厌氧污泥床过滤器处理涤纶废水的生产性试验

采用厌氧泥床过滤器 (UASBAF)处理高浓度涤纶废水 ,试验结果表明 :UASBAF反应器具有较高的处理涤纶废水的效能 ,稳定运行容积负荷可达 10～ 12kg/m3 ·d ,水力停留时间 2 2～ 2 4h ,CODCr去除率 80 %左右 ,并具有启动快 ,耐冲击性负荷强的特点。     

煤与垃圾在流化床中的混烧利用技术分析

从技术、经济和环保等方面 ,对于煤与垃圾在流化床中的混烧利用技术进行了比较详细的分析。结果表明对于我国目前的垃圾 ,混烧比率宜小于 90 % ;垃圾收费和售电价格对于焚烧厂的经济状况影响很大 ,若从鼓励多焚烧垃圾而不是多发电的角度出发 ,应尽量增加垃圾收费补贴来使焚烧厂正常运行 ;与纯烧煤相比 ,混烧时除SOx 外 ,其余污染物排放均有所增加 ,但混烧有利于提高燃烧温度 ,破坏二英类物质的生成。该结果对于混烧处理厂的规划以及相关政策的制定有一定参考价值     

干化床和芦苇床稳定污泥过程中的腐殖化特征

通过现场实验,考查污泥干化床和污泥干化芦苇床稳定污泥过程中的腐殖质变化特征,重点分析了污泥腐殖化率和污泥腐殖化指数的变化情况。系统运行了3年,包括前2年的污泥负荷期和第3年的自然稳定期,检测分析在第3年进行。实验结果表明,污泥腐殖质含量历月变化不大,基本在1．1％～2．1％范围;总体上污泥的腐殖化率具有上升趋势,同一时间样品芦苇床中污泥的腐殖化率略高于干化床;污泥腐殖化指数呈上升趋势,但芦苇床略低于传统于化床;4-11月,干化床中的污泥腐殖化指数从0．079升高到0．742,芦苇床从0．042升高到0．715。经过3Y的稳定化处理,污泥的腐殖化程度和腐熟度得到有效提高。     

养猪舍不同发酵床垫料重金属Zn累积特征初探

为了研究养猪舍不同发酵床垫料及发酵床底部表层土壤中重金属Zn的累积特征与活性大小,以节约经济成本和适宜猪生长发育为前提选取3种发酵床垫料组合：FJ（40%稻壳＋60%菌糠）、FD（40%稻壳＋60%锯木屑）、FW（40%稻壳＋60%酒糟）,采用物质流分析（MFA）和潜在生态危害评价的方法进行研究。结果表明,一个在养猪周期过后,重金属Zn在垫料FD中累积量较大;而不同垫料对Zn活性大小的影响不同,FD中有效态Zn活性显著高于其他2种,所占比例高达25.01%,其次是FJ＆gt;FW（P＆lt;0.05）;表层土壤中,有效态Zn活性高低差异不显著（P＆gt;0.05）。所选取的3种垫料中,尽管Zn在FJ中累积量最小,渗漏到土壤中的全量Zn与有效态活性与其他2种垫料无明显差异,然而其潜在生态风险最小,因此从控制Zn污染角度出发,该配比垫料优于FD与FW。经过潜在生态危害评价分析,3种垫料在养殖结束后其潜在生态危害均未超过轻微生态危害临界值（Eir≤40）,在不断补充垫料的前提下发酵床可以使用约10年。     

Characteristics of high-sulfate wastewater treatment by two-phase anaerobic digestion process with Jet-loop anaerobic fluidized bed

A new anaerobic reactor, Jet-loop anaerobic fluidized bed （JLAFB）, was designed for treating high-sulfate wastewater. The treatment characteristics, including the effect of influent COD/SO42 ratio and alkalinity and sulfide inhibition in reactors, were discussed for a JLAFB and a general anaerobic fiuidized bed （AFB） reactor used as sulfate-reducing phase and methane-producing phase, respectively, in two-phase anaerobic digestion process. The formation of granules in the two reactors was also examined. The results indicated that COD and sulfate removal had different demand of influent COD/SO4^2- ratios. When total COD removal was up to 85%, the ratio was only required up to 1.2, whereas, total sulfate removal up to 95% required it exceeding 3.0. The alkalinity in the two reactors increased linearly with the growth of influent alkalinity. Moreover, the change of influent alkalinity had no significant effect on pH and volatile fatty acids （VFA） in the two reactors. Influent alkalinity kept at 400-500 mg/L could meet the requirement of the treating process. The JLAFB reactor had great advantage in avoiding sulfide and free-H2S accumulation and toxicity inhibition on microorganisms. When sulfate loading rate was up to 8. 1 kg/（m^3.d）, the sulfide and free-H2S concentrations in JLAFB reactor were 58.6 and 49.7 mg/L, respectively. Furthermore, the granules, with offwhite color, ellipse shape and diameters of 1.0-3.0 mm, could be developed in JLAFB reactor. In granules, different groups of bacteria were distributed in different layers, and some inorganic metal compounds such as Fe, Ca, Mg etc. were found.     

Invasive species and coal bed methane development in the Powder River Basin, Wyoming

One of the fastest growing areas of natural gas production is coal bed methane (CBM) due to the large monetary returns and increased demand for energy from consumers. The Powder River Basin, Wyoming is one of the most rapidly expanding areas of CBM development with projections of the establishment of up to 50,000 wells. CBM disturbances may make the native ecosystem more susceptible to invasion by non-native species, but there are few studies that have been conducted on the environmental impacts of this type of resource extraction. To evaluate the potential effects of CBM development on native plant species distribution and patterns of non-native plant invasion, 36 modified Forest Inventory and Analysis plots (each comprised of four 168-m² subplots) were established in the Powder River Basin, Wyoming. There were 73 168-m² subplots on control sites; 42 subplots on secondary disturbances; 14 on major surface disturbances; eight on well pads; and seven on sites downslope of CBM wells water discharge points. Native plant species cover ranged from 39.5 ± 2.7% (mean ± 1 SE) in the secondary disturbance subplots to 17.7 ± 7.5% in the pad subplots. Non-native plant species cover ranged from 31.0 ± 8.4% in the discharge areas to 14.7 ± 8.9% in the pad subplots. The control subplots had significantly less non-native species richness than the combined disturbance types. The combined disturbance subplots had significantly greater soil salinity than the control sites. These results suggest that CBM development and associated disturbances may facilitate the establishment of non-native plants. Future research and management decisions should consider the accumulative landscape-scale effects of CBM development on preserving native plant diversity.     

Resource recovery potential from secondary components of segregated municipal solid wastes

Fermentable components of municipal solid wastes (MSW) such as fruit and vegetable wastes (FVW), leaf litter, paddy straw, cane bagasse, cane trash and paper are generated in large quantities at various pockets of the city. These form potential feedstocks for decentralized biogas plants to be operated in the vicinity. We characterized the fermentation potential of six of the above MSW fractions for their suitability to be converted to biogas and anaerobic compost using the solid-state stratified bed (SSB) process in a laboratory study. FVW and leaf litter (paper mulberry leaves) decomposed almost completely while paddy straw, sugarcane trash, sugarcane bagasse and photocopying paper decomposed to a lower extent. In the SSB process between 50–60% of the biological methane potential (BMP) could be realized. Observations revealed that the SSB process needs to be adapted differently for each of the feedstocks to obtain a higher gas recovery. Bagasse produced the largest fraction of anaerobic compost (fermentation residue) and has the potential for reuse in many ways.     

初论地表粗糙度

粗糙度是流体力学引进的一个重要参数,是现代地球表面各种物质流运动研究中不可或缺的一个重要概念。它在定床流动中曾获得巨大的成功,但在动床及所谓零位移较大的粗糙面上,表现出其局限性。文章在系统阐述了空气动力学意义上粗糙度概念的由来及其物理意义;在总结某些学科领域中粗糙度的应用成果基础上,发现对于定床,地表粗糙具有地表阻力系数特性,它比地表物体群落平均高度小一个量级;而对于动床,粗糙度则更具有阻力系数的特性,它与超出临界摩阻之值成正比;至于植被地表的粗糙度则近似于定床,但它要从零平面位移高度算起。因此,地表粗糙度概念的进一步完善应从地表阻力系数和实验研究入手,并加强自然界和室内实验室的观测和实验以获得相应系数的变化规律,最终解决粗糙度本身和流体力学相关的理论和实践问题。     

三层混床技术在水处理装置中的应用

某化肥厂水处理装置采用混合离子交换器生产精制水,针对现存的阴阳双层离子交换树脂交叉污染问题,在不改变设备结构及工艺的前提下,采用三层混床技术将阴阳离子树脂彻底分离,有效消除了交叉污染问题,再生次数减少,混床运行周期平均延长到10d,周期制水量由原来的3.02×104 m3提高到4.32×104 m3;再生酸碱消耗量、用水量和污水排放量都得到了降低。     

库车坳陷复合盐层高密度环保钻井液技术研究

通过对处理剂环保性能评价及作用效果优选、高密度环保钻井液配方及其钻井液的流变性、失水性、抗温性、抑制性、抗污染等综合性能评价等一系列实验研究,形成了一套适合山前构造带的环保钻井液体系。该钻井液具有无毒、易降解、密度高(2.0g/cm3和2.3g/cm3)、高温高压失水低、流变性好、抗高温可达130～140℃,性能稳定,抑制性、润滑性能好,抗污染能力强,既能够满足复合盐层钻井工程需求,又具环保性能好的特点。