无皂乳液聚合改性废聚苯乙烯

以聚(甲基丙烯酸丁酯—丙烯酸钠)(P (BMA- AANa))为乳化剂,采用无皂乳液聚合技术,利用BMA对废聚苯乙烯(PS)泡沫塑料进行接枝改性.实验得出适宜的工艺条件:P(BMA - AANa)质量分数为51.5％,m(BMA)∶m(丙烯酸)=4∶6,PS和BMA质量分数之和为10.0％;m(PS)∶m(BMA) =...     

快速高效丙烯酸系吸油树脂的合成及性能研究

采用悬浮聚合法合成了低交联度的丙烯酸系高吸油性树脂。研究了单体配比、交联剂用量及种类、分散剂用量和反应温度等反应条件对树脂吸油性能的影响,并且考察了树脂对4种有机毒物(氯苯、吡啶、硝基苯和甲苯) 的吸油效果。结果表明,吸油5 h后,树脂对氯苯、吡啶、硝基苯及甲苯的最大吸油率分别为37.3、34.1、30.5和23.7 g/g;另外,树脂吸油10 min时,其吸油率即可达到最大吸油率的50%。实验证明,该合成树脂对有机毒物有快速高效的吸附效果,可以应用于污染事故应急处理。     

电催化还原技术处理丙烯酸盐废水的研究

采用电催化还原技术处理高浓度丙烯酸盐废水,考察了离子交换隔膜、阴极材料等对丙烯酸盐转化的影响.结果表明,电催化还原技术可将废水中的丙烯酸盐高效还原为丙酸盐;反应器中加入阳离子交换隔膜有利于提高催化还原的电流效率;阴极极板材料对丙烯酸盐还原有很大影响.其中钯/泡沫镍电极（Pd/Nickel foam）的平均电流效率最高,...     

聚丙烯基改性纤维固相萃取水中的苯酚

通过高能电子束辐照的方法,在聚丙烯（PP）纤维基体上分别接枝长链丙烯酸十八酯（SA）和亲水性丙烯酸-β-羟乙酯（HEA）2种单体,并将该纤维作为固相萃取填料,用于固相萃取（SPE）水中的痕量苯酚。研究了SPE过程中上样速度、洗脱溶剂、洗脱体积以及洗脱速度等因素对纤维萃取效果的影响。结果表明,改性纤维对痕量苯酚的富集倍数达95~145倍,回收率达到90%~98%,甲醇对纤维有良好的再生效果,纤维重复使用6次以内时,吸附性能无明显变化。     

三维电极法处理丙烯酸丁酯生产废水的研究

对比了二维电极与三维电极对丙烯酸丁酯生产废水的处理效果,考察了三维电极条件下废水初始COD浓度、曝气强度、极板间距对废水处理效果的影响,并研究了丙烯酸丁酯生产废水中特征污染物的去除过程.结果表明:三维电极对丙烯酸丁酯生产废水COD的去除率明显高于二维电极;三维电极电流效率和能耗受污染物浓度影响较大,污染物浓度越高,电流...     

双极膜电渗析法回收丙烯酸丁酯废水中的有机酸

采用三隔室型双极膜电渗析装置将丙烯酸丁酯废水中的丙烯酸钠和对甲基苯磺酸钠转化为丙烯酸和对甲基苯磺酸并回收有机酸溶液,研究了料室与酸室初始溶液体积比对转化过程的影响.实验结果表明:当料室与酸室初始溶液体积比为5时,回收的有机酸溶液中丙烯酸和对甲基苯磺酸的质量浓度分别达161.5 g/L和25.0 g/L;整个电渗析过程的...     

Ecotoxicity studies of some organotin compounds

The ecotoxicities of three organic compounds containing spacer groups, an intermediate organotin premonomer, four organotin monomers, their homopolymers and six copolymers of tributylin α‐chloroacrylate (TCA) are reported against two microorganisms viz., Pseudomonas aeruginosa and Sarcina lutea and a larval species Anemia salina (Nauplii II). The organic compounds containing spacer group were less toxic whereas the monomers were found to be highly toxic. The homopolymers were found to be more toxic than that of tributyltin acrylate (TBTAA), tributyltin methacrylate (TBTMA) and tributyltin α‐Chloroacrylate (TCA). The toxicity of TCA copolymers increased with the increase in tributyltin (TBT) content in the polymer. From this study it was not possible to establish any relationship between the chemical nature of the comonomer with its toxicity.     

电催化还原脱毒预处理丙烯酸盐废水

丙烯酸盐生物降解性好,但毒性较高,为解决含丙烯酸盐废水难以进行高负荷厌氧生物处理的问题,采用电催化还原技术预处理高浓度丙烯酸盐废水,考察了初始ρ(丙烯酸盐)、电流、废水pH、温度、ρ(对甲基苯磺酸盐)等对丙烯酸盐转化的影响. 结果表明:初始ρ(丙烯酸盐)、废水pH、电流对丙烯酸盐电催化还原为丙酸盐的过程影响较大,而废水温度和ρ(对甲基苯磺酸盐)的影响较小. 当废水初始ρ(丙烯酸盐)由5.0 g/L升至20.0～60.0 g/L时,丙烯酸盐转化速率由30.1 g/(L·h)升至51.9～54.6 g/(L·h),能耗下降近50%;随着操作电流从0.25 A升至2.00 A,丙烯酸盐转化速率由9.5 g/(L·h)线性增至85.1 g/(L·h),电流效率略有降低,能耗由2.0 W·h/g增至5.2 W·h/g;pH由2升至4时,能耗由6.6 W·h/g降至3.4 W·h/g;废水温度在30~50 ℃范围内、ρ(对甲基苯磺酸盐)在0~8.0 g/L范围内时,对丙烯酸盐的转化影响较小. 研究显示,在优化工艺条件(电流为1.00 A、废水pH为5、温度为30 ℃)下,电催化还原处理实际丙烯酸丁酯废水,电流效率达90%以上.      

气相色谱法测定气体样品中丙烯酸甲酯

采用活性炭吸附气体样品中的丙烯酸甲酯,用二硫化碳浸泡解吸30 min后,取上清液进样,用气相色谱法FID检测器测定。方法在0.475 mg/L~38.0 mg/L范围内线性良好,空白活性炭采样管的3个浓度水平加标回收率为94.7%~98.7%,测定结果的RSD为2.7%~4.6%,方法检出限为0.075μg,当采集1.5 L气体样品时,最低检测质量浓度为0.05 mg/m3。以南京化学工业园区常见的15种化合物做干扰试验,结果方法稳定性好,测定不受干扰。用该方法测定南京市某企业周边环境空气,结果上风向和下风向丙烯酸甲酯均未检出。     

Anti-fouling ultrafiltration membrane prepared from polysulfone-graft-methyl acrylate copolymers by UV-induced grafting method

Membrane fouling is one of the most important challenges faced in membrane ultrafiltration operations. The copolymers of polysulfone-graft-methyl acrylate were synthesized by homogeneous photo-initiated graft copolymerization. The variables affecting the degree of grafting, such as the time of UV(Ultraviolet-visible)irradiation and the concentrations of the methyl acrylate and photoinitiator, were investigated. The graft copolymer membranes were prepared by the phase inversion method. The chemical and morphological changes were characterized by attenuated total reflection-Fourier transform infrared spectroscopy(ATR/FT-IR), scanning electron microscopy, and water contact angles measurements. Results revealed that methyl acrylate groups were present on the membranes and the graft degree of methyl acrylate had remarkable effect on the performance of membranes. Pure water contact allgle on the membrane surface decreases with the increase of methyl acrylate graftdegree. which indicated that the hydrophilicity of graft copolymer membranes Was improved. The permeation fluxes of pure water and bovine serum albumin solution were measured to evaluate the antifouling property of graft copolymer membranes, the results of which have shown an enhancement of antifouling property for graft copoly mermembranes.