稀土在废水处理中的应用进展

综述了国内稀土金属在废水处理中的最新应用进展,总结了稀土复合吸附剂的制备方法及其在含磷、氨氮、砷、氟、铬、镉等废水处理中的效果,讨论了稀土复合混凝剂和稀土催化剂在染料、助剂、化工等高浓度有机废水处理中的应用,为找到高效环保的处理工业废水的方法提供了依据.     

利用含铬废水和含铅废水制备铬黄

利用净化后的含铬废水和含铅废水制备铬黄.采用沉淀法对废水进行净化预处理,最佳工艺条件:100mL含铬废水中加入20 g Na_2CO_3,及10 mL H_2O_2,用NaOH调节含铬废水pH为10.00;用NaOH调节含铅废水pH为2.65.将净化后的10 mL含铬废水和25 mL含铅废水混合,在55-60℃条件下反应10 min,合成的铬黄达到GB/T 3184-2008<铬酸铅颜料和钼铬酸铅颜料>的质量标准.经重金属吸附剂处理Pb~(2+)后铬黄合成滤液中的Cr~(6+)和Pb~(2+)质量浓度均达到GB8978-1996<污水综合排放标准>的指标.     

pH敏感性β-环糊精微球的制备及其吸附性能

采用反相微悬浮乳液聚合技术制备了β-环糊精(β-CD)微球,用丁二酸酐对β-CD微球进行化学改性,制备了pH敏感性β-CD(pH-β-CD)微球.通过傅里叶红外光谱仪和扫描电子显微镜对微球的结构、粒径和形貌进行了表征.探讨了亚甲基蓝模拟染料废水pH、吸附时间和微球加入量对亚甲基蓝吸附性能的影响.实验结果表明,在亚甲基蓝模拟染料废水pH为10.0、吸附时间为90 min的条件下,当pH-β-CD微球加入量为50 mg时,pH-β-CD微球吸附量为16.1 mg/g;当pH-β-CD微球加入量为250 mg时,pH-β-CD微球对亚甲基蓝的脱色率达96.2%.     

改性高岭土处理含酸性媒介染料的印染废水

用十六烷基三甲基溴化铵(CTMAB)改性的高岭土处理以水溶性酸性媒介染料为主的印染废水.实验结果表明,当CTMAB-高岭土加入量为0.6 g/L、用石灰乳控制废水pH为9.5～10.0、聚丙烯酰胺的加入量为2.0 mg/L时,废水的处理效果最佳,废水色度和COD去除率分别达到98.0%和92.0%以上,出水色度和COD达到了GB4287-92<纺织染整工业水污染物排放标准>一级排放标准.     

利用活化粉煤灰处理造纸废水的研究

通过正交试验,对粉煤灰处理造纸废水的影响因素进行了研究。研究结果表明：对粉煤灰进行活化,能增加其对造纸废水COD的去除效果;最佳的试验设计方案为：粉煤灰经40％硫酸活化、粒度160—200目、投加量为30g／100ml;影响COD去除率的大小顺序为：投加量影响最大,粒度次之,活化方式影响最小。     

铁碳微电解法在废水处理中的研究进展及应用现状

介绍了铁碳微电解法处理废水的作用机理,概述了近10年来国内外利用铁碳微电解法及其组合工艺对印染、造纸、焦化、炸药、制药等废水处理方面的研究进展及实际的应用状况.提出了铁碳微电解法在运行过程中存在的几个问题,并对今后研究工作的大体方向做了初步的探讨.     

双区电除尘器降低锅炉烟尘排放浓度

粉尘在传统结构的荷电区荷电之后,一部分尘粒被阳极板捕集,大部分带有正、负电荷的尘粒再分别被收尘区的管式辅助电极和阳极板捕集.模拟试验数据表明,收尘区具有高电压、低电流和板电流密度分布均匀的特性.工业性试验结果显示,应用双区电除尘技术设计或改造电除尘器,不仅可以较好地防止发生反电晕,而且能够将锅炉烟尘排放质量浓度降低到50 mg/m3以下.与传统的卧式电除尘器相比,还可节省10%左右的占地面积和钢材用量.     

降低蒸氨废水中的氨氮含量的措施

主要介绍南昌长力钢铁股份有限公司焦化厂在增加1座60孔捣固型焦炉后,原有顶装焦炉和捣固型焦炉共用1套化产回收系统的情况下如何降低蒸氨废水中氨氮含量的措施.     

Metal concentrations in used engine oils: Relevance to site assessments of soils

Used engine oils contain metals, which upon entering soils may pose risks to human health or the environment. In this study, previously published concentrations of 23 metals in 213 used engine oil samples from the early 1970s to the mid-1990s are statistically evaluated. Neat (100%) used engine oils were found to contain relatively high concentrations of lead, calcium, and zinc, attributable to piston blow-by of leaded gasoline, calcium salt detergent additives, and zinc-bearing anti-corrosion/anti-oxidation additives, respectively. Wear metal concentrations were lower. The lead concentration in used engine oils in the U.S. declined between the 1970s and early 1990s, potentially providing a basis to constrain the “age” of used engine oil(s) in soils. The concentrations of 23 metals in used engine oils were compared to soil risk benchmarks in 15 representative jurisdictions in the U.S., Canada, Australia, and Europe. The maximum concentrations in neat (100%) used engine oil of eight metals – Be, Co, Fe, Mn, Ni, Se, Ag, and Ti – were lower than their collective minimum benchmarks in soils for the jurisdictions surveyed, indicating their concentrations in soils could not be reasonably expected to exceed any soil benchmarks. Nine metals (As, Ba, Cd, Cr, Cu, Pb, Sn, V and Zn), but particularly arsenic, cadmium, lead, tin, and zinc, were identified as potential contaminants of concern (PCOC) for soils from locations impacted with used engine oils, owing to their higher median concentrations (i.e., 2.5, 1.4, 1038, 5.0, and 922 mg/kg in oil, respectively) relative to most soil benchmarks. Site-specific benchmarks and metal concentrations at reasonable oil in soil concentrations require consideration when developing the suite of PCOC metal analytes for conducting site assessments of soils impacted by used engine oil.     

电石渣－铁屑法去除硫酸废水中的氟和砷

对各种处理含氟、砷废水的方法进行了探讨，选择了以电石渣和废铁屑为药剂去除硫酸废水中氟和砷的方法，取得了较好的效果。该法以废治废、工艺简便、运行费用低，处理后的废水可达排放标准。