山西夏季气溶胶空间分布飞机观测研究

以搭载了多种气溶胶观测仪器的飞机为观测平台,在2013年夏季首次对山西中部地区霾日及晴空大气气溶胶空间分布特性进行了观测,得到气溶胶粒子数浓度和尺度的垂直分布廓线以及不同高度气溶胶粒子谱分布特征.研究发现,山西夏季非降水天气条件下气溶胶粒子以核模态和积聚模态的细粒子为主,粗粒子很少.霾日气溶胶数浓度是晴空的2~3倍,主要是核模态的小粒子;气溶胶粒子数浓度随着高度逐渐减小,低空存在气溶胶累积区,逆温层的存在是导致气溶胶累积区形成的主要原因;气溶胶粒子尺度随高度增加,大粒子主要分布在2500m以上的高空;不同高度上的气溶胶粒子谱均呈双峰或三峰分布,谱型基本一致,从近地面到5000m高空,气溶胶粒子谱随高度的增加略有展宽.观测区域气团后向轨迹模拟结果显示,4000m以上高空气溶胶粒子主要是从中国西北地区远距离输送而来,3000m以下气溶胶粒子则主要来源于近地面排放.     

土壤溶液性质对Zn的形态变化及其微生物毒性的影响

采集了我国具有代表性的12种不同性质土壤,利用基础诱导硝化(SIN)方法测定了不同土壤中锌的微生物毒性阈值,同时利用850离子色谱仪与WHAM6.0模型,测定了溶液不同阴离子组成及自由Zn2+含量,建立了基于不同土壤性质与溶液离子的土壤中Zn毒性预测模型.结果表明,基于SIN测定的不同土壤Zn微生物毒性阈值在不同土壤间有显著差异,其中EC50从196mg/kg至1310mg/kg;EC10值从48mg/kg增加至682mg/kg,不同土壤EC50与EC10的最大值与最小值的比例分别达到了6.68及14.3倍,表明土壤性质对Zn的微生物毒性有非常显著的影响;基于SIN的Zn的毒性阈值ECx(x=10,50)与溶液自由Zn2+浓度的负对数p(Zn2+)间呈正相关关系,表明随着土壤溶液中自由Zn2+值的升高,Zn的毒性逐渐增加.土壤pH值、OC、CEC、F-、Cl-、Ca2+及Mg2+与Zn的毒性阈值ECx(x=10,50)及p(Zn2+)呈正相关关系,其中土壤pH值为最重要的影响因子,偏相关系数均达到极显著水平(P<0.01),其次为OC、CEC及F-,ECx与溶液中NO3-, SO42-呈负相关关系.基于不同主控因子的土壤中Zn毒性阈值(ECx)及P(Zn2+)的预测模型表明,pH值、OC、CEC、F- 四个变量因子分别解释了log(EC50)、log(EC10)及p(Zn2+)预测模型变异的89.9%、81.2%和92.3%.     

The importance of different forms of Pb on diminishing biological activities in a calcareous soil

In this experimental study, we evaluated the effect of different lead (Pb) fractions on biological properties in soil spiked with 0, 600, 1200 and 1800 mg kg^?1 Pb, during a 90-day incubation period at 25?28°C. Different Pb fractions were measured by sequential extraction at days 1 and 90 after soil treatment. Diethylenetriaminepentaacetic acid (DTPA)-extractable Pb and soil biological properties at days 1, 5, 15, 45 and 90 were measured. The concentration of Pb in soluble and exchangeable fractions was very high at day 1, but it showed remarkable transfer into carbonate and residual fractions by day 90. Substrate-induced respiration, basal respiration, acid and alkaline phosphatases, microbial populations (bacterial, fungal and actinomycetes) and biomass carbon decreased significantly with soil contamination compared with the control. With Pb ageing, these biological properties increased. Metabolic quotient (qCO₂) increased significantly compared with the control with increasing Pb concentration. The toxicity of various forms of Pb for the biological status of the soil was in the following order: KNO₃ extractable>NaOH extractable>EDTA extractable>HNO ₃ extractable>total content Pb. Thus, the bioavailable fractions are better indicators of Pb pollution in soils.     

Thermal cracking of waste printed wiring boards for mechanical recycling by using residual steam preprocessing

Mechanical waste-processing methods, which combine crushing and separation processes for the recovery of valuable materials, have been widely applied in waste printed wiring board (PWB) treatment. However, both the high impact toughness and the tensile and flexural strengths of whole PWB with a laminated structure result in great energy consumption and severe abrasion of the cutters during multi-level crushing. In addition, the high temperatures occurring in continual crushing probably cause the decomposition of the polymer matrix. A thermal-crack method using residual steam as the heating medium has been developed to pre-treat waste PWBs. This treatment reduces the mechanical strength in order to improve the recovery rate of valuable materials in subsequent mechanical recycling. The changes of the PWBs’ macro-mechanical properties were studied to evaluate thermal expansion impacts associated with changes in temperature, and the dynamic dislocation micro-structures were observed to identify the fracture mechanism. The results showed that thermal cracking with steam at the temperature of 500 K can effectively attenuate the mechanical properties of waste PWBs, by reducing the impact, tensile and flexural strengths respectively, by 59.2%, 49.3% and 51.4%, compared to untreated PWB. Thermal expansion can also facilitate the separation of copper from glass fiber by reducing peel resistance by 95.4% at 500 K. It was revealed that the flexural fracture was a transverse cracking caused by concentrated stress when the heating temperature was less than 500 K, and shifted to a vertical cracking after exceeding 500 K.     

海藻酸钠/锆@钙水凝胶的制备及其对磷的吸附研究

利用简便的方法制备了一种新型的海藻酸钠/锆@钙(SA/Zr@Ca)水凝胶材料,采用SEM、XRD对该材料进行了表征,并通过拟合吸附等温模型及吸附动力学模型,结合XPS和Zeta电位分析,研究了该材料对磷酸盐吸附的性能和机理.结果表明,该材料为非晶态的无定型材料.在溶液初始pH为2～7时,SA/Zr@Ca对磷酸盐(以PO...     

Biochemical properties of beryllium potentially relevant to its carcinogenicity†

The carcinogenicity of beryllium to several animal species is well established and evidence exists which strongly suggests that this is the case in human exposure. In this review several biochemical properties of the metallocarcinogen are considered including, the causation of cell transformation, and infidelity of DNA synthesis, inhibition of cell division and enzyme induction, and interference with regulatory mechanisms controlling gene expression. These effects are discussed in relation to beryllium chemistry, cellular accumulation mechanisms and distribution to subcellular organdies and molecular targets. It is suggested that the ultimate location and interactions of the metal ion in cell nuclei and its selective inhibition of certain protein phosphorylation reactions in particular are the biochemical effects potentially most relevant to induction of beryllium carcinogenesis.     

Polycyclic aromatic hydrocarbons in surface sediments held in experimental mesocosms

Sediment was collected from three locations along a pollution gradient in Narragansett Bay and transplanted to controlled mesocosms. Total hydrocarbons and eleven individual polycyclic aromatic hydrocarbons (PAHs) were measured in these sediments over a period of 394 days. Total hydrocarbon concentrations increased in the “relatively uncontaminated”; (Rhode Island Sound) sediment that was held in the mesocosms, but did not change in the two other sediments. The concentrations of four PAHs: naphthalene, 2‐methyl naphthalene, 1‐methyl naphthalene and biphenyl, decreased in the “contaminated”; (Providence River) sediment during the experiment and the calculated half‐lives for these compounds were 287, 353, 321 and 333 days, respectively.     

黄土丘陵区生物结皮对土壤物理属性的影响

生物结皮在干旱、半干旱地区广泛发育。迄今,有关生物结皮发育过程中土壤物理属性的响应仍不明确。论文采用野外调查与室内分析相结合的方法,定量研究不同生物量生物结皮对土壤物理属性的影响。结果表明:①生物结皮的发育能够细化土壤,当生物结皮由初期藻结皮演替至60%~80%苔藓结皮时(5等级),生物结皮层粗砂粒含量降低了86%;②随着生物结皮生物量的增加,生物结皮层土壤容重和硬度较初期分别降低了15%和68%,田间持水量和孔隙度分别增加了36%和14%;生物结皮层粘结力是下层土壤的6~7倍;③生物结皮的发育对土壤物理属性的影响与生物量有关,当苔藓生物量达2.91±0.12 g/dm²时,其土壤物理属性基本稳定。研究结果为揭示生物结皮抗侵蚀机理提供了科学参考。     

废TFT-LCD面板中主要元素溶出特性

以废TFT-LCD面板破碎料为研究对象,在使用XRF（X射线荧光光谱分析仪）分析其主要元素组成以及采用ICP-AES测试不同酸体系下主要元素浓度的基础上,研究了不同酸体系下主要元素的溶出特性. 结果表明:废TFT-LCD面板由Si、Al、Sr和In等10余种元素组成,其主要组成元素在不同酸体系下的溶出特性存在明显差异,这与其赋存形态有密切关系. In在各种酸体系下溶出浓度变化较小,为283～306 mgL. Fe的溶出特性与In相似,是主要伴随离子. Al和Sr易在浓盐酸体系下溶出. As在含有浓硝酸的体系下溶出率较高,最高溶出率为100%,而在无浓硝酸体系下的溶出率最低值仅为293%. Zn、Ti、Cu、Sn和Cr在各酸体系下的溶出浓度均较低(均低于1 mgL),不宜回收.      

机械化学法修复柴油污染土壤的效率、产物及影响

针对常规污染土壤修复处理方法存在有毒降解产物、容易产生二次污染等问题,本研究采用行星球磨仪研究了机械化学法（MC）对柴油污染土壤的修复效能,利用GC/MS对柴油烃组分的降解产物进行分析,并采用SEM、XRD、BET、FTIR和TGA等方法对不同处理条件下的土壤样品进行表征.结果表明,MC处理在0.5~4.0 h内对土壤中总石油烃（TPH）的去除率可达95%以上.随着初始TPH浓度和球土质量比的升高,TPH去除率随之提高.采用MC处理后柴油组分降解难度顺序如下：烷烃<烯烃<环烷烃<芳香族化合物.在球磨处理4 h后,未检出有毒有害残留物质.球磨后土壤粒径变小,表面变粗糙,粘土矿物中的硅氧四面体暴露在土壤表面,矿物结构的结晶度逐渐降低,晶体结构逐渐破裂或变形,可在土壤表面形成富电子区域或促使土壤具有更高的反应活性,这是机械化学法高效降解柴油的主要机制.其次,土壤有机质的主要官能团受到破坏,纳米级孔隙容量降低,从而降低了土壤组分的吸附能力,增加了柴油的有效性,也有助于柴油的解吸和机械化学降解.此外,随着球磨时间的增加,土壤有机碳（SOC）含量先增加后下降,但均高于处理前.可见,MC处理可以快速彻底降解土壤中的柴油,且有利于增加土壤有机碳含量,对于石油烃污染土壤修复具有较好的应用潜力.