臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

垃圾渗滤液中典型内分泌干扰物质(EDCs)细胞毒性分析

垃圾渗滤液的人类健康风险评估日益受到人们重视,也成为研究热点。本文采用一种新型高级氧化技术UV-Fenton处理渗滤液,并用人体乳腺癌细胞(MCF-7)评估处理过程中渗滤液原液以及渗滤液中典型内分泌干扰物质(EDCs)的细胞毒性,对垃圾渗滤液中EDCs的细胞毒性和变化规律进行了研究。结果表明渗滤液中的邻苯二甲酸二丁酯(DBP)、双酚A(BPA)、壬基酚(NP)是产生细胞毒性的主要物质,其毒性大小为DBPBPANP。在同样的氧化降解过程中显示出不同毒性变化规律,通过GC-MS分析,结果显示UV-Fenton过程中产生了大量的中间产物,这也是引起毒性变化的主要原因。实验结果也说明垃圾渗滤液细胞毒性可以通过UV-Fenton过程有效去除。     

Performance of a small-scale solar-powered adsorption cooling system

In this study, an experimental investigation on the performance of a small-scale residential-size solar-driven adsorption (silica gel-water) cooling system that was constructed at Assiut University campus, Egypt is carried out. As Assiut area is considered as hot, arid climate, field tests for performance assessment of the system operation during the summer season are performed under different environmental operating conditions. The system consists of an evacuated tube with a reflective concentration parabolic surface solar-collector field with a total area of 36 m², a silica gel-water adsorption chiller of 8 kW nominal cooling capacity, and hot and cold water thermal storage tanks of 1.8 and 1.2 m³ in volume, respectively. The results of summer season field test show that under daily solar insolation varying from 21 to 27 MJ/m², the solar collectors employed in the system had high and almost constant thermal efficiency. The daily solar-collector efficiency during the period of system operation ranged from about 50% to 78%. The adsorption chiller performance shows that the chiller average daily coefficient of performance (COP) was 0.41 with the average cooling capacity of 4.4 kW when the cooling-water and chilled-water temperatures were about 31°C and 19°C, respectively. As the chiller cooling water is cooled by the cooling tower in the hot arid area, the cooling water is at a higher temperature than the design point of the chiller. Therefore, an experiment was carried out using the city water for cooling. The results show that an enhancement in the chiller COP by 40% and the chilling power by 17% has been achieved when the city water was 27.7°C.     

Improving photostability and efficiency of polymeric luminescent solar concentrators by PMMA/MgO nanohybrid coatings

MgO nanocrystals were synthesized and doped with different concentrations in poly(methylmethacrylate) (PMMA) to prepare hybrid organic-inorganic coatings based on polymer nanohybrid thin films. The nanoparticles were found to be spherical with 62 nm diameter as determined by X-ray diffraction (XRD) and atomic force microscope (AFM). The coatings were characterized by spectroscopic tools such as optical absorption, transmission and fluorescence spectroscopy. The prepared nanohybrid films were spin-coated on cost-effective luminescent PMMA substrates doped with highly efficient luminescent dyes luminescent solar concentrators (LSCs). The outdoor photostability tests demonstrated enhanced protection against UVA radiation for coated LSCs compared to bare LSC substrates. The current–voltage characteristics of commercially produced LSC prototypes showed that the poor UV response of monocrystalline silicon solar cell can be improved by for LSCs coated by PMMA/MgO nanohybrid films which act as luminescent down shifting layer (LDSL).     

Techno-economic and environmental analysis of an integrated standalone hybrid solar hydrogen system to supply CCHP loads of a greenhouse in Iran

The techno-economic and environmental performance of hybrid solar hydrogen energy systems was investigated to provide combined cooling, heating and power (CCHP) demands of a standalone greenhouse in Iran to achieve sustainable agriculture based on an optimization procedure. From the environmental point of view, by deploying hybrid energy systems, 83%, to 100% of emissions can be avoided. Also a sensitivity analysis was performed on the hybrid energy systems in order to study the effect of major parameter variation on the systems justification. It was concluded that hybrid solar systems are economically competitive with conventional systems, for high solar intensity locations with high diesel fuel prices and decreased prices for PV and hydrogen storage technology.     

Comparison of the daily global solar radiation from different data sources in Northwest China climate

The solar radiation data are of high importance to the solar energy systems. Conventional methods to obtain the solar radiation data are from weather stations, solar radiation models, commercial software databases, and field measurements. In the present study, a new daily global solar radiation model is proposed, by combining the quadratic function of sunshine fraction and sine function of the day of the year. The solar radiation model calculated data are then compared with China Meteorological Data Sharing System (CMDSS) data, TRNSYS data, and field-measured data in Northwest China climate. It is found that the newly proposed solar radiation model has better performance than the other nine solar radiation models in the literature. The solar radiation model calculated data fit well with the CMDSS annually average data. The TRNSYS data are a bit larger than the CMDSS annually average data in summer half year and a little smaller than those in winter half year. The solar radiation model and the CMDSS annually average data have the best correlation, whereas the TRNSYS data and the field-measured data have the worst correlation. The solar radiation model calculated data have the best correlation with the other three data sources.     

含硝基苯类化合物废水处理技术研究进展

综述了近年来处理含硝基苯类化合物废水的物理法（包括吸附法和溶剂萃取法）、化学法（包括电化学法、铁碳微电解法、超声波氧化法和臭氧氧化法及复合技术）和生物法的研究进展。指出将现有的处理技术高效整合并降低成本是今后处理含硝基苯类化合物废水的研究方向和重点。     

Fenton试剂氧化法处理染料结晶废母液

采用Fenton试剂氧化法处理分散橙、分散紫和分散蓝3种染料结晶废母液。研究了H₂O₂加入量、n（H₂O₂）#x02236;n（Fe²⁺）和废母液pH对COD去除率或TOC去除率的影响。对TOC去除反应分段进行了动力学方程拟合,并探讨了反应机理。实验得到的分散橙、分散紫和分散蓝的废母液处理工艺条件：H₂O₂加入量分别为264.4,352.9,441.2mmol/L;n（H₂O₂）#x02236;n（Fe²⁺）分别为20,10,20;废母液pH=3。3种废母液在0~20min和20~120min两个阶段的反应与二级动力学拟合方程的相关性最好。3种废母液经Fenton试剂氧化处理后,部分有机物降解为小分子有机酸,部分有机物完全矿化。     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水,研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下,处理后出水的浊度、色度和COD去除率分别为98.59%,97.62%,86.21%。处理后出水澄清透明,COD为50.34mg/L,满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。