全文获取类型
收费全文 | 6094篇 |
免费 | 405篇 |
国内免费 | 1613篇 |
专业分类
安全科学 | 412篇 |
废物处理 | 773篇 |
环保管理 | 990篇 |
综合类 | 4231篇 |
基础理论 | 447篇 |
环境理论 | 1篇 |
污染及防治 | 1081篇 |
评价与监测 | 117篇 |
社会与环境 | 42篇 |
灾害及防治 | 18篇 |
出版年
2024年 | 6篇 |
2023年 | 40篇 |
2022年 | 73篇 |
2021年 | 115篇 |
2020年 | 139篇 |
2019年 | 108篇 |
2018年 | 100篇 |
2017年 | 106篇 |
2016年 | 157篇 |
2015年 | 191篇 |
2014年 | 328篇 |
2013年 | 393篇 |
2012年 | 453篇 |
2011年 | 446篇 |
2010年 | 362篇 |
2009年 | 416篇 |
2008年 | 324篇 |
2007年 | 534篇 |
2006年 | 632篇 |
2005年 | 477篇 |
2004年 | 410篇 |
2003年 | 404篇 |
2002年 | 336篇 |
2001年 | 297篇 |
2000年 | 261篇 |
1999年 | 247篇 |
1998年 | 173篇 |
1997年 | 137篇 |
1996年 | 100篇 |
1995年 | 92篇 |
1994年 | 80篇 |
1993年 | 55篇 |
1992年 | 31篇 |
1991年 | 25篇 |
1990年 | 10篇 |
1989年 | 4篇 |
1988年 | 4篇 |
1986年 | 7篇 |
1984年 | 2篇 |
1982年 | 3篇 |
1981年 | 4篇 |
1980年 | 3篇 |
1978年 | 2篇 |
1977年 | 2篇 |
1975年 | 2篇 |
1974年 | 3篇 |
1973年 | 4篇 |
1972年 | 3篇 |
1971年 | 3篇 |
1970年 | 2篇 |
排序方式: 共有8112条查询结果,搜索用时 31 毫秒
281.
研究了在散射光下铁(III)-丙酮酸盐配合物对铬(V I)的光还原反应;考察了溶液pH、铁(III)、丙酮酸钠、铬(V I)浓度对反应的影响;分析了铬(V I)光还原反应的动力学。实验结果表明:铁(III)-丙酮酸盐配合物体系能在较弱的散射光下还原铬(V I)。在铬(V I)浓度为19.2μm o l/L、铁(III)浓度为10.0μm o l/L、丙酮酸钠浓度为240μm o l/L、pH为3.0、光照240m in的条件下,铬(V I)的还原率达到99.7%。从表观动力学方程的反应级数看,铁(III)的级数(0.83)最高,铁(III)浓度是影响铬(V I)光还原反应速率的主要因素,铁(II)是铬(V I)光还原的主要还原剂。 相似文献
282.
厌氧-好氧一体化反应器处理高浓度有机废水的运行特性研究 总被引:4,自引:0,他引:4
本实验采用新型厌氧—好氧一体化反应器处理高浓度有机废水,主要研究了系统的启动与运行性能,并对系统的NH3 N去除效果作了初步考察。实验结果表明:在16℃~24℃的自然温度下,采用递增负荷、厌氧和好氧分期启动的方式,系统可在38天内达到较好的启动效果;在系统负荷运行期内,当系统总进水COD浓度平均值为3601 8mg/L,总出水COD浓度平均值为384 0mg/L,系统容积负荷平均值为2 54kgCOD/(m3·d),系统总HRT平均值为35 1h时,系统总COD去除率平均值达90 6%。实验还发现:当进水NH3 N浓度为280 3~350 7mg/L,整个系统的NH3 N去除率在68 5%~91 7%,平均为81 0%。由此说明,本反应器具有很好的COD去除性能和NH3 N去除效果,适合于处理COD浓度高且含有中等NH3 N浓度的有机废水。 相似文献
283.
就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究,确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1.5倍,反应时间可控制在20min上。ClO2处理pH5.0~6.5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。 相似文献
284.
285.
286.
中国石油大连石化公司的生产废水不仅具有炼化废水的复杂性,而且其中含有大量的氯离子,给絮凝药剂的筛选带来一定的困难。通过对715、728两种絮凝药剂的现场应用实验,找出了不同水质情况下的最佳投药量。实验结果表明,当污水中含油量大于100mg/L时,715药剂加入量控制在150~180mg/L,728的加入量为4mg/L,此时油、SS、COD、浊度的去除率分别为92%、41%、41%和82%。当污水含油量在30mg/L以下时,715药剂加入量为90~120mg/L,728加入量为2.7~3.3mg/L,此时油、SS、COD、浊度的去除率分别为74%、71%、38%和89%。经实验筛选出的这两种药剂可以利用现有的加药系统设备加入污水,加药处理后能提高出水的水质。 相似文献
287.
288.
Alan M. Stueber Robert E. Criss 《Journal of the American Water Resources Association》2005,41(2):267-290
ABSTRACT: An extensive base of water quality information emphasizing the effects of land use and hydrology was obtained in the karstified Fountain Creek watershed of southwestern Illinois to help resolve local water quality issues. Agrichemicals dominate the loads of most water quality constituents in the streams and shallow karstic ground water. Only calcium (Ca), magnesium (Mg), Aluminum (A1), and sulfate (SO4) ions are predominantly derived from bedrock or soils, while agrichemicals contribute most of the sodium (Na), potassium (K), chlorine (Cl), nitrate (NO3), fluorine (F), phosphorus (P), and atrazine. Concentrations of individual ions correlate with discharge variations in karst springs and surface streams; highly soluble ions supplied by diffuse ground water are diluted by high flows, while less soluble ions increase with flow as they are mobilized from fields to karst conduits under storm conditions. Treated wastewater containing detergent residues dominates the boron load of streams and provides important subordinate loads of several other constituents, including atrazine derived from the Mississippi River via the public water supply. Average surface water concentrations at the watershed outlet closely approximate a 92:8 mixture of karst ground water and treated wastewater, demonstrating the dominance of ground water contributions to streams. Therefore the karst aquifer and watershed streams form a single water quality system that is also affected by wastewater effluent. 相似文献
289.
This study was conducted to investigate microbial organisms that can be used for preventing clogging in drip irrigation systems caused by biological factors. A total of 25 fungi isolate and 121 bacterial strains were isolated from water samples collected from drip irrigation systems in tomato greenhouses in the eastern Anatolia region of Turkey in the spring season of 2001. Biological clogging of emitters in a model drip irrigation system was experimentally caused by application of the microorganisms (fungi and bacteria) isolated in the study. Three antagonistic bacterial strains in the genus Bacillus spp (ERZ, OSU-142) and Burkholdria spp (OSU-7) were used for treatment of biological clogging of the emitters. The results showed that the antagonistic bacterial strains tested have the potential to be used as anti-clogging agents for treatment of emitters in drip irrigation system. This is the first study that demonstrated that antagonistic microorganisms can be utilized for treatment of clogging in drip irrigation systems. 相似文献
290.
Toyohisa Fujita Hiroyuki Ono Gjergj Dodbiba Kunihiko Yamaguchi 《Waste management (New York, N.Y.)》2014,34(7):1264-1273
Printed circuit boards (PCBs) from discarded personal computer (PC) and hard disk drive were crushed by explosion in water or mechanical comminution in order to disintegrate the attached parts. More parts were stripped from PCB of PC, composed of epoxy resin; than from PCB of household appliance, composed of phenol resin.In an attempt to raise the copper grade of PCB by removing other components, a carbonization treatment was investigated. The crushed PCB without surface-mounted parts was carbonized under a nitrogen atmosphere at 873–1073 K. After screening, the char was classified by size into oversized pieces, undersized pieces and powder. The copper foil and glass fiber pieces were liberated and collected in undersized fraction. The copper foil was liberated easily from glass fiber by stamping treatment.As one of the mounted parts, the multi-layered ceramic capacitors (MLCCs), which contain nickel, were carbonized at 873 K. The magnetic separation is carried out at a lower magnetic field strength of 0.1 T and then at 0.8 T. In the +0.5 mm size fraction the nickel grade in magnetic product was increased from 0.16% to 6.7% and the nickel recovery is 74%.The other useful mounted parts are tantalum capacitors. The tantalum capacitors were collected from mounted parts. The tantalum-sintered bodies were separated from molded resins by heat treatment at 723–773 K in air atmosphere and screening of 0.5 mm. Silica was removed and 70% of tantalum grade was obtained after more than 823 K heating and separation.Next, the evaluation of Cu recycling in PCB is estimated. Energy consumption of new process increased and the treatment cost becomes 3 times higher comparing the conventional process, while the environmental burden of new process decreased comparing conventional process.The nickel recovery process in fine ground particles increased energy and energy cost comparing those of the conventional process. However, the environmental burden decreased than the conventional one.The process for recovering tantalum used more heat for the treatment and therefore the energy consumption increased by 50%, when comparing with conventional process. However, the market price for tantalum is very large; the profit for tantalum recovery is added. Also the environmental burden decreased by the recycling of tantalum recovery. Therefore, the tantalum recovery is very important step in the PCB recycling. If there is no tantalum, the consumed energy and treatment cost increase in the new process, though the environmental burden decreases. 相似文献