600 t/d新型污泥喷雾干化-焚烧 示范工程污染物去除效果

新型污泥喷雾干化-回转窑焚烧工艺是将脱水污泥通过雾化喷嘴形成滴雾后与高温烟气并流接触达到干化后再进行焚烧的集成技术.干化过程中湿污泥中有机物的挥发及该新型工艺的运行工况和污染物减排效果成为污泥处理处置领域关注的焦点.在对污泥喷雾干化焚烧工艺原理分析基础之上,对我国600 t/d新型污泥喷雾干化焚烧示范项目进行封闭式现场取样监测,通过成分分析、毒性监测等重点对污染物去除效果进行了研究,结果表明,该工艺通过自动控制可将出口烟气温度和干化污泥温度保持较稳定的状态,分别为(96±10)℃和(72±8)℃;喷雾干化塔内不存在粉尘爆炸危险,TVOC＜0.025 mg/m3;直接干化热利用率＞80％,优于间接干化;烟气排放口各指标均满足《生活垃圾焚烧污染控制标准》(GB18485-2001)的要求.     

中国有机氯农药的监测现状

归纳了有机氯农药在我国的生产和使用概况,总结了我国大气、水体和沉积物、土壤以及生物体等环境介质中的有机氯农药监测现状。在此基础上,对我国有机氯农药的深入研究提出了建议。     

石化综合污水生化处理中有机污染物的分析

运用GC-MS、紫外光谱及三维荧光光谱扫描技术考察了石化污水处理厂“水解酸化—厌氧处理—好氧处理”工艺的各单元出水中有机污染物的变化情况。总进水中检出84种主要有机污染物,主要含有烃类27种,酚类5种,醛、酯、醇和酮类化合物共24种,胺类4种,腈、有机酸及其他杂环化合物14种,另有10种物质未定性;该工艺的COD累积去除率达87.66%, 64种有机污染物被完全去除,17种有机污染物去除率可达90%以上,接触氧化池出水中主要含杂环化合物和少量醛、醇、酯类化合物。     

Particulates and Metallic Elements Monitoring at Two Sampling Sites (Harbor,Airport) in Taiwan

This study characterized the dry deposition flux and dry deposition velocity (Vd) of metallic elements attached on particulate matter. Specifically, large particles (>10 μm), coarse particles (10 μm～2.5 μm), and fine particles (<2.5 μm) were studied at the Gong Ming Junior High School (Taichung Airport) and Taichung Harbor sampling sites in central Taiwan. Ambient air samples were collected to determine total suspended particulate matter (TSP), dry deposition plate (DDP), Vd, coarse particulate matter (PM_2.5–10) and fine particulate matter (PM_2.5), and metallic elements concentrations at the Airport and Taichung Harbor sites between June 17, 2013, and November 14, 2013. The results revealed that the average TSP, DDP, Vd, PM_2.5–10, and PM_2.5 particulate at the Airport were 54.55 (μg/m³), 902.25 (μg/m²-min), 17.11 (m/sec), 0.003 (μg/m³), and 0.010 (μg/m³), respectively; while these values at Taichung Harbor were 63.66 (μg/m³), 539.69 (μg/m²-min), 9.94 (m/sec), 0.003 (μg/m³), and 0.014 (μg/m³), respectively. In addition, the results showed that the average Cu and Pb concentrations were higher than Cr, Ni, and Cd for both the airport and harbor sampling sites. Furthermore, Cr, N, Cu, Cd, and Pb had the highest average concentrations versus those reported for other study areas, with one exception: The results obtained in Kacanik, Kosovo, during 2005. The average metallic elements concentrations order was Cu > Pb > Cr > Ni > Cd.     

不同处理技术对河流污染物降解系数影响的比较

以苏州官渎花园内河为研究背景,利用模拟河道分别考察了曝气复氧、人工水力循环、渗滤净化技术3种处理技术对受污河水中COD降解系数k COD、NH3-N降解系数k NH3-N变化规律的影响。实验表明,在无外源污染且河水滞留的天然情况下河道拥有一定自我净化的能力,并且3种处理技术对COD、NH3-N的降解系数都有一定提高,分别使k COD增加了34.3%、47.8%和57.8%,k NH3-N增加了8.35%、15.4%和52.8%,结果显示,渗滤净化技术对污染物降解系数的提高影响最大。     

Effects of Strength and Position of Pollutant Source on Pollutant Dispersion Within an Urban Street Canyon

A two-dimensional numerical model for simulating airflow and pollutant dispersion inside an urban street canyon was first developed using the FLUENT code, and then it was validated against a wind tunnel experiment. Then the effects of strength and position of pollutant sources on pollutant dispersion within an urban street canyon were investigated numerically. The numerical results showed that the dimensionless pollutant concentrations within the urban street canyon were independent from the source strength. The results also revealed that the pollutant distributions inside the urban street canyon with a two-lane road were influenced significantly by the positions of the two sources: 1) the closer the two sources were to the street center of the canyon, the lower the pollutant concentrations on the leeward wall and at the human respiration level in the leeward footpath became; 2) the pollutant concentrations on the windward wall and at the human respiration level in the windward footpath were not sensitive to the locations of the two sources as long as the source on the windward lane was situated outside the small recirculation zone at the bottom corner of the canyon windward wall; 3) the pollutant concentrations on the lower parts of the windward and leeward walls as well as in the two footpaths increased greatly when the two sources were moved from outside into the small recirculation zones.     

环境资源市场配置在浙江省的实践与探索

全面总结了浙江省污染物排放总量管理和市场配置环境资源试点的主要实践措施(包括创新构建总量管理和激励制度、全面构建市场配置环境资源制度、探索建立协同管理和交易机制和深入推进监管执法机制建设)和实施成效(包括市场倒逼污染减排、促进经济转型升级、市场拓宽融资渠道、提升环境管理水平和增强生态环境保护意识),提出了完善环境资源市场配置模式总体设想,为全面推进中国环境资源市场配置实践提供借鉴。     

含腈废水处理过程中污染物的转化规律

对某石化企业含腈废水的处理工艺进行了评估,从污染物的来源、组成、处理效果等方面研究了污染物的转化规律,揭示了现有工艺在含腈废水处理过程中的问题。实验结果表明:该企业污水处理场的废水来源较多,丙烯腈生产废水经四效蒸发系统处理后的出水是其污染物的主要来源,含有相对较多的含氮共轭体系;与其他废水混合后,经氨化作用,有机腈转变为有机胺和铵盐;A/O工段矿化度较高,COD的去除率高达73.0%,但有机胺含量仍较高;在缺氧池—生物流化池—硝化池工段,COD进一步被去除,胺类物质浓度大幅降低,但总氮脱除效果并不理想。     

电镀行业铜、镍、锌产排污系数的核算

针对现有国家《产排污系数手册》中电镀行业重金属产排污系数的不完整问题,以深圳市电镀企业分布较多的宝安区和龙岗区为研究对象,采用全面调研和个案实测的方法,将电镀行业典型镀种铜、镍、锌划分为18组四同组合。根据调研数据计算获得了每组四同组合的产排污系数,并通过个案实测验证了产排污系数的合理性及适用性。结果表明,产排污系数法计算的产污量误差在16%以内,排污量误差在30%以内,所以产排污系数能够推广应用于电镀行业重金属污染排放量核算。     

焦化废水的污染物特征及处理技术的分析

重点分析了焦化废水中存在的特征性有机污染物,强调水质分析是焦化废水工艺选择的基础。针对焦化生产工艺过程的复杂性,探讨了蒸氨、焦油分离、粗苯回收及脱硫过程中典型有机污染物的来源和分布,提出焦化废水污染物源头控制的重要性和必要性。比较了焦化废水预处理、生物处理和深度处理各阶段的污染控制技术,强调技术创新与政策性引导有助于实现本行业污染控制和厂区清洁生产。