Ra–Po–Pb isotope systematics in waters of Sambhar Salt Lake,Rajasthan (India): geochemical characterization and particulate reactivity

The Sambhar Salt Lake hydrological system, including river waters, groundwaters, evaporating pans and sub-surface brines, has been analyzed for the salt content (TDS) and naturally occurring radionuclides (²¹⁰Po, ²¹⁰Pb and ^226,228Ra). The abundance of these radionuclides and their activity ratios show a wide variation in different hydrological regimes, which helps to geochemically characterize the lake system. A significantly lower Ra to total dissolved solids (TDS) ratio in the brines (by two to three orders of magnitude), when compared to the groundwaters and river waters, suggests removal of dissolved Ra by co-precipitation with Ca–Mg minerals at an early stage of the brine evolution. The concentration of Ra in evaporating lake/pan waters saturates at a value of about 35 Bq L⁻¹ over the salinity range of 100–370 g L⁻¹; attributable to its equilibration with the clay minerals. The two distinct regimes, saline lake system (lake water, evaporating pans and sub-surface brines) and groundwaters have been identified based on their differences in the distribution of ^226,228Ra isotopes. This observation points to the conclusion that the groundwaters and the lake brines are not intimately coupled in terms of their origin and evolution. The abundances of ²¹⁰Po and ²¹⁰Pb along with their activity ratios (²¹⁰Po/²¹⁰Pb) are markedly different among the surface lake waters/evaporating pans, sub-surface lake brines and groundwaters. These differences are explained in terms of different geochemical behaviour of these nuclides in presence of algae and organic matter present in these water regimes.     

纳米镍/铁和铜/铁双金属对四氯乙烯脱氯研究

以实验室合成的纳米双金属颗粒(Ni/Fe和Cu/Fe)为反应材料,对四氯乙烯(PCE)进行脱氯试验研究.纳米金属颗粒(直径范围在1～100nm)比表面积比微米级铁颗粒高数十倍.结果表明,纳米Ni/Fe和Cu/Fe对四氯乙烯有明显的脱氯作用,且脱氯反应符合准一级反应动力学方程;在作为还原剂的铁表面镀上一薄层起催化作用的金属Ni或Cu,催化剂的存在大大降低脱氯反应活化能,提高了脱氯速率,并减少氯代副产物的产量.与零价铁及微米级双金属系统(Ni/Fe,Cu/Fe)相比,纳米颗粒对PCE的脱氯速率有明显提高,尤其是纳米Ni/Fe,标准化反应速率常数KSA为4.283 mL·m-2·h-1,分别比零价铁和微米级Ni/Fe系统快33.23倍和11.59倍.纳米Cu/Fe标准化反应速率常数KSA为1.194 mL·m-2·h-1,分别比零价铁和微米级Cu/Fe双金属系统快9.26倍和5.24倍.在相同条件下,纳米Ni/Fe脱氯速率常数KSA是纳米Cu/Fe的3.59倍.     

金属氧化物直接分解CO2成C的活性分析

复各种类型的简简单和复合金属氧化物在Ｈ２还原活性化前后分解ＣＯ２成Ｃ活的性试验的结果，决定金属氧化物分解ＣＯ２活性的因素是氧缺位程度石结构及其含铁相。     

A review of atmospheric benzene homologues in China: Characterization, health risk assessment, source identification and countermeasures

Benzene homologues are important chemical precursors to the formation of ground-level ozone and secondary organic aerosol (SOA) in the atmosphere, in addition, some toxic species are harmful to human health. Strict countermeasures have been taken to fight air pollution since 2013, and total amount control of volatile organic compounds is being promoted in China at present. Therefore, it is important to understand the pollution situation and the control status of ambient benzene homologues in China. This paper reviews research progress from published papers on pollution characteristics, atmospheric photochemical reactivity, health risk assessment and source identification of ambient benzene homologues in recent years in China, and also summarizes policies and countermeasures for the control of ambient benzene homologues and the relevant achievements. The total ambient levels of benzene, toluene, ethylbenzene and xylenes (BTEX) shows a declining tendency from 2001 to 2016 in China. The mass concentrations of BTEX are generally higher in southern regions than in northern regions, and they present vertical decreasing variation characteristics with increasing altitude within the height range of about 5500 m. Toluene has the highest ozone formation potential and SOA formation potential both in urban areas and background areas, while benzene poses an obvious carcinogenic risk to the exposed adult populations in urban areas. Source identification of ambient benzene homologues suggested that local governments should adopt differentiated control strategies for ambient benzene homologues. Several recommendations are put forward for future research and policy-making on the control of ambient benzene homologues in China.     

典型光化学污染期间杭州大气挥发性有机物污染特征及反应活性

在2018年9月14～23日选取了典型光化学污染期间,在长三角重点城市杭州市城区开展大气中挥发性有机物(VOCs)的加密观测.对80个有效样品分析结果表明,观测期间大气VOCs的122种化合物平均体积分数为(59.5±19.8)×10~(-9),含氧化合物(OVOC)是其中最主要的组分.用臭氧生成潜势(OFP)评估大气反应活性结果表明,观测期间OFP平均值为145×10~(-9),其中贡献最大的是芳烃和醛酮化合物.其大气VOCs整体活性水平与丙烯腈相当.运用正交矩阵因子(PMF)模型对VOCs进行源解析后,识别出杭州市大气VOCs的5个主要污染源,分别为二次生成(25.2%)、燃烧及工艺过程(27.2%)、溶剂使用(17.3%)、天然源(9.2%)和机动车排放(21.2%).本研究结果可为深入掌握杭州市VOCs污染特征以及科学制定防控措施提供技术支撑.     

Differences in physical properties and CO2 gasification reactivity between coal char and petroleum coke

This paper mainly investigated the physical properties and gasification reactivity of coal char and petroleum coke, separately at the high temperature pyrolysis (950–1400 °C) with slow heating rate and pyrolysis pressure of the atmospheric pressure and at the pressurized pyrolysis (the atmospheric pressure to 3 MPa) with rapid heating rate and the pyrolysis temperature of 950 °C. Some significant differences in those between coal chars and petroleum coke were found. The high temperature pyrolysis caused more easily the graphitization of petroleum coke than that of coal char, especially in the higher temperature range. The increasing pyrolysis temperature resulted in the decrease of surface areas of coal char and the increase of surface areas of petroleum coke. As the pyrolysis pressure was elevated from the atmospheric pressure to 3 MPa, surface areas of petroleum coke initially increased and then decreased, while those of coal chars presented an opposite tendency. The increasing pyrolysis temperature was adverse to the gasification activity of coal chars and was favorable for the gasification activity of petroleum coke. Also, the effects of the pyrolysis pressure on the gasification activity of coal char and petroleum coke were significantly different. The gasification activity of petroleum coke was obviously lower than that of coal chars, and even lower than that of the natural graphite.     

化工生产装置活性危害评估

活性危害的评估由理论筛选,热稳定性的实验筛选,动力学参数的检测装置,紧急排放系统的设计、筛选和放大,过程设计和优化等几个部分组成.     

Upscaling heterogeneity in aquifer reactivity via exposure-time concept: forward model

Reactive properties of aquifer solid phase materials play an important role in solute fate and transport in the natural subsurface on time scales ranging from years in contaminant remediation to millennia in dynamics of aqueous geochemistry. Quantitative tools for dealing with the impact of natural heterogeneity in solid phase reactivity on solute fate and transport are limited. Here we describe the use of a structural variable to keep track of solute flux exposure to reactive surfaces. With this approach, we develop a non-reactive tracer model that is useful for determining the signature of multi-scale reactive solid heterogeneity in terms of solute flux distributions at the field scale, given realizations of three-dimensional reactive site density fields. First, a governing Eulerian equation for the non-reactive tracer model is determined by an upscaling technique in which it is found that the exposure time of solution to reactive surface areas evolves via both a macroscopic velocity and a macroscopic dispersion in the artificial dimension of exposure time. Second, we focus on the Lagrangian approach in the context of a streamtube ensemble and demonstrate the use of the distribution of solute flux over the exposure time dimension in modeling two-dimensional transport of a solute undergoing simplified linear reversible reactions, in hypothetical conditions following prior laboratory experiments. The distribution of solute flux over exposure time in a given case is a signature of the impact of heterogeneous aquifer reactivity coupled with a particular physical heterogeneity, boundary conditions, and hydraulic gradient. Rigorous application of this approach in a simulation sense is limited here to linear kinetically controlled reactions.     

What is the acceptable margin of error for the oxygen uptake method in evaluating the reactivity of organic waste?

The acceptable margin of error for the organic waste reactivity measured by the oxygen uptake method was assessed. Oxygen uptake was determined by the Dynamic Respiration Index (DRI) (mgO₂/kgVS h). The composed uncertainty (uC) of the experimental set up used for the DRI test was evaluated and the uncertainty (u) of all the components of the apparatus was evaluated. A procedure for calculating the uC of the apparatus is proposed. The components affecting the uC of the DRI to a more significant extent were the one of the oxygen mass rate and the u of the amount of VS in the sample analyzed. For a confidence level of 99.73%, the extended uC (UC) interval for a DRI = 1024 mgO₂/kgVS h was ±440 mgO₂/kgVS h, whereas for a DRI = 3489 mgO₂/kgVS h, the UC interval was ±1288 mgO₂/kgVS h. When oxygen consumption and VS content become lower than 600 mgO₂/h and 0.9 kg, respectively, the UC interval is similar to the measured DRI.     

Thiolsulfonate functionalized polystyrene resin： Preparation and application in the isolation and identification of electrophilic mutagens

A new approach for isolation and identification of elecrtophilic mutagens from complex matrix was developed.Thiosulfonic anion was immobilized onto polystyrene beads and used as separation media.Potassium polystyryl-thiosulfonate,prepared from polystyryl- sulfonyl chloride and KHS,was observed to selectively react with model electrophilic mutagens such as alkyl halides,α-chloroketones andα-chloroesters to produce polystyryl-thiosulfonic esters.After separation from other nonreactive organic compounds,the beads then reacted with ethanethiol to produce unsymmetrical ethyl disulfides which are easily detected by GC/MS.For one mutagenic compound,only one unsymmetrical disulfide was found to contain its structure part.Thus,the structure of the parent mutagens could be deduced from that of the unsymmetrical disulfides.The degree of functionaiization of the potassium polystyryl-thiosulfonate resin was 1.11 mmol/g.Its reactivity was discussed and its recycling method was reported here.