钻孔间距对水力压裂促抽煤层瓦斯的影响

针对定量确定合理钻孔间距困难问题,基于损伤力学和多场耦合理论,建立了水力压裂和瓦斯抽采的煤层流固耦合模型,包括和水运移场、应力场以及孔隙度、渗透率演化方程,并采用Comsol联合Matlab求解,研究了不同钻孔间距时压裂和抽采过程中煤层弹模、损伤值、渗透率、瓦斯压力、抽采量和压裂贯通时间的变化规律。结果表明:耦合模型可较准确地模拟煤层水力压裂和瓦斯抽采过程;压裂贯通时间与钻孔间距呈指数增长关系;在马堡煤矿,当钻孔间距为4~8 m时,压裂损伤区在抽采孔贯通,渗透率呈“n”型曲线,瓦斯抽采后,瓦斯压力迅速下降,抽采有效区随间距的增加而增大;当钻孔间距为9~12 m时,压裂损伤区未贯通,煤层渗透率呈“m”型曲线,抽采有效区随间距的增加而减小,与间距4~8 m相比,瓦斯抽采量较小。     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性,利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg,对其进行阶段划分:阶段1为30℃~Tc;阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化,进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化,单轴应力为2.7 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段1和2煤导热系数随温度升高均先减小后增大,并且煤导热系数随单轴应力增大呈三次函数变化。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

HRT对固定床厌氧反应器运行效果的影响

为了考察水力停留时间(HRT)对炭纤维载体固定床厌氧反应器运行效果的影响,在进水COD分别为20 000~25 000 mg/L和40 000~45 000 mg/L2个浓度范围下,研究了不同HRT对反应器运行效果的影响。结果表明,通过HRT的调整,在达到相同有机负荷(OLR)下,进水COD为20 000~25 000 mg/L的COD去除率和产气量,明显比进水COD为40 000~45 000 mg/L的运行效果好;进水COD为20 000~25 000 mg/L,HRT为14 h,相应的OLR为41.09 kgCOD/(m3.d)时,COD去除率仍然维持在68%以上,沼气容积产气率达到14.55 m3/(m3.d)。炭纤维载体固定床厌氧反应器具有较高的COD去除率、产气效率以及抵抗低pH、高负荷冲击的能力,运行过程中没有发生反应器堵塞的现象。     

污泥含炭吸附剂对挥发性有机废气吸附实验研究

研究了污泥含炭吸附剂对挥发性有机污染物的吸附特性。结果表明,污泥含炭吸附剂对苯系物的吸附为典型的物理吸附,其吸附甲苯等温线的类型系优惠型吸附等温线,表明具有良好的吸附能力;在吸附反应温度为20℃,气体流量为500 mL/m in(停留时间为0.424 s),甲苯浓度为2 700 mg/m3时,甲苯的饱和吸附容量为150.0 mg/g;同时,研究表明污泥含炭吸附剂对苯系物的饱和吸附容量和吸附强弱次序为二甲苯甲苯苯。结果表明污泥含炭吸附剂适合对中低浓度有机废气的吸附净化。     

实验室环境温度下电导率测定计算的改进

对原电导率温度校正公式进行了改进,改进后的校正公式在实验室环境温度（11－30℃）下较适用。     

抑制型电导-离子色谱法测定水中无机阴离子

采用抑制型电导-离子色谱法测定生活饮用水、污水和地表水中F-、Cl-、NO2-、Br-、NO3-、PO43-、SO42-等7种无机阴离子,对清洁水样过滤后直接测定,浑浊样品离心后取上清液过滤测定。F-在0.100 mg/L~1.20 mg/L范围内、其余6种阴离子在1.00 mg/L~12.0 mg/L范围内线性良好,方法检出限为0.031 mg/L~0.47 mg/L,水样平行测定的RSD为0.9%~1.8%,加标回收率为82.6%~110%。     

潜流人工湿地水力学特性及工程设计

以净化低污染水体的潜流人工湿地水力学特性工程设计为重点,系统开展了室内外实验研究,并利用Peelet数分析了水平潜流人工湿地碎石床渗流返混程度。结果表明,潜流人工湿地集水花管孔口出流计算、基质填料内渗流计算、碎石床平均水力停留时间计算可分别借鉴薄壁孔口恒定淹没出流、线性或非线性渗流、活塞流理论;但受工程实际条件及运行淤堵等影响,工程实测结果均小于理论计算值。基于室内外实验成果,提出一套包括集配水系统水力计算、填料内渗流计算、平均水力停留时间计算在内的潜流人工湿地水力学特性计算方法和参数选择,可为人工湿地技术的工程设计提供借鉴。     

Toxicological characterization of the landfill leachate prior/after chemical and electrochemical treatment: A study on human and plant cells

In this research, toxicological safety of two newly developed methods for the treatment of landfill leachate from the Piškornica (Croatia) sanitary landfill was investigated. Chemical treatment procedure combined chemical precipitation with CaO followed by coagulation with ferric chloride and final adsorption by clinoptilolite. Electrochemical treatment approach included pretreatment with ozone followed by electrooxidation/electrocoagulation and final polishing by microwave irradiation. Cell viability of untreated/treated landfill leachate was examined using fluorescence microscopy. Cytotoxic effect of the original leachate was obtained for both exposure periods (4 and 24 h) while treated samples showed no cytotoxic effect even after prolonged exposure time. The potential DNA damage of the untreated/treated landfill leachate was evaluated by the comet assay and cytokinesis-block micronucleus (CBMN) assay using either human or plant cells. The original leachate exhibited significantly higher comet assay parameters compared to negative control after 24 h exposure. On the contrary, there was no significant difference between negative control and chemically/electrochemically treated leachate for any of the parameters tested. There was also no significant increase in either CBMN assay parameter compared to the negative control following the exposure of the lymphocytes to the chemically or electrochemically treated landfill leachate for both exposure periods while the original sample showed significantly higher number of micronuclei, nucleoplasmic bridges and nuclear buds for both exposure times. Results suggest that both methods are suitable for the treatment of such complex waste effluent due to high removal efficiency of all measured parameters and toxicological safety of the treated effluent.     

Near Real-Time Monitoring and Mapping of Specific Conductivity Levels Across Lake Texoma, USA

A submersible sonde equipped with a specific conductivity probe, linked with a global positioning satellite receiver was developed, deployed on a small boat, and used to map spatial and temporal variations in specific conductivity in a large reservoir. 7,695 sample points were recorded during 8 sampling trips. Specific conductivity ranged from 442,uS/cm to 3,378,uS/cm over the nine-month study. The data showed five statistically different zones in the reservoir: 2 different riverine zones, 2 different riverine transition zones, and a lacustrine zone (the main lake zone). These data were imported to a geographic information system where they were spatially interpolated to generate 8 maps showing specific conductivity levels across the entire surface of the lake. The highly dynamic nature of water quality, due to the widely differing nature of the rivers that flow into the reservoir and the effect of large inflows of fresh water during winter storms is easily captured and visualized using this approach.