乡镇工业企业发展与环境,资源协调问题初探

我国乡镇工业企业的发展与环境、资源的协调问题已经成为我国发展与环境、资源关系方面的大问题。实行工农相对分离,组建乡村工业区,是提高乡镇工业企业素质、效益,强化乡镇工业企业优化组合、规模经营的有效途径;是保护环境,实现资源有效利用的基础工作之一;是提高农业劳动生产率,实现农业规模经营的基础工作之一。     

Sensitivity of Ozone Production to the Nmhc Composition, Aerosol Back-Scattering and High Chimney Emission

In this paper, three sensitivity studies are designed to analyze the effect of the NMHC (Non-Methane HydroCarbon) composition, the aerosol back-scattering and the high chimney NO_x emission to the photochemical prodution of ozone by using a one-dimensional photochemistry-diffusion model under a favourable meteorological condition. Measurements of the NMHC composition in Taipei indicated that the percentage of iso-butene, cis-2-butene, trans-2-butene and benzene in a unit volume was much higher than of those observed in other major cities. the high ratio of benzene was directly linked to its high percentage in gasoline. As to the unusually high amount of iso-butene, cis-2-butene and trans-2-butene, more researches are needed to identify their source. Concerns are raised as to how productive is NMHC composition is to the photochemical production of the surface ozone. A rough estimate shows that the total reactivity of the Taipei NMHC composition is about 1.21 × 10^-9 cm³ s^-1 which is 1.6 times that of the Los Angeles (LA) NMHC composition, while the simulated noon peak will be different by 28 ppbv, i.e. 18% more than that simulated with a LA composition.

Meanwhile, high aerosol loading is a serious problem in Taipei. the attenuation of the UV radiation by aerosols cannot be ignored. A numerical simulation shows that the noon ozone level will decrease from 178 to 141ppbv, i. e. about 21% reduction, with deterioration of the visual range from 85 to 5 km.

In the southern Taiwan, industry parks are mixed with the populated Kaohsiung city, hence the large emission of NO_x from high chimneys cannot be ignored. in this study, NO_x is assumed to be emitted in the layer between 235-460 m high with an emission rate of 0.05 or 0.145 ppbv/sec. the results show that the NO_x emitted from the elevated stack lead to a considerable reduction of surface ozone. Such conclusion is obtained due to the fact that a one-dimensional model is used in this paper. Whereas, if a three-dimensional regional model was used, then a higher productivity of ozone downstream would be simulated.     

Production of radioactive particles for use in environmental studies

This paper presents an aerosol generation technique developed to produce dry aerosol particles of various sizes from aqueous solutions of salt. The technique was tested with sodium chloride, lithium carbonate and uranyl acetate at various aqueous concentrations which produced particles in the size range of 0.13-1.37 microm Mass Median Diameter (MMD). The generated aerosols were acceptably monodisperse with a geometric standard deviation of 1.4-2. Both MMD and Mass Median Aerodynamic Diameter (MMAD) increased significantly (p<0.001) with increased concentration of the salt in solution. The technique can also be used to generate aerosols of different chemical species. The results obtained indicate that the system is convenient for use with various aerosol-forming materials, with a stable particle size distribution being maintained for a long period of steady operation. The technique was successfully applied in wind tunnel studies to simulate the release of submicron radioactive particles and their interception by crops, grass and tree canopies. The relevance and application of the technique in other areas of environmental assessment studies is discussed.     

Effective Planning and Implementation of Ecological Rehabilitation Projects: A Case Study of the Regional Municipality of Waterloo (Ontario, Canada)

The literature guides environmental planning and, specifically, how to use ecological rehabilitation projects to achieve long-term planning goals and landscape-scale environmental sustainability. There is, however, a perceived gap between principles in the literature and the use of them by practitioners involved in smaller-scale ecological rehabilitation projects. Using interviews with practitioners involved in 11 projects within the Regional Municipality of Waterloo, Ontario, Canada, we tested whether practitioners used five principles for effective planning and implementation of ecological rehabilitation that we derived from the literature. These five principles were: establishing political and ecological context, using ecologically appropriate objectives and practices, using comparative multidisciplinary and cross-scale approaches, using adaptive planning and implementation, and establishing good communication within and external to projects. Few projects followed all five principles, and practitioners indicated that they used three more project-specific principles: obtaining political/social support, promoting projects and changing attitudes about projects, and securing sufficient and persistent funding to maintain a project's life. While the literature emphasizes that ecological rehabilitation is only effective if projects are coordinated on a watershed basis, most practitioners focused solely on the goals of their specific project. The gap between literature and practice may arise because most practitioners are new to the field of ecological rehabilitation and still are focused on the methods involved. Time pressures force practitioners to obviate the literature and get projects started quickly, lest support evaporate. Complicating these difficulties is decreased support from federal and provincial governments for large-scale environmental planning. It is unclear whether ecological rehabilitation projects in Waterloo Region (at least) will ever become effective at promoting landscape-scale ecological goals or remain smaller-scale stop-gaps.     

HYDROLOGIC EFFECTS FROM CHANGES IN GROUND WATER PUMPAGE1

ABSTRACT: Simulation of a large stream-aquifer system in Nebraska has been accomplished for the period from 1975 to 2020 to determine effects of controls on ground water pumpage. Three scenarios tested consisted of average annual withdrawals of 15.2 ac-in/ac (FUTURE 1), 14.8 ac-in/ac (FUTURE 2), and 9.8 ac-in/ac (FUTURE 3). The highest quantity represents the historical tendency; while the 14.8 in. figure represents a slight reduction and also represents an equalization of irrigation application efficiencies throughout the area. The lowest figure represents a substantial increase in application efficiency. Comparisons between simulated ground water elevations indicate maximum savings of FUTURE 2 over FUTURE 1 of less than 8 ft. FUTURE 3 ft. FUTURE 3 levels are projected to be a maximum of approximately 13 ft. higher than FUTURE 1's. The relatively small savings from reductions in pumpage result primarily from recirculation effects. Differences between ground water contributions to stream flow are small for all scenarios. These contributions decrease with time and increasing pumpage amounts. Base flow rates at the end of the simulation are approximately 25 percent of those at the beginning.     

OBSERVATIONS ON KINEMATIC RESPONSE IN URBAN RUNOFF MODELS1

ABSTRACT: This paper first discusses the results of sensitivity analyses conducted on various parameters of the San Francisco Stormwater Model ta version of WREM) and the Penn State Runoff Model in terms of their impact on outflow hydrographs. The parameters considered within a idealized catchment include: basin shape, imperivous fraction, overland roughness and slope: deterntion depth; infiltration capacity; and hyetograph timing. Second, the results for the hypothetical catchment are extended to the lazzard laboratory surfaces (asphalt, grass, roofing material) as a mean of illustrating the need for changes in model structure, as opposed to continued parameter adjustment Finally the effect of altering the scale of hydraulic representation in the surface runoff and sewer transport calculations are demonstrated for two gaged watersheds in Hamburg, West Germany.     

DESK TOP METHODOLOGY FOR MODELING BIOCHEMICAL OXYGEN DEMAND IN STREAMS1

: The modeling of dissolved oxygen in streams is a widely used technique, upon which a great deal of money has been spent. This paper concludes that the standard methods of DO modeling by computer are unnecessarily complex, and that for some purposes, they can be replaced without loss of accuracy by desk top BOD models. Taking as an example, a set of data used in DO modeling, it is shown (a) that the data are grossly inconsistent, (b) that simultaneous gathering of data introduces errors in streams of long travel time, (c) that much more data as to pollutant concentrations should have been obtained, and (d) that 24-hour DO data could have been dispensed with.     

CAPITAL COST OF RURAL WATER DISTRIBUTION SYSTEMS1

ABSTRACT: The cost of water service to rural residents is very high compared to urban areas. This is true even after subsidization by Farmers Home Administration (FmHA) loans and grants. Capital cost data on 44 projects financed by the Ohio office of the FmHA during the period August 1968 to January 1977 are used to derive cost equations for 26 components of rural water distribution systems. These components represent 92 percent of the capital cost of the pipeline distribution systems studied. The data can be used to economically design rural water supply systems from a capital cost viewpoint. More data are needed on operation and maintenance costs as well as central and cluster well costs before totally economic system designs can be undertaken.     

Application of the Braun-Blanquet cover-abundance scale for vegetation analysis in land development studies

To document environmental impact predictions for land development, as required by United States government regulatory agencies, vegetation studies are conducted using a variety of methods. Density measurement (stem counts) is one method that is frequently used. However, density measurement of shrub and herbaceous vegetation is time-consuming and costly. As an alternative, the Braun-Blanquet cover-abundance scale was used to analyze vegetation in several ecological studies. Results from one of these studies show that the Braun-Blanquet method requires only one third to one fifth the field time required for the density method. Furthermore, cover-abundance ratings are better suited than density values to elucidate graphically species-environment relationships. For extensive surveys this method provides sufficiently accurate baseline data to allow environmental impact assessment as required by regulatory agencies.     

Energy analysis and the coupling of man and estuaries

New concepts and insights concerning human and natural systems in the coastal zone are emerging from recent energy analysis and synthesis studies. By using new concepts for measuring the quality of energy, one can express the work of ecosystems and human economies in equivalent terms. From energy models and new energy quality evaluations, one can learn what kinds of coastal systems maximize power, are competitive, economically vital, and likely to have a survival advantage.Energy analysis and synthesis is aided by energy circuit diagrams. Models of the coastal zone that emphasize the change in external driving functions related to world energy sources provide insights and some predictive abilities that are not found in economic studies, since money flows alone do not evaluate external driving energies.This paper suggests four procedures for coastal planning: 1) calculation of investment ratio in units of equal quality to determine which projects are economic in a broad sense, 2) development of energy signatures for coastal ecosystems, 3) determination of which interface ecosystems develop the best energy flows, and 4) development of regional models that include the main features of human and natural ecosystems.