulations are compared with time series' of upward infiltration and matric potential heads measured at two depths using miniature tensiometers. The 3D and the 1D dual-permeability models yielded comparable results as long as pressure heads are in local equilibrium; however, could describe either the upward infiltration or the matric potential curves but not both at the same time. The mobile–immobile type dual-porosity model failed to describe the data. A simultaneous match with pressure heads and upward infiltration data could only be obtained with the 1D dual-permeability model (i.e., mobile–mobile) by assuming an additional restriction of the inter-domain water transfer. These results indicate that for unsaturated flow conditions at higher matric potential heads (i.e., here >− 40 hPa), water in a restricted part of the fragment domain must be more mobile as compared to water in the sandy matrix domain. Closer inspections of the pore system and first neutron radiographic imaging support the hypothesis that a more continuous pore region exists at these pressure heads in the vicinity of the lignitic fragments possibly formed by fragment contacts and a lignitic dust interface-region between the two domains. The results suggest that the small-scale structure is too complex as to be represented by weighted contributions of individual components alone.     

低温等离子体杀菌的实验研究

由于传统的化学水处理方式有化学成分残留和环境污染问题,因而迫切需要开发新型的水处理技术。本研究针对现有杀菌消毒方法的不足之处,利用低温等离子体进行杀菌处理的实验研究,对电压、水层厚度、气体种类及电极形式的影响进行考察。结果表明,低温等离子体用于杀菌不仅效果显著,而且使用方便、快捷、安全并无残留,因而适于饮用水或者生活污水的杀菌处理。     

低温等离子体与催化剂联用降解空气中低浓度的苯

采用介质阻挡放电(DBD)与催化剂(MnO2,TiO2)联用降解空气中低浓度的苯(C6H6)。考察了苯的转化率、产物选择性、能量效率随能量密度的变化关系。研究发现,苯的转化率随能量密度的增加而增加,当注入DBD反应器的能量密度为1200J/L时,等离子体协同催化剂MnO2氧化苯的转化率达到了92%。苯的氧化产物为一氧化碳(CO)和二氧化碳(CO2),进而阐述了其氧化机理。当能量密度为430J/L时,在催化剂MnO2,TiO2存在的条件下,能量效率分别达到了0.062与0.043mol/kWh。