连接性指数对脂肪醇的QSPR/QSAR研究

用碳原子取代醇中的氧,构造出极性很小、结构和原化合物相似的分子.定义原子特征值f_i=1 sum h_(ij),并在邻接矩阵的基础上,建立该化合物的连接性指数~mG,~mG=sum(f_i·f_i·f_k…)~0.5,其中,~0C=sum(f_i)~0.5.G=sum(f_i·f_i)~0.5.~mG对脂肪醇异构体具有很强的区分能力,且~0G与醇的-lgS_w,lgK_ow均有良好的相关性,复相关系数均在0.99以上.~0G具有物理意义明确,计算简单等优点.     

Determination of alcohol compounds using corona discharge ion mobility spectrometry

Ion mobility spectrometry （IMS） is a very fast, highly sensitive, and inexpensive technique, it permits efficient monitoring of volatile organic compounds like alcohols. In this article, positive ion mobility spectra for six alcohol organic compounds have been systematically studied for the first time using a high-resolution IMS apparatus equipped with a discharge ionization source. Utilizing protonated water cluster ions （H2O）nH^＋ as the reactant ions and clean air as the drift gas, alcohol organic compounds, ethanol, 1- propanol, 2-propanol, 1-butanol, 1-pentanol and 2-octanol, all exhibit product ion characteristic peaks in their respective ion mobility spectrometry, that is a result of proton transfer reactions between the alcohols and reaction ions （H2O）nH^＋. The mixture of these alcohols, including two isomers, has been detected, and the results showed that they could be distinguished effectively in the ion mobility spectrum. The reduced mobility values have been determined, which are in very well agreement with the traditional ^63Ni-IMS experimental values. The exponential dilution method was used to calibrate the alcohol concentrations, and a detection limit available for the alcohols is in order of magnitude of a few ng/L.     

Degradation of MTBE and TBA by a new isolate from MTBE-contaminated soil

Methyl ten-butyl ether （MTBE）, a gasoline additive, possesses serious problems to the environmental health. In the present study, a bacterial culture named A-3 which could effectively degrade MTBE was isolated from the MTBE contaminated soil. The isolate was identified as Chryseobacterium sp., a new species capable of degrading MTBE. In order to enhance its degradation ability, selected environment factors were investigated. The results showed that the optimal temperature was in the range of 25-30℃, the pH was 7.0, the inoculum size was 2 × 10^8 CFU/ml and the optimal concentration of MTBE was from 50 to 100 mg/L. The maximum MTBE utilization rate （Vmax） was 102 nmol MTBE/（mg cell protein.h）. Furthermore, it was found that the isolate could also degrade tert-butyl alcohol （TBA）. The degradation rates of TBA were much faster than those of MTBE. The additional TBA would lead to the decrease of the initial MTBE degradation rate and the inhibitory effect of TBA increased with the increase of TBA concentration. Similar protein profiles at least seven peptides were demonstrated after SDS-PAGE analysis of crude extracts obtained from the cells growing in MTBE and TBA culture.     

酒精废水部分亚硝化-厌氧氨氧化脱氮的可行性

采用一体式部分亚硝化-厌氧氨氧化反应器研究了酒精废水脱氮的可行性.结果表明,在pH 7.8±0.5,温度30~35℃,好氧区ORP值120~150 mV的条件下,历时40 d成功地启动了一体式PN-ANAMMOX反应器,总氮去除速率由0.125kg·(m~3·d)~(-1)上升至0.75 kg·(m~3·d)~(-1)左右,说明接种成熟的亚硝化生物膜和厌氧氨氧化颗粒污泥可达到快速启动的效果;在酒精废水处理的研究中表明,酒精废水对PN-ANAMMOX反应器的影响主要是由其中可生物降解的TOC导致,短期内可生物降解TOC的加入,ANAMMOX反应区首先受到影响;酒精废水中100 mg·L~(-1)可生物降解TOC浓度可以使总氮去除速率由0.75 kg·(m~3·d)~(-1)降低至0.25 kg·(m~3·d)~(-1)左右,降低约66%,这种抑制是可以恢复的;采用不同浓度梯度酒精废水驯化PN-ANAMMOX反应器内功能菌群,随着进水浓度梯度的增加,总氮去除速率均出现了先下降再上升的趋势,通过延长HRT和适当提高PN阶段的溶解氧的方式,有利于反应器整体脱氮效能的提高,完全以酒精废水作为进水时,总氮去除速率稳定在0.65 kg·(m~3·d)~(-1)左右,脱氮效果较好,说明一体式PN-ANAMMOX可用于回用酒精废水的处理.     

聚乙烯醇降解酶产生菌发酵培养基响应面法优化研究

为了提高假单胞菌Pseudomonas.sp XT11-Z90S产聚乙烯醇降解酶的能力,用Plackett-Buman实验和响应面分析实验对影响产聚乙烯醇降解酶的9个因素,即发酵培养基的9种组成成分进行了研究,并探讨了影响产酶的主要因素和培养基的最佳组成.结果表明,影响产聚乙烯醇降解酶的3个重要组成为葡萄糖、酵母膏和硫酸铵,其最适浓度分别为0.64、0.22和1.45g.L-1.在最佳浓度和组成条件下,聚乙烯醇降解酶最高酶活为13.5U.mL-1,与优化前的12.1U.mL-1相比,提高了11.6%,且其降解率6h时可达到35.5%.     

聚氯乙烯生产过程生命周期评价

文章运用生命周期评价方法,对我国东南某大型石化集团聚氯乙烯生产过程的资源消耗及环境影响进行量化与估算。结果表明:生产1t聚氯乙烯的总能量消耗为6102.24MJ,环境影响负荷为0.49标准人当量。聚氯乙烯生产的主要环境影响为大气颗粒物污染、光化学臭氧合成、酸化和全球变暖。     

好氧与电絮凝组合工艺处理糖蜜酒精厌氧出水研究

采用好氧与电絮凝联合工艺处理糖蜜酒精厌氧出水,考察COD和色度的去除效果.首先,采用SBR工艺去除废水中的易降解污染物.结果表明:采用SBR法处理稀释10倍的糖蜜酒精厌氧出水,适宜的水力停留时间为10 h;COD去除率为42％,脱色效果不明显,BOD5/COD由0.54下降到0.09,好氧出水难以生化降解.进一步采用电絮凝法处理好氧出水,并考察了极板间距、初始pH值、电流密度和电解时间等因素对COD去除及脱色效果的影响.结果表明,在极板间距为3 cm、废水pH=7.83(无须调节,最佳pH=6～8)、电流密度为10 mA/cm2、电解时间为30 min的条件下进行电絮凝处理,与稀释10倍的糖蜜酒精厌氧出水相比,COD总去除率可达86％,脱色率达95％.     

表层沉积物中6:2氟调醇生物降解对细菌群落结构的影响

6∶2氟调醇(6∶2 FTOH)是一种多氟烷基物质,近年被广泛用于工业和消费品中,对环境有潜在威胁,但目前关于6∶2FTOH及其降解产物对沉积物中微生物群落结构的影响还不清楚.本研究的目的是通过基因分析方法探索6∶2 FTOH生物降解对表层沉积物中细菌群落结构的影响.从天津海河采集表层沉积物和河水,在实验室进行微宇宙实验,通过LC-MS/MS测定6∶2 FTOH及其降解产物的浓度,通过变性梯度凝胶电泳和高通量测序分析细菌的群落结构.结果表明,6∶2 FTOH在微生物的作用下可发生降解(半衰期小于3 d),生成6∶2 FTCA、6∶2 FTUCA等中间产物和5∶2 FT Ketone、5∶2 s FTOH、PFHx A、PFPe A、PFBA、5∶3 Acid等稳定产物,该过程对沉积物细菌群落结构产生明显影响,引起细菌群落丰富度和多样性的变化.在6∶2 FTOH降解的不同阶段,细菌的变化和优势菌群略有不同.根据100 d的实验结果,从门的分类水平看,6∶2 FTOH生物降解引起绿弯菌门丰度大幅上升(+24.8%)、变形菌门和厚壁菌门丰度大幅下降(-17.8%和-15.9%).从纲的分类水平看,6∶2 FTOH生物降解引起丰度上升较大的有厌氧绳菌纲(+19.6%)和δ-变形菌纲(+4.3%),引起丰度下降较大的有ε-变形菌纲(-20.0%)、梭菌纲(-10.1%)、芽孢杆菌纲(-5.8%)和γ-变形菌纲(-4.2%).从属的分类水平看,6∶2 FTOH生物降解引起丰度上升较大的有Anaerolineaceae_uncultured(+19.1%)和硫碱球菌属(+13.3%),引起丰度下降较大的有弧菌属(-14.1%)、硫单胞菌属(-13.2%)、芽孢杆菌属(-5.1%)、Sulfurovum(-4.2%)和Fusibacter(-4.1%).这些结果有助于预测环境中细菌对多氟烷基物质污染的响应及筛选可降解多氟烷基物质的细菌.     

厌氧膨胀颗粒污泥床(EGSB)在高浓度工业废水处理中的应用

介绍了一种新型的用于高浓度有机废水处理的EGSB反应器 ,该反应器的工艺特点包括反应器内部的生物相的分层 ,颗粒污泥的变速膨胀 ,以及高效的三相分离装置等。该反应器最高CODCr容积负荷可达到 2 5kg m3·d以上 ,最高进水CODCr浓度可达 30 0 0 0mg L以上。并介绍了几个应用该工艺的具有代表性的工程实例。     

两种释碳材料的制备及其性能研究

应用固定化技术制备了包埋淀粉的聚乙烯醇(PVA)释碳材料和海藻酸钠(SA)释碳材料,采用红外光谱和扫描电镜对其物化特性进行分析,研究了二者的释碳性能以及作为碳源对硝态氮的去除效果.结果表明,PVA释碳材料中淀粉混合较好,释碳过程满足二级动力学方程,单位质量材料释放的饱和COD达到99.60mg/(g·L).在温度为18~22℃,pH7.2~8.0,硝态氮浓度为35mg/L的条件下,PVA释碳材料的平均反硝化速率为18.5g/(m3·d),SA释碳材料的平均反硝化速率为15.5g/(m3·d),在稳定运行15d后,出水硝态氮浓度逐渐升高,脱氮效果开始下降.