全文获取类型
收费全文 | 553篇 |
免费 | 68篇 |
国内免费 | 336篇 |
专业分类
安全科学 | 51篇 |
废物处理 | 84篇 |
环保管理 | 78篇 |
综合类 | 488篇 |
基础理论 | 39篇 |
污染及防治 | 199篇 |
评价与监测 | 11篇 |
社会与环境 | 5篇 |
灾害及防治 | 2篇 |
出版年
2024年 | 1篇 |
2023年 | 4篇 |
2022年 | 7篇 |
2021年 | 8篇 |
2020年 | 14篇 |
2019年 | 10篇 |
2018年 | 16篇 |
2017年 | 21篇 |
2016年 | 19篇 |
2015年 | 34篇 |
2014年 | 48篇 |
2013年 | 56篇 |
2012年 | 67篇 |
2011年 | 52篇 |
2010年 | 38篇 |
2009年 | 46篇 |
2008年 | 35篇 |
2007年 | 68篇 |
2006年 | 60篇 |
2005年 | 56篇 |
2004年 | 41篇 |
2003年 | 43篇 |
2002年 | 38篇 |
2001年 | 36篇 |
2000年 | 25篇 |
1999年 | 21篇 |
1998年 | 20篇 |
1997年 | 21篇 |
1996年 | 10篇 |
1995年 | 10篇 |
1994年 | 10篇 |
1993年 | 8篇 |
1992年 | 4篇 |
1991年 | 3篇 |
1990年 | 1篇 |
1989年 | 1篇 |
1986年 | 1篇 |
1980年 | 1篇 |
1972年 | 2篇 |
1969年 | 1篇 |
排序方式: 共有957条查询结果,搜索用时 531 毫秒
131.
生物膜生态浮床对城市尾水净化特征分析 总被引:1,自引:1,他引:0
为探究生物膜对城市尾水的净化特征,通过采用联合生物膜生态浮床技术,考察生物膜长度、水力停留时间(HRT)及生物膜覆盖面积对含氮尾水的净化特征.结果表明,生物膜为1/2水深长度时,NH_4~+-N、NO_3~--N和TN的去除率分别可达到90. 82%、62. 7%和81. 96%,氮去除率较高,而生物膜长度为整个河道水深时,NH_4~+-N的去除率最高只有22. 07%,NO_3~--N和TN的浓度变化不明显.在HRT为6 d时,NH_4~+-N和TN的去除率最高分别可达到82. 01%和62. 88%,最低分别为55. 24%和46. 82%;当HRT为12 d时,NH_4~+-N和TN的去除率最高分别可达81. 4%和79. 93%,但最低分别达到了8. 73%和17. 23%,对比发现,HRT为6 d时氮的去除效率较高且稳定.在生物膜覆盖面积为10%时,一个运行周期内NH_4~+-N去除率呈下降趋势,而覆盖面积为20%时,去除率呈上升趋势; TN在10%和20%的膜覆盖面积条件下去除率分别为62. 88%和71. 09%. 相似文献
132.
以自行设计的反应器作为生态滤床的基础,采用活性污泥作为接种污泥,采用轻质陶粒作为生态滤床的滤料,对其进行挂膜.在整个挂膜过程中,温度控制在中温条件下,进水pH值控制在7左右,水力停留时间为24 h,进水方式为连续进水,并根据需要对曝气量进行调节.在挂膜过程中对进、出水的COD、NH_3-N、TP、Cl~-和pH进行检测,并刮取少量轻质陶粒上的生物膜制成镜检切片后用多媒体显微镜对生物膜的形态进行观察.研究结果表明,在中温条件下采用活性污泥作为接种污泥,以轻质陶粒为滤料的生态滤床在15 d内挂膜成功;且随着进水污染负荷的提高,其去除率也逐渐提高,其中COD的去除率最后稳定在95%左右,NH3-N的去除率稳定在85%左右,TP的去除率在挂膜后期达到了80%以上;Cl~-作为微生物所需的微量元素在微生物生长高峰期为50%,稳定期保持在20%左右;进水pH保持在7左右,出水pH略高于进水,在8左右;从第13 d和第15 d的切片可观察到轮虫这种象征生物膜成熟的微生物的出现,此外还有大量的丝状菌和菌胶团. 相似文献
133.
The disposal of sewage sludge from municipal waste water treatment plants is suffering from raising costs.The gasification is an alternative way of treatment, which can reduce the amount of solid residues that must be disposed from a water treatment plant. The produced gas can be used very flexible to produce electrical energy, to burn it very cleanly or to use it for upgrading.The gasification in the fluidised bed and the gas cleaning with the granular bed filter has shown successful operation. A demonstration plant in Balingen was set up in 2002 and rebuilt to a larger throughput in 2010. As a next step a demonstration plant was built in Mannheim and is now at the end of the commissioning phase. Nowadays the product gas is blended with biogas from sludge fermentation and utilized in a gas engine or combustion chamber to produce heat. In the future the process control for a maximized efficiency and the removal of organic and inorganic impurities in the gas will be further improved. 相似文献
134.
135.
Kristin Bunte Steven R. Abt 《Journal of the American Water Resources Association》2001,37(4):1001-1014
ABSTRACT: Improved sampling techniques are needed to increase the accuracy of pebble‐count particle‐size distributions used for stream studies in gravel‐bed streams. However, pebble counts are prone to operator errors introduced through subjective particle selection, serial correlation, and inaccurate particle‐size measurements. Errors in particle‐size measurements can be minimized by using a gravel template. Operator influence on particle selection can be minimized by using a sampling frame, 60 by 60 cm, in which sampling points are identified by the cross points of thin elastic bands. Serial correlation can be minimized by adjusting the spacing between the cross points and setting it equal to the dominant large particle size (=D95). In a field test in a cobble‐bed stream, the sampling frame developed in this study produced slightly coarser size distributions, particularly in the cobble range, than the traditional heel‐to‐toe walk that selects particles with a blind touch at the tip of the boot. The sampling frame produced more similar sampling results between two operators than heel‐to‐toe walks. The difference between the two sampling methods is attributed to an unbiased selection of fine and coarse particles when using the sampling frame. 相似文献
136.
137.
138.
采用多孔聚合物载体固定化微生物在厌氧流化床(AFB)反应器中处理含硫废水,研究反应器抗硫化物(S2-)毒性抑制和抗硫酸盐毒性抑制的能力;探索解除 S2-毒性的方法.研究表明,当进料基质 COD浓度为 5000mg/L,HRT为5.2-5.4h,S2-<200mg/L时,反应器去除 COD效果不受影响,S2-350mg/L时,厌氧消化受到明显抑制,反应器可容忍530mg/L S2-浓度而未造成消化系统的破坏;SO42-浓度高达3521mg/L,COD去除率仍可达77%-80%,但SO42-去除率明显下降;当COD/SO42-的比值大于1.45时,硫酸盐还原菌和产甲烷菌的生长未受到明显抑制,此时容积负荷为22-24kgCOD/(m3>·d),COD去除率为80%,SO42-去除率为58.8%;向反应器投加适量FeCl2可很好地解除S2-的抑制. 相似文献
139.
在日处理200t进口流化床垃圾焚烧炉上,进行烟气喷水降温加上喷消石灰粉末脱除尾气中的酸性气体HCl和SO2的试验研究,HCl和SO2浓度由布袋除尘器出口的在线气体分析仪测得,结果表明HCl和SO2的去除率在Ca/Cl摩尔比等于9时分别为80%和20%,说明该法消石灰利用率较低,宜改为半干法脱除HCl和SO2酸性气体,以便降低吸收剂用量,提高运行的经济性. 相似文献
140.
气-固流化床光催化氧化甲苯的研究 总被引:2,自引:0,他引:2
在自制的流化床光催化反应装置中研究了中低浓度(28~140mg/m3)甲苯的气相光催化降解过程,考察了光照时间、初始浓度、表观气速和催化剂负载量等因素对甲苯光催化降解率的影响规律。结果表明,紫外灯照射约1·5h,甲苯的转化率达最大值,甲苯初始浓度越低,维持此最大值的时间越久;在一定低浓度范围内(28~55mg/m3),甲苯的转化率不随浓度变化,符合一级反应动力学,浓度进一步增加,则甲苯的转化率下降;表观气速和催化剂负载量的最佳值分别为3·3Umf和0·19gTiO2/gSiO2。 相似文献