CaCO_3对生活垃圾热解气体组成的影响

利用固定床反应器,选用CaCO_3和SiO_2为添加剂,进行了生活垃圾催化热解实验研究,结果表明,CaCO_3在生活垃圾热解中的催化作用比SiO_2更加明显。为此,研究了不同CaCO_3添加量对热解可燃气产量的影响,探讨了CaCO_3在生活垃圾热解过程中的催化作用机理,重点分析了CaCO_3对生活垃圾热解气中CH_4和CO的影响机理。通过对比分析生活垃圾中添加不同量CaO的热解实验结果,得出CaCO3的催化作用主要在于其分解产物CaO促进了垃圾的二次热解,以及CO_2与C的还原反应。     

基于微波热解技术的竹炭、竹醋生产设备研究

基于现有竹炭、竹醋生产工艺流程及工业技术水平,设计了一套具有创新性的竹炭、竹醋生产设备,并给出了设备完整的结构以及包括微波源功率在内的关键制造参数.该设备首次引入微波热解技术代替传统的燃烧加热方法,同时窑炉整体设计遵循节约生产空间、原料充分转化、废气废渣循环处理、热量多级利用、全封闭式生产、自动化控制等节能、环保、高效的思想.此外,在对微波源的设计上依据多源溃能理论,采用以小功率磁控管组合代替大功率磁控管设计,从而大幅降低设备的制造成本,提高微波源的使用寿命及工作稳定性.     

Differences in physical properties and CO2 gasification reactivity between coal char and petroleum coke

This paper mainly investigated the physical properties and gasification reactivity of coal char and petroleum coke, separately at the high temperature pyrolysis (950–1400 °C) with slow heating rate and pyrolysis pressure of the atmospheric pressure and at the pressurized pyrolysis (the atmospheric pressure to 3 MPa) with rapid heating rate and the pyrolysis temperature of 950 °C. Some significant differences in those between coal chars and petroleum coke were found. The high temperature pyrolysis caused more easily the graphitization of petroleum coke than that of coal char, especially in the higher temperature range. The increasing pyrolysis temperature resulted in the decrease of surface areas of coal char and the increase of surface areas of petroleum coke. As the pyrolysis pressure was elevated from the atmospheric pressure to 3 MPa, surface areas of petroleum coke initially increased and then decreased, while those of coal chars presented an opposite tendency. The increasing pyrolysis temperature was adverse to the gasification activity of coal chars and was favorable for the gasification activity of petroleum coke. Also, the effects of the pyrolysis pressure on the gasification activity of coal char and petroleum coke were significantly different. The gasification activity of petroleum coke was obviously lower than that of coal chars, and even lower than that of the natural graphite.     

醇酸清漆对典型装饰木材燃烧特性和生烟特性的影响

为了探讨醇酸清漆对典型装饰木材火灾危险性的影响,利用热重分析、差热分析、木垛法、隧道法和塑料烟密度仪对装饰木材的燃烧性能、热解特性和生烟特性进行了分析。结果表明,木材及其表面涂覆的醇酸清漆主要热失重发生在200~500℃,其中木材的热解过程为先吸热、后放热的过程,而醇酸清漆为吸热过程。与未涂覆清漆的木材相比,清漆使木材在燃烧过程中质量损失、有焰燃烧时间及火焰传播比值明显增加。同时,醇酸清漆的烯烃结构和苯环结构还导致木材的比光密度、质量光密度增大,烟气危害增大,从而进一步增大了火灾危险性。此外,装饰木材的生烟特性还受火焰条件和辐射功率的影响,高辐射功率和有焰条件下材料的比光密度和质量光密度均较低。     

NaOH碱促热解磷酸铵镁产物沉氨性能研究

药剂费用过高是阻碍磷酸铵镁结晶技术应用的难题之一,通过磷酸铵镁热解产物循环沉氨可降低药剂费用.但湿法热解会生成热稳定性更好的NH4MgPO4·H2O,从而增加了磷酸铵镁热解的能耗.采用干法热解时,由于不引入额外的水分子,可以降低磷酸铵镁的热解温度.同时,在磷酸铰镁热解过程中加入NaOH碱促试剂,可有效促进磷酸铵镁释放NH4+,提高热解产物的沉氨效率,但同时上清液磷酸盐残留量也随NaOH添加量和热解温度提高而增加.热解温度为110℃时,直接热解产物沉氨效率为84％,而NaOH碱促热解产物沉氨率达到87％(NaOH与NH4+物质的量比为1:1),但此时上清液磷酸盐残留质量浓度达到2.3 mg/L,略高于GB 8978-1996《国家污水综合排放标准》的1.0 mg/L,方便废水的后续处理.     

污水厂污泥在不同氧气浓度下的热分析动力学特性研究

为了解在不同氧气浓度下污泥的热解燃烧行为和动力学机理,利用热重差热分析仪,在不同氧气浓度下,对经过不同干燥温度干燥的污泥样品进行热重差热实验.通过分析氧气浓度和干燥温度对样品热分析曲线的影响发现,干燥温度对污泥样品热分析的影响很小,但氧气浓度对其有明显的影响;随着氧气浓度的增加,热分析曲线有规律的向左偏移.在此基础上,提出污泥在不同氧气浓度条件下3种物质独立反应的热化学反应动力学模型.在该模型中,3个阶段分别对应3种不同的物质独立反应.在各种氧气浓度条件下,这3种物质的反应过程均符合一级反应模型.随着氧气浓度的上升,3个阶段对应的活化能和频率因子呈现上升趋势.     

废聚苯乙烯的化学回收方法

废聚乙烯（ＰＳ）转化为燃料油和化学品的化学回收方法,分为废ＰＳ单独裂解及废ＰＳ与其它废塑料混合裂解两种方式,分别阐述了两种回收方式的研究成果和工艺现状,并就存在的问题进行了讨论。     

城市生活垃圾在热解处理中的产气特性研究

通过对沈阳市皇姑区内的3个垃圾排放点进行实地采样并分类称量,得出其组分含量,得到了生活垃圾的主要物料组份.在此基础上在外加热固定床式热解试验台上,用热解实验的方法对8种城市生活垃圾中的主要物料中的典型成分进行热解试验.通过数据分析总结出不同工况下产气特性和热解气体的组分含量、热值,并建立热解气体析出模型进行产气量预测.     

Pyrolysis of commingled waste textile fibers in a batch reactor: Analysis of the pyrolysis gases and solid product

The main object of this study was the investigation of the thermal recycling of commingled waste textile fibers, with the aim of the production of useful end products. Differential scanning calorimetry/Thermo gravimetric analysis (DSC/TGA) was applied to determine the thermal degradation characteristics of the commingled waste textile fibers and there are two peaks located at the temperature ranges of 299–360°C and 399–500°C. Commingled waste fiber was pyrolyzed in a nitrogen atmosphere in relation to three different temperatures (500, 600, and 700°C), heating rates (25 and 50°C min^?1), and retention times (15 and 30 min). The effect of the experimental conditions such as pyrolysis temperature, heating rates, and retention time on the formation of char and gas--liquid products was investigated and the product yields were determined from the rate of the weight loss. The highest conversion rate 82.9 wt.% liquid--gas product and 17.1 wt.% char product was achieved at 700°C. Pyrolysis gases were taken for every 7, 15, and 25 min and were analyzed for major components such as CO, CO₂, CH₄, and H₂ by gas chromatography. The pyrolysis char called as carbon black derived from the pyrolysis of commingled waste textile fibers was analyzed for a range of properties, including the elemental analysis, moisture content, ash content, calorific value, and trace metal analysis.