碱渣对铜(Ⅱ)离子吸附特征的研究

研究了铜在碱渣表面的吸附特征.结果表明,碱渣总吸附量随体系温度的升高而降低;随体系pH值的升高而增加;随吸附质初始浓度的增加而增大.在pH《5.01时其等温吸附能较好地符合Freudlich等温吸附规律,而在pH》5.01时,能较好地符合Langmuir等温吸附规律,吸附热随pH值的增大而升高.当pH≤4.54时,碱渣的吸附力以偶极间力和氢键力的作用为主,而当pH》4.54时,以化学键力为主.碱渣的动力学方程亦随pH值的改变而改变,在pH=4.54时,碱渣对Cu2 的吸附动力学方程以一级动力学方程拟合效果最优;当pH为4.91和6.01时,以Langmuir方程的拟合效果最优.     

微生物对土壤和沉积物吸附多环芳烃动力学的影响

以枯草芽孢杆菌为接种微生物,研究微生物对沉积物和湿地土壤吸附菲和苯并[a]芘(BaP)吸附动力学的影响.结果表明:枯草芽孢杆菌对菲与BaP都可进行生物降解,对菲的利用率明显要大于BaP;接种微生物的土壤与沉积物对菲和BaP的吸附动力曲线与仅有微生物吸附的结果相近似,表明多环芳烃的降低主要是由于微生物的利用造成的;接种微生物后沉积物与土壤对菲的吸附量明显增大,而对BaP的吸附却降低.     

Radiation-induced reduction of chromium(Ⅵ) in aqueous solution by γ-irradiation in a laboratory-scale

Radiation-induced reduction of chromium(Ⅵ)(Cr(Ⅵ) by γ-irradiation was studied with an initial concentration of 42 mg/L in aqueous solutions. Several factors which might affect the reduction of Cr(Ⅵ) to Cr(Ⅲ) were examined. pH of aqueous solution affects the reduction efficiency significantly. Acidic condition of aqueous solution accelerates the process. At pH 2, a reduction of 86.2%was achieved with the absorbed dose of 15 kGy, while, with the same dose, at pH 5 and 7, the reduction of Cr (Ⅵ) were only 36.3%and 22.2%, respectively. Ethanol (0.1% in V:V) and sodium carbonate (1 mmol/L) were added into the solution respectively as relatively non-toxic hydroxyl radical scavengers. Reduction rate increased greatly in the presence of ethanol at each pH. Reduction efficiency of Cr(Ⅵ) was enhanced in neutral condition with the addition of sodium carbonate, however, no enhancement was found in acidic condition. The reduction of Cr(Ⅵ) was restrained when the solution was saturated with oxygen; however, the restraint was not significant.     

Kinetics study on photochemical oxidation of polyacrylamide by ozone combined with hydrogen peroxide and ultraviolet radiation

An investigation on the process of ozone combined with hydrogen peroxide and ultraviolet radiation has been carried out in order to establish the kinetics for photochemical oxidation of polyacrylamide （PAM） in aqueous solution. Effects of operating parameters, including initial PAM concentration, dosages of ozone and hydrogen peroxide, UV radiation and pH value on the photochemical oxidation of PAM, have been studied. There was an increase in photochemical oxidation rate of PAM with increasing of dosages of 03, H2O2 and ultraviolet radiation. Upon increasing of the initial PAM concentration, the photochemical oxidation rate of PAM decreased. Slight effect of pH value on the photochemical oxidation rate of PAM was observed in the experiments. The kinetics equation for the photochemical oxidation of PAM by the system has been established.     

烷基多糖苷季铵盐改性粘土治理赤潮研究

研究了新型表面活性剂烷基多糖苷季铵盐在2种粘土高岭土和膨润土上的吸附行为,发现其在2种粘土上的吸附符合Langmuir吸附等温线,并且吸附速率很快,在1～2min之内就能够达到吸附平衡,经红外分析发现其可以对粘土进行有效改性.在此基础上,还研究了烷基多糖苷季铵盐对东海原甲藻、强壮前沟藻、锥状斯氏藻生长的影响以及2种有机改性粘土对赤潮藻的去除情况和絮凝动力学.结果表明,烷基多糖苷季铵盐用量分别为0～0.4 mg/L、0～0.5 mg/L、0～0.8 mg/L时,对上述3种藻的生长只是抑制作用;当浓度为0.6～1.2 mg/L、0.75～1.5 mg/L、1.2～2.4 mg/L时,就会阻碍上述3种藻的生长,并且3d之后能够使其几乎全部死亡.用其改性粘土后,在与原土相同的用量条件下可将对赤潮藻的去除率从20%左右提高到90%以上,大大降低了有效去除赤潮藻的粘土用量.其沉降动力学研究表明,粘土的种类、用量以及改性剂的用量都是影响体系沉降速率的重要因素,在实际应用中可以根据不同的情况而改变其中的某个因素以达到提高沉降速率的效果.     

Fenton试剂预处理高浓度丁腈胶乳生产废水

采用Fenton试剂预处理高浓度丁腈胶乳生产废水,确定最佳操作条件为:[H2O2]= 2 664 mg/L,[Fe2 ]=219 mg/L,初始pH=5.0,25 ℃下反应60 min,此条件下废水COD去除率可达80%以上.经正交试验得出各因素对废水COD去除率的影响顺序为:pH＞[H2O2]＞[Fe2 ]＞反应时间.动力学研究表明,在此最佳操作条件下,反应近似符合一级反应动力学,动力学方程ln(C0/C)=0.018 7t 0.783 1,反应速率常数k=0.018 7 min-1,半衰期t 1/2=37.1 min.     

改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附

通过批量实验研究了改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附特性.Langmuir和Freundlich吸附等温方程被用于分析吸附等温数据,准一级动力学模型、准二级动力学模型和颗粒扩散模型被用于吸附动力学实验数据分析.结果表明,改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附过程符合Langmuir和Freundlich吸附等温方程,最大吸附量达到71.43 mg·g^-1;颗粒扩散模型能够很好地描述改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附动力学过程,水溶液中染料的初始浓度、颗粒直径、颗粒量及搅拌速度对吸附速率均产生一定的影响.改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附作用主要发生在颗粒的外表面.     

滴流床反应器中苯酚催化湿式氧化集总反应动力学研究

在自行研制的滴流床反应器中,以苯酚配水溶液作为研究对象,采用负载型CuO/γ-Al2O3作为催化剂,于连续流工况下实验研究了苯酚催化湿式氧化(CWO)过程,建立了滴流床反应器拟均相一维活塞流模型,并结合集总动力学反应模型对实验数据进行拟合.该模型计算值均能较好的预测实验结果;模型引入了集总动力学概念,较深入地解释了催化湿式氧化反应过程.由模型计算所得的动力学参数表明,在所使用的催化剂上苯酚较易氧化为中间产物,但苯酚和中间产物的深度氧化不易进行.     

活性炭-微波辐照处理丁腈胶乳生产废水的研究

以活性炭-微波辐照工艺处理丁腈胶乳生产废水,考察了催化剂的种类及用量、废水初始浓度、废水初始pH值、微波辐照时间和微波功率等对废水COD去除率的影响.结果表明,采用3 g粉末活性炭处理100 mL COD浓度为3500 mg/L左右的丁腈胶乳废水,在微波辐照功率为200 W,辐照时间4 min的条件下,废水COD去除率最高可达96.6%.动力学研究表明,在最佳操作条件下的反应表观过程近似符合一级反应规律,动力学方程为In(C0/C)=0.6034t 0.9247(R=0.9926),反应速率常数k=0.6034 min-1,半衰期t1/2=1.15 min.     

好氧氨氧化菌混培物的氨氧化动力学研究

采用批式呼吸法求得好氧氨氧化菌产率系数为0.2119 mg COD/mg NH4 -NOD(或者0.7268 mg COD/mg NH4 -N)和氨氧化菌最大氨氮降解速率为0.1 mg NOD/(mg COD·h)(或者0.0292 mg N/(mg COD·h)).用间歇式批试验法,加入24 μmol/L NaN3抑制NO2--N氧化,建立氨氧化反应动力学方程,得到氨氮半饱和系数为18.38 mg NOD/L(或者5.36 mg NH4 -N/L),DO半饱和系数为0.494 mg/L.对比参数值表明,用一步硝化动力学来描述氨氧化反应动力学模型是错误的.