UV/SPS降解水中三氯生的效能及动力学

采用短波紫外光激活过硫酸钠(UV/SPS)对水中三氯生(TCS)的去除进行了研究,考察了紫外光波长、紫外光强、过硫酸钠(SPS)投加量、pH值和腐殖酸(HA)等因素对TCS去除的影响,计算了自由基(·OH、SO_4~(·-))与TCS的二级反应速率常数及其对TCS去除的贡献值,鉴定了反应中主导自由基,对比了UV254/SPS和UV254/H_2O_2对天然水体中TCS的去除效果,GC/MS分析了TCS降解的中间产物及可能的降解路径.结果表明UV/SPS能有效去除TCS,紫外光波长为254nm,光强为11.5μW·cm-2,SPS浓度为1 mmol·L~(-1)时,100s后初始浓度为275μg·L~(-1)的TCS去除率可达98.15%,TCS降解过程符合拟一级反应动力学方程,其动力学常数K=0.039 2 s~(-1).实验范围内TCS去除的速率常数随紫外光强(I)和SPS投加量的增加而增大,波长对TCS去除影响不显著,中性条件不利于TCS降解,HA对TCS去除具有抑制作用.·OH和SO_4~(·-)与TCS反应速率常数分别为7.62×109L·mol~(-1)·s~(-1)、9.86×109L·mol~(-1)·s~(-1),UV254/SPS中主导自由基为SO_4~(·-),其对TCS去除贡献率为97.63%.UV254/SPS工艺更能有效地去除TCS,其拟一级动力学常数K值是UV254/H_2O_2工艺的4.13倍.TCS降解过程中主要生成了2,4-二氯苯酚(2,4-DCP)、苯酚等中间产物.     

表面活性剂辅助离子液体预处理稻秆的酶解动力学与结构变化分析

以稻秆为原料进行酶解研究,考察了纤维素酶和β-葡萄糖苷酶单独作用及协同作用对稻秆酶解还原糖产量的影响,以确定最佳酶体系,并研究在最佳酶体系中不同种类表面活性剂辅助离子液体对稻秆酶解的影响和动力学特征,最后通过稻秆成分分析、FTIR、XRD、SEM对预处理前后的稻秆结构、结晶性进行了分析比较.结果表明,纤维素酶与β-葡萄糖苷酶具有协同作用,而且在最佳酶体系中,与未处理稻秆及单独离子液体预处理相比,不同种类表面活性剂辅助离子液体预处理的稻秆在酶水解48 h时纤维转化率分别增加40%~85%、10%~31%,并且预处理对反应速率的提高有促进作用.     

羊粪生物炭对水体中诺氟沙星的吸附特性

以羊粪为原料分别在350、450、550、650℃条件下制备生物炭,通过元素分析、BET-N_2、电镜扫描及FTIR表征了不同热解温度下羊粪生物炭的结构特征,并采用序批实验研究了pH、生物炭投加量、热解温度、初始浓度等因素对羊粪生物炭吸附水体中诺氟沙星(NOR)的影响及吸附机制.结果表明,随着热解温度的升高,生物炭的比表面积、总孔容、平均孔径增大,芳香性和稳定性也有所提高.羊粪生物炭吸附NOR的最佳初始pH为6.0,吸附在180 min左右达到平衡,采用准二级动力学模型能更好地拟合动力学数据(R~20.96),吸附速率由表面吸附和颗粒内扩散共同控制.等温吸附拟合发现,Langmuir模型能较好地描述NOR在羊粪生物炭上的吸附行为(R~20.93),吸附过程均为有利吸附,且可能与氢键和π-π键作用密切相关,4种热解温度下生物炭的吸附能力大小为:650℃550℃450℃350℃.吸附过程中ΔGθ0、ΔHθ0、ΔSθ0,表明羊粪生物炭对NOR的吸附是自发、吸热及熵增加的过程.650℃和550℃条件下制备的羊粪生物炭可作为水体中NOR的优势吸附材料.     

Diffusion mechanism of lindane into wood charcoal

Abstract

The wood charcoal treated by 1N HNO₃ (WCT) was used to remove toxic chlorinated pesticide lindane (y‐HCH) residue from water by the sorption process. Using a simple first order reversible kinetics constants and half time equations, the film and pore diffusion coefficients were determined. Film diffusion was found to be rate limiting step in sorbing lindane by WCT. This was further authenticated by kinetics studies at different initial sorbate concentrations, different sorbent sizes, and different agitation speeds besides interruption test. A pore diffusion model was used to fit the data of kinetics in continuously mixed batch reactors (CMBR), and the tortuosity, external resistance, and surface diffusion effects on lindane sorption by WCT were noticed. The tortuosity values of 15 to 28 were obtained for WCT‐lindane system.     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.     

Sorption and desorption kinetics of diuron,fluometuron, prometryn and pyrithiobac sodium in soils

Abstract

The sorption and desorption characteristics of four herbicides (diuron, fluometuron, prometryn and pyrithiobac‐sodium) in three different cotton growing soils of Australia was investigated. Kinetics and equilibrium sorption and desorption isotherms were determined using the batch equilibrium technique. Sorption was rapid (> 80% in 2 h) and sorption equilibrium was achieved within a short period of time (ca 4 h) for all herbicides. Sorption isotherms of the four herbicides were described by Freundlich equation with an r² value > 0.98. The herbicide sorption as measured by the distribution coefficient (K_d) values ranged from 3.24 to 5.71 L/kg for diuron, 0.44 to 1.13 L/kg for fluometuron, 1.78 to 6.04 L/kg for prometryn and 0.22 to 0.59 L/kg for pyrithiobac‐sodium. Sorption of herbicides was higher in the Moree soil than in Narrabri and Wee Waa soils. When the K_d values were normalised to organic carbon content of the soils (K_oC), it suggested that the affinity of the herbicides to the organic carbon increased in the order: pyrithiobac‐sodium < fluometuron < prometryn < diuron. The desorption isotherms were also adequately described by the Freundlich equation. For desorption, all herbicides exhibited hysteresis and the hysteresis was stronger for highly sorbed herbicides (diuron and prometryn) than the weakly sorbed herbicides (fluometuron and pyrithiobac‐sodium). Hysteresis was also quantified as the percentage of sorbed herbicides which is not released during the desorption step ω = [n_ad / n_de ‐1] x 100). Soil type and initial concentration had significant effect on ω. The effect of sorption and desorption properties of these four herbicides on the off‐site transport to contaminate surface and groundwater are also discussed in this paper.     

生化法处理含氨废水动力学研究

对生化法处理含氨废水过去中有重要影响的动力学因素进行了试验研究和分析，得出了利用高效微生物菌群废水中COD和NH3－N的动力学条件，温度为20－35℃，PH为7－8，DO大于2.6mg/L,MLSS大于2.6g/L，C／N小于3。在此条件下处理含氨废水，处理后的出水达到国家化肥行业一级排放标准。     

有机废气的臭氧化过程降解及其动力学

实验研究了有机废气中的1.1-二氧乙烯（CH2=CCl2）在101.3kPa和288～308K下气相臭氧化降解过程及其反应动力学。结果表明，总的反应级数是2级，相对于臭氧和二氯乙烯浓度均为1级。反应速率常数可用方程Arrhenius（k2=8.32exp[-389.7/T]）表示。     

钢渣吸附Pb2+的动力学研究

采用批式振荡吸附法研究了钢渣吸附Pb^2＋的动力学。研究结果表明,钢渣吸附Pb^2＋的动力学控制步骤（简称动力学控制步骤）随实验条件的变化而变化：钢渣粒径大于120μm、振荡器转速小于150r/min或Pb^2＋初始质量浓度小于150mg/L时,孔扩散是动力学控制步骤;钢渣粒径小于120μm、振荡器转速大于150r/min或Pb^2＋初始质量浓度大于150mg/L时,表面扩散是动力学控制步骤;钢渣对Pb^2＋的吸附反应是二级反应,其吸附速率为13.26g/（mg.min）。     

Adsorption behavior of ammonium by a bioadsorbent - Boston ivy leaf powder

The adsorption behaviors of ammonium ions from aqueous solution by a novel bioadsorbent,the Boston ivy (Parthenocissus tricuspidata) leaf powder (BPTL) were investigated.The SEM images and FT-IR spectra were used to characterize BPTL.The mathematical models were used to analyze the adsorption kinetics and isotherms.The optimum pH range for ammonium adsorption by BPTL was found to be 5-10.The adsorption reached equilibrium at 14 hr,and the kinetic data were well fitted by the Logistic model.The intraparticle diffusion was the main rate-controlling step of the adsorption process.The high temperature was favorableto the ammonium adsorption by BPTL,indicating that the adsorption was endothermic.The adsorption equilibrium fitted well to both the Langrnuir model and Freundlich model,and the maximum monolayer adsorption capacities calculated from Langmuir model were 3.37,5.28 and 6.59 mg N/g at 15,25 and 35℃,respectively,which were comparable to those by reported minerals.Both the separation factor (RL) from the Langmuir model and Freundlich exponent (n) suggested that the ammonium adsorption by BPTL was favorable.Therefore,the Boston ivy leaf powder could be considered a novel bioadsorbent for ammonium removal from aqueous solution.