基于SVR的含缺陷管道剩余强度研究

针对采用标准预测含缺陷管道剩余强度误差较大这一问题,在Matlab中建立基于SVR的含缺陷管道剩余强度预测模型,并基于60组含缺陷管道爆破试验数据进行训练测试,以验证模型的实际性能.结果表明:SVR模型预测测试集结果的最小相对误差为0.55％,最大相对误差为10.35％,平均相对误差为2.63％,预测结果的R2高达0....     

消防射水与自然冷却下玻璃纤维对灾后混凝土性能影响

本文对火灾后消防射水对玻璃纤维改性混凝土(GF-1)剩余抗压强度的影响进行了研究。分析了GF-1在不同温度、不同冷却方式条件下抗压强度的变化规律,并利用ORIGIN7.5软件拟合了高温作用后GF-1剩余抗压强度与温度之间的关系。研究得出:在两种冷却条件下,二种配比的HPC在高温后剩余抗压强度均呈持续降低,消防射水冷却条件下HPC的剩余抗压强度降低速率大;加热到900℃时,消防射水冷却条件下HPC的剩余抗压强度最低;消防射水对高温作用后GF-1的剩余强度影响很大,射水冷却后GF-1剩余强度明显低于自然冷却的剩余强度;且随着破坏温度升高,经消防射水冷却的GF-1剩余抗压强度呈衰减状态,;GF-1在射水冷却下强度变化没有NC-1快速,与自然冷却条件下的强度变化相比,也呈现出不同的衰减规律;并建立了自然冷却条件下及消防射水冷却条件下GF-1剩余强度与火场温度之间的多阶多项式拟合式。     

热带海洋环境中5083铝合金腐蚀行为研究

目的 研究某岛礁不同海洋区带环境中5083铝合金的腐蚀规律。方法 在某岛礁进行海洋多区带腐蚀试验,利用表面微观形貌观测、腐蚀产物分析、质量损失测试及点蚀深度测量等手段,对比分析铝合金在不同海洋区带中的腐蚀形貌、腐蚀速率和点蚀深度。结果 5083铝合金在某岛礁海洋全浸区带环境中的腐蚀速率最大,大气区带中的腐蚀速率最小,在潮差区带的腐蚀速率介于二者之间。试样在海洋不同区带主要发生局部腐蚀,大气区试样的最大点蚀深度最大,而潮差区试样的最大点蚀深度最小。在不同海洋区带,铝合金腐蚀产物和附着物的混合物中均含有钙元素,大气区钙元素含量远低于潮差区和全浸区,潮差区和全浸区铝合金表面的腐蚀产物和附着物混合物中主要含有CaCO₃、CaSiO₃和Al₂O₃。结论 不同海洋区带环境中,5083铝合金的腐蚀速率差别较大,潮差区和全浸区材料表面附着大量污损生物和矿物质。     

地铁地基液化变形的影响因素研究

研究了一些对地铁隧道抗震稳定有较大影响的因素。例如,地铁隧道的整体平均容重和地铁隧道的埋深,尽管它们对地基的孔隙水压力发展影响不大,但却对地铁隧道的震后残余变形影响相当显著。还有,砂性土中粘性土的含量多少对砂性土的动力行为有直接而显著的影响。最后,从能量的角度分析了输入不同地震波的地铁地基土层动力反应的差异。     

不同外源条件下稀土在小麦植株中的残留

采集了全国14个稀土施用区3种不同施用条件（土施、喷施、拌种）下的成熟小麦样品及未施用稀土对照样品，利用等离子体质谱法（ICP－MS）测定了小麦植株的根、茎、叶及籽粒中14种稀土元素的含量。分别探讨了不同外源下小麦植株各部位稀土元素的含量及分布特征，并与有关文献中的报道进行了对比。研究结果表明，土施和拌种的小麦各部位没有发现明显残留，施用样各部位稀土总量比对照样增加约5％－10％，其分布模式与土壤类似；喷施的小麦样品的根、茎、叶中稀土残留严重，其含量比对照样高一个数量级，其分布模式与土壤及对照完全不同，表现为轻稀土更富集；3种施用方法的小麦籽粒中稀土残留均不明显。     

高瓦斯易自燃工作面高抽巷瓦斯抽采与采空区遗煤自燃相互影响研究

为了实现瓦斯与煤自燃两大灾害的联合防治,首先对布置高抽巷条件下瓦斯与遗煤自燃多因素相互影响关系进行了理论分析和归纳总结。结合淮南潘二煤矿11223高瓦斯易自燃工作面,建立了带有高抽巷的物理模型,利用UDF编译了本煤层与邻近层瓦斯涌出源项、采空区三维孔隙率和低温条件下煤氧化反应氧气消耗速率。在此基础上,分析了高抽巷布置参数和抽采参数以及工作面风量对高抽巷瓦斯抽采效果和采空区自燃带分布相互影响的规律。结果表明,当工作面风量为2 000 m3/min,高抽巷布置在顶板上方40 m时,高抽巷瓦斯抽采浓度和纯量分别达32.3%和29.07 m3/min,占总瓦斯涌出量的69.71%,同时能满足实际防火的要求。研究结果可为类似条件下高抽巷最佳施工与抽采参数提供借鉴。     

Treatment,residual chlorine and season as factors affecting variability of trihalomethanes in small drinking water systems

Seasonal variability in source water can lead to challenges for drinking water providers related to operational optimization and process control in treatment facilities. The objective of this study is to investigate seasonal variability of water quality in municipal small water systems (<3000 residents) supplied by surface waters. Residual chlorine and trihalomethanes (THM) were measured over seven years (2003–2009). Comparisons are made within each system over time, as well as between systems according to the type of their treatment technologies. THM concentrations are generally higher in the summer and autumn. The seasonal variability was generally more pronounced in systems using chlorination plus additional treatment. Chloroform, total THM (TTHM) and residual chlorine concentrations were generally lower in systems using chlorination plus additional treatment. Conversely, brominated THM concentrations were higher in systems using additional treatment. Residual chlorine was highest in the winter and lowest in the spring and summer. Seasonal variations were most pronounced for residual chlorine in systems with additional treatment. There was generally poor correlation between THM concentrations and concentrations of residual chlorine. Further study with these data will be beneficial in finding determinants and indicators for both quantity and variability of disinfection byproducts and other water quality parameters.     

Validation of the UN test method N.5

Many substances react with water in such a way that flammable gases are formed. For transport issues this reaction may possess a considerable hazard especially if the cargo is wetted by rain or by water from other sources. In the UN Recommendations on the Transport of Dangerous Goods these kinds of problems are addressed. The UN test N.5 “Test method for substances which in contact with water emit flammable gases” corresponds to this hazard. Classification according to the test method is done by measurement of the gas evolution rate of the flammable gas by any suitable procedure. At BAM a gravimetric approach is used to measure the gas evolution rate. In this paper we present the evaluation of the apparatus by means of an absolute calibration routine utilizing a reaction where a known amount of gas is produced as well as the evaluation of important parameters influencing the gas evolution rate using different substances. It can be shown that the apparatus is capable of measuring absolute gas volumes as low as 6 mL with an acceptable error of about 17% as determined from the reaction of Mg with demineralized water.     

过电流故障铝导线熔痕部位与组织特征关联性研究

为深入研究过电流故障铝导线熔痕部位与组织特征之间的关联关系,本文模拟2.5 mm2BLV铝导线通25～ 187.5 A电流时的发热、熔断和燃烧过程,研究过电流铝导线发热形变与熔痕形成的内在关联,根据各部位熔痕受热形成过程,分类识别典型组织特征.研究结果表明:随着电流值升高,铝导线先后出现线芯发热、绝缘热解、熔断拉弧、绝...     

我国原铝冶炼行业温室气体排放模型

我国原铝冶炼行业产业集中度较低,生产水平参差不齐,随着国内原铝产量不断增加,原铝行业碳排放及其计算方法备受关注. 针对我国原铝冶炼过程原料类型、能源结构复杂的特点,对国内外已有碳排放核算框架进行细化,从物料、工序、工艺3个层面构建了复杂的原铝冶炼系统温室气体排放计算模型. 在广泛文献调研的基础上,选取典型原铝冶炼企业开展现场调研及专家咨询,进而形成模型的基础数据库. 利用上述模型对我国2011年原铝冶炼过程碳排放进行核算. 结果表明:综合考虑氧化铝生产工艺结构、电解铝行业分布区域的电网能源结构,我国原铝冶炼系统CO₂排放因子(以铝锭计)为14.70t/t. 电解铝生产过程电耗相关排放占70%,南方电网区域电解铝生产电耗相关CO₂排放分别比华中、华北地区低13%、30%. 原铝冶炼行业可通过优先选用碳排放因子较低的物料、淘汰落后氧化铝工艺、开发引进低温低电压工艺技术等手段,进一步实现物料、工序及工艺的多层次温室气体减排.