电化学工艺处理有机废水的研究进展

综述了目前国内外学者在二维电极和三维电极的开发和改进方面的研究成果,指出了电化学氧化技术和电极材料的主要研究方向和发展趋势.提出为解决电化学水处理技术中提高电催化效率和延长电极寿命的问题,当前研究的主要方向应集中在阳极材料、反应器结构和处理工艺方面.     

催化湿式氧化预处理造纸黑液

采用连续式固定床反应器,利用自制稀土类复合金属氧化物催化剂对草浆造纸黑液进行了催化湿式氧化(CWAO)预处理研究.通过正交实验确定了最佳工艺条件为:进水COD 40 800 mg/L,空速0.8h-1,反应温度260℃,反应压力6.5 MPa.在此最佳条件下进行实验,COD去除率达90％.经CWAO工艺处理后,草浆造纸...     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

MCM-41分子筛负载铁铈催化降解甲基橙

采用等体积浸渍法制备了负载型有序介孔Fe-Ce/MCM-41催化剂。研究了该催化剂降解甲基橙的适宜工艺条件,并采用XPS,XRD,TEM技术对该催化剂进行了表征。实验结果表明,该催化剂Fenton氧化降解甲基橙的较适宜工艺条件为:溶液pH 5.0、甲基橙溶液初始质量浓度100 mg/L、催化剂加入量2.0 g/L、H_2O_2浓度20 mmol/L,在此适宜条件下反应120 min时,甲基橙去除率接近100%。表征结果显示:Fe-Ce/MCM-41催化剂主要由铁、铈、氧、碳4种元素组成;铁与铈的摩尔比接近3∶1;铁和铈主要以Fe_3O_4和CeO_2的形态存在于催化剂表面。     

厌氧-Carrousel氧化沟处理亚麻沤制废水的试验研究

亚麻沤制废水是一种高浓度有机废水,经厌氧处理后,出水仍不达标.采用厌氧-Carrousel氧化沟进行后续处理试验,并引进了ACF32微生物制剂进行污泥培养,出水CODCr值在200 mg/L左右,TN值维持在22 mg/L左右,TP值维持在3 mg/L以下,最后讨论了试验中影响处理效果的主要因素.     

Multi-response optimization of Fenton process for applicability assessment in landfill leachate treatment

Fenton process, as a pretreatment method, was found to be effective in the primary treatment of mature/medium landfill leachate. However, the main problem of the process is the large amount of produced sludge that requires an accurate feasibility evaluation for operational applications. In this study, the response surface methodology was applied for the modeling and optimization of Fenton process in three target responses, (1) overall COD removal, (2) sludge to iron ratio (SIR) and (3) organics removal to sludge ratio (ORSR), where the latter two were new self-defined responses for prediction of sludge generation and applicability assessment of the process, respectively. The effective variables included the initial pH, [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage. According to the statistical analysis, all the proposed models were adequate (with adjusted R² of 0.9116–0.9512) and had considerable predictive capability (with prediction R² up to 0.9092 and appropriate adequate precision). It was found that all the variables had significant effects on the responses, specifically by their observed role in dominant oxidation mechanism. The optimum operational conditions obtained by overlay plot, were found to be initial pH of 5.7, [H₂O₂]/[Fe²⁺] ratio of 17.72 and [Fe²⁺] of 195 mM, which led to 69% COD removal, 2.4 (l sludge/consumed mole Fe²⁺) of SIR and 16.5 (gCOD removed/l produced sludge) for ORSR in verification test, in accordance with models-predicted values. Finally, it was observed that [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage had significant influence on COD removal, while Fe²⁺ dosage and [H₂O₂]/[Fe²⁺] ratio had remarkable effects on SIR and ORSR responses, respectively.     

铁屑还原－鼓风氧化－石灰凝沉法脱除硫酸生产废水中的砷

比较了硫酸生产废水的几种除砷方法，认为铁屑还原－鼓风氧化－石灰凝沉工艺是可行的，此法具有处理量大、处理效果好、运行费用低等优点。     

Chemiluminescence in evaluating thermal oxidative stability of acrylonitrile-butadiene-styrene (ABS) copolymers. III. Emulsion-grade products

The thermal oxidative stability of various formulations based on emulsion-grade ABS was studied by the chemiluminescence technique. Emulsion products were found to be essentially less stable than ionic mass polymerization resins. Among the antioxidants studied, Santonox R is clearly more efficient than Irganox 1076 and Irganox 3114, and its superiority is reflected primarily in improved induction period values. The introduction of Tinuvin 770 and Tinuvin 328 UV stabilizers into emulsion resins does not change the durability of the products. In mixtures where both Irganox 1076 and UV stabilizers are present, a certain antagonistic effect was noted at high UV stabilizer concentrations.     

低温湿式空气氧化法处理废碱液的研究

对采用低温湿式空气氧化法处理炼油和乙烯废碱液进行了研究。考察了停留时间对废碱液中硫化物的氧化、氧化产物的形态、COD和酚去除率的影响，反应温度对废碱液中污染物氧化反应的影响。试验结果表明，废碱液的脱臭效果很好，S^2-的氧化产物以S2O3^2-和SO4^2-2种形式共存；酚、COD的去除率及S^2-的氧化反应停留时间影响小，受反应温度影响明显；废碱液的S^2-的酚浓度相当时，COD去除率一 般低于40％， 废碱液的S^2-浓度远大于酚浓度时，废碱液的COD去除率为40％－70％；废碱液中酚的质量浓度大于20000mg/L时才有回收价值。     

含氯苯和对邻硝基氯苯农药废水的混凝—氧化预处理

采用混凝沉淀 -芬顿试剂氧化对含氯苯和对邻硝基氯苯农药废水进行预处理 ,探讨了不同条件下农药废水的处理效果。结果表明 ,废水经混凝处理后可去除 46 .2 %的COD ,BOD5/COD值有一定程度的提高 ;废水经芬顿试剂氧化处理后可去除 5 0 .9%的COD ,BOD5/COD值可从 0 .0 4提高到 0 .1