离心场环境下液压振动台试验设备的研制

本文主要介绍了离心机液压振动台系统的设计思想、构成和工作原理以及主要技术指标、特点和意义.     

Near Real-Time Monitoring and Mapping of Specific Conductivity Levels Across Lake Texoma, USA

A submersible sonde equipped with a specific conductivity probe, linked with a global positioning satellite receiver was developed, deployed on a small boat, and used to map spatial and temporal variations in specific conductivity in a large reservoir. 7,695 sample points were recorded during 8 sampling trips. Specific conductivity ranged from 442,uS/cm to 3,378,uS/cm over the nine-month study. The data showed five statistically different zones in the reservoir: 2 different riverine zones, 2 different riverine transition zones, and a lacustrine zone (the main lake zone). These data were imported to a geographic information system where they were spatially interpolated to generate 8 maps showing specific conductivity levels across the entire surface of the lake. The highly dynamic nature of water quality, due to the widely differing nature of the rivers that flow into the reservoir and the effect of large inflows of fresh water during winter storms is easily captured and visualized using this approach.     

供水管网震后流量监测点的动态分级优化布局研究

为了提高管网地震监测点布局的准确性和合理性,基于管网微观水力计算模型和动态分级法,提出供水管网震后流量监测点的动态分级优化布局模型。首先,利用管网微观水力计算模型计算管段流量的影响系数,构建管段的影响系数矩阵,并利用信息熵确定管段权重;其次,标准化处理影响系数矩阵,通过聚类迭代提出供水管网地震流量监测点优化布局的动态分级方法,对供水管网震后流量监测点进行优化布置分级评定;最后,根据工程实例进行方法实践,结果表明:供水管网中的管线分类较为科学合理,地震监测点在供水管网上分布也比较均匀,而且该模型在一定程度上消除了人为因素的影响,保障了震时管网的监控效果和日常建设的合理性。     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性,利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg,对其进行阶段划分:阶段1为30℃~Tc;阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化,进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化,单轴应力为2.7 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段1和2煤导热系数随温度升高均先减小后增大,并且煤导热系数随单轴应力增大呈三次函数变化。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

HRT对固定床厌氧反应器运行效果的影响

为了考察水力停留时间(HRT)对炭纤维载体固定床厌氧反应器运行效果的影响,在进水COD分别为20 000~25 000 mg/L和40 000~45 000 mg/L2个浓度范围下,研究了不同HRT对反应器运行效果的影响。结果表明,通过HRT的调整,在达到相同有机负荷(OLR)下,进水COD为20 000~25 000 mg/L的COD去除率和产气量,明显比进水COD为40 000~45 000 mg/L的运行效果好;进水COD为20 000~25 000 mg/L,HRT为14 h,相应的OLR为41.09 kgCOD/(m3.d)时,COD去除率仍然维持在68%以上,沼气容积产气率达到14.55 m3/(m3.d)。炭纤维载体固定床厌氧反应器具有较高的COD去除率、产气效率以及抵抗低pH、高负荷冲击的能力,运行过程中没有发生反应器堵塞的现象。     

污泥含炭吸附剂对挥发性有机废气吸附实验研究

研究了污泥含炭吸附剂对挥发性有机污染物的吸附特性。结果表明,污泥含炭吸附剂对苯系物的吸附为典型的物理吸附,其吸附甲苯等温线的类型系优惠型吸附等温线,表明具有良好的吸附能力;在吸附反应温度为20℃,气体流量为500 mL/m in(停留时间为0.424 s),甲苯浓度为2 700 mg/m3时,甲苯的饱和吸附容量为150.0 mg/g;同时,研究表明污泥含炭吸附剂对苯系物的饱和吸附容量和吸附强弱次序为二甲苯甲苯苯。结果表明污泥含炭吸附剂适合对中低浓度有机废气的吸附净化。     

青冰滩冰川水文特征初步分析

通过对青冰滩冰川的综合考察,对该地区2008-08-01日至08-31日的水文、气象以及水环境进行了连续观测。结果表明:冰川表面大量覆盖冰碛增加了冰川表面的反射率,加速了冰川消融;整个8月日均气温在8℃以下,气温的日较差较大,冰川消融期的降水以降雪和冰雹为主;冰川融水的电导率和溶解性固体相关系数可达0.98,两者与气温的相关度也可达到0.8以上。     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

循环荷载对饱和黄土动剪模量的影响研究

利用装有压电陶瓷弯曲元的双向振动三轴仪对饱和黄土进行了循环荷载试验,并根据静力固结条件下黄土的动剪模量发展规律建立了基于哈定方程的拟合曲线;将循环荷载作用下的动剪模量与静力固结下的动剪模量进行了对比研究,并根据轴向应变的发展规律,确定了以上2种条件下动剪模量产生差异的原因:试样结构性破坏,土颗粒重排列,土体具有很高的敏感性。对于振动过程中的暂停对试验的影响进行了研究,认为由于暂停时间很短,可以忽略这种影响。在振动结束后,对试样在原压力下重新进行固结,结果表明,固结完成后,试样的动剪模量增大,且增大幅度随着密度的增加而变小。